Wind and Structures

  • 제18권2호
  • /
  • Pages.181-194
  • /
  • 2014
  • /
  • 1226-6116(pISSN)
  • /
  • 1598-6225(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Development of wind vortex shedding coefficients for a multisided cylinder structure

  • 투고 : 2012.10.19
  • 심사 : 2013.10.29
  • 발행 : 2014.02.25
⟨ 이전 논문 다음 논문 ⟩

초록

A major problem with high-mast light poles is the effects that wind vortex shedding can have on the pole itself because of the lock-in phenomenon. It is desired that the coefficients in the AASHTO Standard Specifications ($5^{th}$ edition) for Structural Supports for Highway Signs, Luminaries, and Traffic Signals be analyzed and refined. This is for the belief that the span of the shapes of poles for which the coefficients are used is much too broad and a specific coefficient for each different shape is desired. The primary objective of this study is to develop wind vortex shedding coefficient for a multisided shape. To do that, an octagonal shape was used as the main focus since octagonal cross sectioned high-mast light poles are one of the most common shapes in service. For the needed data, many wind parameters, such as the static drag coefficient, the slope of aerodynamic lift coefficient, Strouhal number, the lock-in range of wind velocities producing vibrations, and variation of amplitude of vortex-induced vibration with Scruton number are needed. From wind tunnel experiments, aerodynamic parameters were obtained for an octagonal shape structure. Even though aerodynamic coefficients are known from past test results, they need to be refined by conducting further wind tunnel tests.

키워드

참고문헌

  1. American Association of State Highway and Transportation Officials. (2009), Standard specifications for structural support for highway signs, Luminaries, and Traffic Signals, 5th Ed., Washington, D.C.
  2. Belver, A.V., Iban, A.L. and Lavin Martin, C.E. (2012), "Coupling between structural and fluid dynamic problems applied to vortex shedding in a 90m steel chimney", J. Wind Eng. Ind. Aerod., 100(1), 30-37. https://doi.org/10.1016/j.jweia.2011.10.007
  3. Blevins, R.D. (1990), Flow-induced vibration, 2nd Ed., Van Nostrand Reinnhold, New York.
  4. Bosch, H.R. and Guterres, R.M. (2001), "Wind tunnel experimental investigation on tapered cylinders for highway support structures", J. Wind Eng. Ind. Aerod., 89(14), 1311-1323. https://doi.org/10.1016/S0167-6105(01)00144-1
  5. CAN/CSA-S6-06 (2006), Canadian highway bridge design code, CAN/CSA-S6-06, CSA International, Rexdale, Ontario, Canada.
  6. Chang, B.e.a. (2009), "Development of a procedure for fatigue design of slender support structures subjected to wind-induced vibration", J. Trans. Res. Board, 2131, 23-33. https://doi.org/10.3141/2131-03
  7. Chang, B.e.a. (2010), "Time-domain model for predicting aerodynamic loads on a slender support structure for fatigue design", J. Eng. Mech. - ASCE 136(6), 736-746. https://doi.org/10.1061/(ASCE)EM.1943-7889.0000122
  8. Connor, R.J., Collicott, S.H., DeSchepper, A.M., Sherman, R.J. and Ocampo, J.A. (2012), NCHRP Report 718: Fatigue Loading and Design Methodology for High-Mast Lighting Towers. TRB, National Research Council, Washington D.C.
  9. Constantinescu, G.e.a. (2013), Wind loads on dynamic message cabinets and behavior of supporting trusses. Final report to Iowa Department of Transportation, Ames, Iowa.
  10. Dawood, M., Goyal, R., Dhonde, H. and Bradberry, T. (2013), "Fatigue life assessment of cracked high mast illumination poles", J. Perform. Constr. Fac., In press.
  11. Dexter, R.J. and Ricker, M.J. (2002), NCHRP Report 469: Fatigue-resistant design of cantilever signal, sign, and light supports. TRB, National Research Council, Washington D.C.
  12. Dexter, R.J. (2004), Investigation of cracking of high-mast lighting towers. Final report to Iowa Department of Transportation, Ames, Iowa.
  13. Fouad, F.H., Calvert, E.A. and Nunez, E. (1998), NCHRP Report 411: Structural supports for highway signs, luminaries, and traffic signals, TRB, National Research Council, Washington, D.C.
  14. Fouad, F.H., Calvert, E.A. and Nunez, E. (2003), NCHRP Report 494: Structural supports for highway signs, luminaries, and traffic signals, TRB, National Research Council, Washington, D.C.
  15. Garrett, J.L. (2003), Flow-induced vibration of elastically supported rectangular cylinders, Ph.D. dissertation, Iowa State University, Ames, Iowa.
  16. James, W.D. (1976), Effects of Reynolds number and corner radius on two-dimensional flow around octagonal, dodecagonal and hexdecagonal cylinders, Ph.D. dissertation, Iowa State University.
  17. Kaczinski, M.R., Dexter, R.J. and Van Dien, J.P. (1998), NCHRP Report 412: Fatigue resistance design of cantilevered signal, sign, and light supports, TRB, National Research Council, Washington, D.C.
  18. Kitagawa, T., Wakaharab, T., Fujinob, Y. and Kimurab, K. (1997), "An experimental study on vortex-induced vibration of a circular cylinder tower at a high wind speed", J. Wind Eng. Ind. Aerod., 69-71, 731-744. https://doi.org/10.1016/S0167-6105(97)00201-8
  19. Le, T., Abolmaali, A., Ardavan Motahari, S., Yeih, W. and Fernandez, R. (2008), "Finite element-based analyses of natural frequencies of long tapered hollow steel poles", J. Constr. Steel Res., 64(3), 275-284. https://doi.org/10.1016/j.jcsr.2007.08.006
  20. Liu, H. (1991), Wind engineering, Prentice Hall, New Jersey.
  21. Placzek, A., Sigrist, J.F. and Hamdouni, A. (2009), "Numerical simulation of an oscillating cylinder in a cross-flow at low Reynolds number: Forced and free oscillations", Comput. Fluids., 38(1), 80-100. https://doi.org/10.1016/j.compfluid.2008.01.007
  22. Rios, C. (2007), Fatigue performance of multi-sided high-mast lighting towers, MS Thesis, The University of Texas at Austin, Austin, Texas.
  23. Simiu, E. and Scanlan, R.H. (1996), Wind effects on structures, fundamentals and applications to design, 3rd Ed., John Wiley & Sons, New York, NY.
  24. Zuo, D. and Letchford, C.W. (2010), "Wind-induced vibration of a traffic-signal-support structure with cantilevered tapered circular mast arm", Eng. Struct., 32(10), 3171-3179. https://doi.org/10.1016/j.engstruct.2010.06.005