한국지반공학회논문집 (Journal of the Korean Geotechnical Society)

한국지반공학회 (Korean Geotechnical Society)
권호 표지
DOI QR코드

DOI QR Code

현장시험을 통한 개단말뚝의 폐색효과에 대한 연구

Analysis of Plugging Effect for Open-ended Piles Based on Field Tests

  • 고준영 (연세대학교 토목환경공학과) ;
  • 정상섬 (연세대학교 토목환경공학과)
  • 투고 : 2014.10.15
  • 심사 : 2014.12.10
  • 발행 : 2014.12.31
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

연구에서는 사질토 지반에서 개단말뚝의 지지력에 영향을 미치는 폐색효과를 조사하기 위하여 현장재하시험을 수행하였다. 현장재하시험은 직경이 다른 총 3본의 시험말뚝(508.0, 711.2, 914.4mm)을 제작하여 각각 동재하시험과 정재하시험을 실시하였다. 내주면마찰력과 외주면마찰력을 분리 측정하기 위하여 시험말뚝을 이중관으로 제작하였고, 외부말뚝의 안쪽과 내부말뚝의 바깥쪽 표면에 변형률계를 부착하였다. 정재하시험 결과, 내주면마찰력은 선단부로부터 총 관내토 길이의 약 18-34%의 부근에서 집중적으로 발생하였고, 이를 통해 말뚝 선단부근의 관내토가 내주면마찰력 발현에 큰 영향을 미치는 것을 알 수 있었다. 또한, 말뚝직경이 클수록 전체지지력에 대한 내주면마찰력과 순단면적의 선단지지력의 합의 비가 감소하는 것으로 나타났다. 그리고 말뚝의 폐색율을 정량화하기 위해 시험말뚝의 incremental filling ratio(IFR)를 측정하여 분석한 결과, SPT의 N값과 상관관계가 있는 것으로 나타났다.

This paper presents an experimental study of the plugging effect on the capacity of open-ended piles installed in sandy soil. Full-scale tests, including dynamic and static axial-compression load tests, were carried out on three instrumented piles with different diameters (508.0, 711.2 and 914.4 mm). To measure the outer and inner shaft resistances acting on the piles, a double-walled system was utilized with instrumented strain gauges on the outside and inside walls of the pile. The results of field tests show that the inner shaft resistance was mostly mobilized at the location between the pile tip and 18-34% of the total plug length. It was found that the soil plugging in the lower portion has influence on the inner shaft resistance. In addition, it can be also demonstrated that the ratio of inner shaft resistance plus annulus load resistance to total resistance decreased with increasing pile diameters. The results of these tests show that the relationship between the degree of plugging and pile diameter is clearly established. Direct observations of the soil plugs were made and used to quantify both the plug length ratio (PLR) and the incremental filling ratio (IFR). Based on this result, it was found that the N value of the standard penetration test (SPT) is highly correlated with the IFR.

