DOI QR코드

DOI QR Code

Column-loss response of RC beam-column sub-assemblages with different bar-cutoff patterns

  • Tsai, Meng-Hao (Department of Civil Engineering, National Pingtung University of Science and Technology) ;
  • Lua, Jun-Kai (Department of Civil Engineering, National Pingtung University of Science and Technology) ;
  • Huang, Bo-Hong (Department of Civil Engineering, National Pingtung University of Science and Technology)
  • 투고 : 2013.03.11
  • 심사 : 2014.02.01
  • 발행 : 2014.03.25

초록

Static loading tests were carried out in this study to investigate the effect of bar cutoff on the resistance of RC beam-column sub-assemblages under column loss. Two specimens were designed with continuous main reinforcement. Four others were designed with different types of bar cutoff in the mid-span and/or the beam-end regions. Compressive arch and tensile catenary responses of the specimens under gravitational loading were compared. Test results indicated that those specimens with approximately equal moment strength at the beam ends had similar peak loading resistance in the compressive arch phase but varied resistance degradation in the transition phase because of bar cutoff. The compressive bars terminated at one-third span could help to mitigate the degradation although they had minor contribution to the catenary action. Among those cutoff patterns, the K-type cutoff presented the best strength enhancement. It revealed that it is better to extend the steel bars beyond the mid-span before cutoff for the two-span beams bridging over a column vulnerable to sudden failure. For general cutoff patterns dominated by gravitational and seismic designs, they may be appropriately modified to minimize the influence of bar cutoff on the progressive collapse resistance.

키워드

참고문헌

  1. Abruzzo, J., Matta, A. and Panariello, G. (2006), "Study of mitigation strategies for progressive collapse of a reinforced concrete commercial building", J. Perform. Constr. Facil., 20(4), 384-390. https://doi.org/10.1061/(ASCE)0887-3828(2006)20:4(384)
  2. ACI (2011), Building code requirements for structural concrete, Standard ACI 318-11, American Concrete Institute, Farmington Hills, Michigan, USA.
  3. Almusallam, T.H., Elsanadedy, H.M., Abbas, H., Alsayed, S.H. and Al-Salloum, Y.A. (2010), "Progressive collapse analysis of an RC building subjected to blast loads", Struct. Eng. Mech., 36(3), 301-309. https://doi.org/10.12989/sem.2010.36.3.301
  4. Choi, H. and Kim, J. (2011), "Progressive collapse-resisting capacity of RC beam-column sub-assemblage", Mag. Concrete Res., 63(4), 297-310. https://doi.org/10.1680/macr.9.00170
  5. DoD (2009), Unified facilities criteria: design of buildings to resist progressive collapse, UFC 4-023-03, Department of Defense, Washington DC, USA.
  6. Ellingwood, B.R. (2006), "Mitigating risk from abnormal loads and progressive collapse", J. Perform. Constr. Facil., 20(4), 315-323. https://doi.org/10.1061/(ASCE)0887-3828(2006)20:4(315)
  7. GSA (2003), Progressive collapse analysis and design guidelines for new federal office buildings and major modernization projects, General Service Administration, Washington DC, USA.
  8. Guice, L.K. and Phomberg, E.J. (1989), "An analogous model for slabs using a truss element", Comput. Struct., 31(5), 767-774. https://doi.org/10.1016/0045-7949(89)90211-3
  9. Izzuddin, B.A. (2005), "A simplified model for axially restrained beams subjected to extreme loading", Steel Struct., 5, 421-429. https://doi.org/10.12989/scs.2005.5.6.421
  10. Kim, J. and An, D. (2009), "Evaluation of progressive collapse potential of steel moment frames considering catenary action", Struct. Des. Tall Spec. Build., 18(5), 455-465. https://doi.org/10.1002/tal.448
  11. Lee, C.H., Kim, S., Han, K.H. and Lee, K. (2009), "Simplified nonlinear progressive collapse analysis of welded steel moment frames", J. Constr. Steel Res., 65(5), 1130-1137. https://doi.org/10.1016/j.jcsr.2008.10.008
  12. Liu, J.L. (2010), "Preventing progressive collapse through strengthening beam-to-column connection, Part 1: theoretical analysis", J. Constr. Steel Res., 66(2), 229-237. https://doi.org/10.1016/j.jcsr.2009.09.006
  13. Mohamed, O.A. (2006), "Progressive collapse of structures: annotated bibliography and comparison of codes and standards", J. Perform. Constr. Facil., 20(4), 418-425. https://doi.org/10.1061/(ASCE)0887-3828(2006)20:4(418)
  14. Nair, R.S. (2006), "Preventing disproportionate collapse", J. Perform. Constr. Facil., 20(4), 309-314. https://doi.org/10.1061/(ASCE)0887-3828(2006)20:4(309)
  15. Sadek, F., Main, J.A., Lew, H.S. and Bao, Y. (2011), "Testing and analysis of steel and concrete beamcolumn assemblies under a column removal scenario", J. Struct. Eng., 137(9), 881-892. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000422
  16. Sasani, M. and Kropelnicki, J. (2008), "Progressive collapse analysis of an RC structure", Struct. Des. Tall Spec. Build., 17(4), 757-771. https://doi.org/10.1002/tal.375
  17. Sasani, M. and Sagiroglu, S. (2010), "Gravity load redistribution and progressive collapse resistance of 20- story reinforced concrete structure following loss of interior column", ACI Struct. J., 107(6), 636-644.
  18. Sasani, M., Werner, A. and Kazemi, A. (2011), "Bar fracture modeling in progressive collapse analysis of reinforced concrete structures", Eng. Struct., 33(2), 401-409. https://doi.org/10.1016/j.engstruct.2010.10.023
  19. Su, Y., Tian, Y. and Song, X. (2009), "Progressive collapse resistance of axially-restrained frame beams", ACI Struct. J., 106(5), 600-607.
  20. Tian, Y. and Su, Y. (2011), "Dynamic response of reinforced concrete beams following instantaneous removal of a bearing column", Int. J. Concrete Struct. Mater., 5(1), 19-28. https://doi.org/10.4334/IJCSM.2011.5.1.019
  21. Tsai, M.H. and Huang, T.C. (2013), "Progressive collapse analysis of an RC building with exterior partially infilled walls", Struct. Des. Tall Spec. Build., 22(4), 327-348. https://doi.org/10.1002/tal.690
  22. Yagob, O., Galal, K. and Naumoski, N. (2009), "Progressive collapse of reinforced concrete structures", Struct. Eng. Mech., 32(6), 771-786. https://doi.org/10.12989/sem.2009.32.6.771
  23. Yi, W.J., He, Q.F., Xiao, Y. and Kunnath, S.K. (2008), "Experimental study on progressive collapse-resistant behavior of reinforced concrete frame structures", ACI Struct. J., 105(4), 433-439.
  24. Yu, J. and Tan, K.H. (2013), "Experimental and numerical investigation on progressive collapse resistance of reinforced concrete beam column sub-assemblages", Eng. Struct., 55, 90-106. https://doi.org/10.1016/j.engstruct.2011.08.040

피인용 문헌

  1. Chord rotation demand for effective catenary action of RC beams under gravitational loadings vol.58, pp.2, 2016, https://doi.org/10.12989/sem.2016.58.2.327
  2. An Analytical Approach for the Flexural Robustness of Seismically Designed RC Building Frames Against Progressive Collapse vol.18, pp.9, 2014, https://doi.org/10.1007/s40999-020-00528-1