키워드

참고문헌

  1. American Association of State Highway and Transportation Officials (2002), Standard specifications for highway bridges, 17th Ed.
  2. American Petroleum Institute (2007), Recommended practice for planning, designing and constructing fixed offshore platforms-working stress design, 21th Ed.
  3. ASTM (2013), Standard test methods for deep foundations under static axial compressive load, D1143.
  4. ASTM (2013), Standard test method for high-strain dynamic testing of piles, D4945.
  5. Beringen, F. L., Windle, D., and Van Hooydonk, W. R. (1979), "Results of loading tests on driven piles in sand", Proceedings of the Conference on Recent Development in the Design and Construction of Piles, ICE, London, Vol.21-22, pp.213-225.
  6. Brucy, F., Meunier, J., and Nauroy, J. F. (1991), "Behavior of pile plug in sandy soils during and after driving", Proceedings of 23rd Annual Offshore Technology Conference, Houston, Vol.1, pp.145-154.
  7. Choi, Y. and O'Neill, M. W. (1997), "Soil plugging and relaxation in pipe pile during earthquake motion", Journal of Geotechnical and Geoenvironmental Enginnering, Vol.123, No.10, pp.975-982. https://doi.org/10.1061/(ASCE)1090-0241(1997)123:10(975)
  8. De Nicola, A. and Randolph, M. F. (1997), "The plugging behavior of driven and jacked piles in sand", Geotechnique, Vol.47, No.4, pp.841-856. https://doi.org/10.1680/geot.1997.47.4.841
  9. Gavin, K. G. and Lehane, B. M. (2003), "The shaft capacity of pipe piles in sand", Canadian Geotechnical Journal, Vol.40, pp.36-45. https://doi.org/10.1139/t02-093
  10. GRL and Associates, Inc. (1997), GRL software: Case pile wave analysis program (CAPWAP).
  11. Federal Highway Administration (1997), Design and construction of driven pile foundations: Workshop manual, Publ. No. FHWAHI-97-014.
  12. Kishida, H. and Isemoto, N. (1977), "Behavior of sand plugs in open ended steel pipe piles", Proceedings of the 9th International Conference on Soil Mechanics and Foundation Engineering, Tokyo, Japan, Vol.1, pp.601-612.
  13. Klos, J. and Tejchman, A. (1977), "Analysis of behavior of tubular piles in subsoil", Proceedings of the 9th International Conference on Soil Mechanics and Foundation Engineering, Tokyo, Japan, Vol.1, pp.605-608.
  14. Klos, J. and Tejchman, A. (1981), "Bearing capacity calculation for pipe piles", Proceedings of the 10th International Conference on Soil Mechanics and Foundation Engineering, Stockholm, Sweden, Vol.2, pp.751-754.
  15. Kraft, L. M. Jr. (1991), "Performance of axially loaded pipe piles in sand", Journal of Geotechnical Engineering, Vol.117, No.2, pp.272-296. https://doi.org/10.1061/(ASCE)0733-9410(1991)117:2(272)
  16. Lehane, B. M. and Gavin, K. G. (2001), "Base resistance of jacked pipe piles in sand", Journal of Geotechnical and Geoenvironmental Engineering, Vol.127, No.6, pp.473-480. https://doi.org/10.1061/(ASCE)1090-0241(2001)127:6(473)
  17. Lehane, B. M., Schneider, J. A., and Xu X. (2005), "The UWA-05 method for prediction of axial capacity of driven piles in sand", Proceedings of the 1st International Symposium on Frontier in Offshore Geotechnics, Perth, pp.683-689.
  18. Nauroy, J. F. and Le Tirant, P. (1983), "Model tests of calcareous sands", Proceedings of Conference on Geotechnical Practice in Offshore Engineering, Austin, TX, pp.356-369.
  19. Paik, K. H. and Lee, S. R. (1993), "Behavior of soil plugs in open-ended model piles driven into sands", Marine Georesources & Geotechnology, Vol.11, pp.353-373. https://doi.org/10.1080/10641199309379929
  20. Paik, K. H., Salgado, R., Lee, J. H., and Kim, B. J. (2003), "Behavior of open- and closed-ended piles driven into sands", Journal of Geotechnical and Geoenvironmental Engineering, Vol.129, No.4, pp.296-306. https://doi.org/10.1061/(ASCE)1090-0241(2003)129:4(296)
  21. Paikowsky, S. G. (1989), "A static evaluation of soil plug behavior with application to the pile plugging problem", D.Sc. thesis, Massachusetts Institute of Technologym Cambridge, MA.
  22. Paikowsky, S. G. (1990), "The mechanism of pile plugging in sand", Proceedings of the 22nd Offshore Technology Conference, Houston, TX, pp.593-604.
  23. Randolph, M. F., May, M., Leong, E. C., Hyden, A. M., and Murff, J. D. (1990), "Soil plug response in open ended pipe piles", Journal of Geotechnical Engineering, Vol.118, No.5, pp.743-759.
  24. Schneider, J. A., Xu, X., and Lehane, B. M. (2008), "Database assessment of CPT-based design methods for axial capacity of driven piles in siliceous sands", Journal of Geotechnical and Geoenvironmental Engineering, Vol.134, No.9, pp.1227-1244. https://doi.org/10.1061/(ASCE)1090-0241(2008)134:9(1227)
  25. Skempton, A. W. (1986), "Standard penetration test procedures and the effect in sands of overburden pressure, relative density, particle size, aging and overconsolidation", Geotechnique, Vol.36, No.3, pp. 425-447. https://doi.org/10.1680/geot.1986.36.3.425
  26. Szechy, C. H. (1959), "Tests with tubular piles", Acta Technica, Hungarian Academy of Science, Vol.24, pp.181-219.
  27. Szechy, C. H. (1961), "The effect of vibration and driving upon the voids in granular soil surrounding a pile", Proceedings of the 5th International Conference on Soil Mechanics and Foundation Engineering, Paris, Vol.2, pp.161-164.
  28. Xu, X., Schneider, J. A., and Lehane, B. M. (2008), "Cone penetration test (CPT) methods for end-bearing assessment of open- and closedended driven piles in siliceous sand", Canadian Geotehnical Journal, Vol.45, pp.1130-1141. https://doi.org/10.1139/T08-035
  29. Yamahara, H. (1964), "Plugging effect and bearing mechanism of steel pipe piles", Transportation of the Architectural Institute of Japan, Vol.96, pp.28-35.