Computers and Concrete

  • 제14권6호
  • /
  • Pages.675-694
  • /
  • 2014
  • /
  • 1598-8198(pISSN)
  • /
  • 1598-818X(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Investigations on the influence of radial confinement in the impact response of concrete

  • Al-Salloum, Yousef (MMB Chair for Research and Studies in Strengthening and Rehabilitation of Structures, Department of Civil Engineering, King Saud University) ;
  • Alsayed, Saleh (MMB Chair for Research and Studies in Strengthening and Rehabilitation of Structures, Department of Civil Engineering, King Saud University) ;
  • Almusallam, Tarek (MMB Chair for Research and Studies in Strengthening and Rehabilitation of Structures, Department of Civil Engineering, King Saud University) ;
  • Ibrahim, S.M. (MMB Chair for Research and Studies in Strengthening and Rehabilitation of Structures, Department of Civil Engineering, King Saud University) ;
  • Abbas, H. (MMB Chair for Research and Studies in Strengthening and Rehabilitation of Structures, Department of Civil Engineering, King Saud University)
  • 투고 : 2013.06.25
  • 심사 : 2014.10.01
  • 발행 : 2014.12.25
⟨ 이전 논문 다음 논문 ⟩

초록

Annular and solid concrete specimens with different aspect ratios and static unconfined compressive strengths were studied for impact loading using SHPB test setup. Numerical simulations in LSDYNA were also carried out and results were validated. The stress-strain curves obtained under dynamic loading were also compared with static compressive tests. The mode of failure of concrete specimen was a typical ductile failure at high strain rates. In general, the dynamic increase factor (DIF) of thin solid specimens was higher than thick samples. In the numerical study, the variation of axial, hydrostatic and radial stresses for solid and annular samples was studied. The core phenomenon due to confinement was observed for solid samples wherein the applied loads were primarily borne by the innermost concrete zone rather than the outer peripheral zone. In the annular samples, especially with large diameter inside hole, the distribution of stresses was relatively uniform along the radial distance. Qualitatively, only a small change in the distribution of stresses for annular samples with different internal diameters studied was observed.

키워드

과제정보

연구 과제 주관 기관 : NSTIP

참고문헌

  1. Abu-Lebdeh, T.M. and Voyiadjis, G.Z. (1993), "Plasticity-damage model for concrete under cyclic multiaxial loading", J. Eng. Mech., 119(7), 1465-1484. https://doi.org/10.1061/(ASCE)0733-9399(1993)119:7(1465)
  2. AlMousawi, M.M., Reid, S.R. and Deans, W.F. (1997), "The use of the split Hopkinson pressure bar techniques in high strain rate materials testing", Proc. Instn. Mech. Eng. Part C, 211(4), 273-292.
  3. Al-Salloum Y, Almusallam T, Ibrahim SM, Abbas H, Alsayed S. (2015), "Rate dependent behavior and modeling of concrete based on SHPB experiments", Cem. Concr. Comp., 55, 34-44. https://doi.org/10.1016/j.cemconcomp.2014.07.011
  4. Ansari, F. and Li, Q.B. (1998), "High-strength concrete subjected to triaxial compressive", ACI Mater. J., 95(6), 747-755.
  5. Barpi, F. (2004), "Impact behaviour of concrete: a computational approach", Eng. Fract. Mech., 71(15), 2197-2213. https://doi.org/10.1016/j.engfracmech.2003.11.007
  6. Bischoff, P.H. and Perry, S.H. (1991), "Compressive behaviour of concrete at high strain rates", Mater. Struct., 24, 425-450. https://doi.org/10.1007/BF02472016
  7. Bischoff, P.H. and Perry, S.H. (1995), "Impact behavior of plain concrete loaded in uniaxial compression", J. Eng. Mech., 121(6), 685-693. https://doi.org/10.1061/(ASCE)0733-9399(1995)121:6(685)
  8. Cotsovos, D.M. and Pavlovic, M.N. (2008). "Numerical investigation of concrete subjected to compressive impact loading. Part 1: A fundamental explanation for the apparent strength gain at high loading rates", Comp. Struct., 86(1-2), 145-163. https://doi.org/10.1016/j.compstruc.2007.05.014
  9. Davies, E.D.H. and Hunter, S.C. (1963), "The dynamic compression testing of solids by the method of the split Hopkinson bar", J. Mech. Phys. Sol., 11(3), 155-179. https://doi.org/10.1016/0022-5096(63)90050-4
  10. Field, J.E., Walley, S.M., Proud, W.G., Goldrein, H.T. and Siviour, C.R. (2004), "Review of experimental techniques for high rate deformation and shock studies", Int. J. Impact Eng., 30(7), 725-775. https://doi.org/10.1016/j.ijimpeng.2004.03.005
  11. Forrestal, M.J., Wright, T.W. and Chen, W. (2007), "The effect of radial inertia on brittle samples during the split Hopkinson pressure bar test", Int. J. Impact Eng., 34(3), 405-411. https://doi.org/10.1016/j.ijimpeng.2005.12.001
  12. Frew, D.J., Forrestal, M.J. and Chen, W. (2001), "A split Hopkinson pressure bar technique to determine compressive stress-strain data for rock materials", Exp. Mech., 41(1), 40-46. https://doi.org/10.1007/BF02323102
  13. Frew, D.J., Forrestal, M.J. and Chen, W. (2002), "Pulse shaping techniques for testing brittle materials with a split Hopkinson pressure bar", Exp. Mech., 42(1), 93-106. https://doi.org/10.1007/BF02411056
  14. Gama, B.A., Lopatnikov, S.L. and Gillespie Jr, J.W. (2004), "Hopkinson bar experimental technique: A critical review", Appl. Mech. Rev., 57(4), 223-250. https://doi.org/10.1115/1.1704626
  15. Gary, G. and Bailly, P. (1998), "Behaviour of quasi-brittle material at high strain rate-Experimental modeling", Eur. J. Mech. A/Sol., 17(3), 403-420. https://doi.org/10.1016/S0997-7538(98)80052-1
  16. Gorham, D.A. (1989), "Specimen inertia in high strain-rate compression", J. Phys. D: Appl. Phys., 22(12), 1888-1893. https://doi.org/10.1088/0022-3727/22/12/014
  17. Gorham, D.A. (1991), "The effect of specimen dimensions on high strain rate compression measurements of copper", J. Phys. D: Appl. Phys., 24(8), 1489-1492. https://doi.org/10.1088/0022-3727/24/8/041
  18. Gray, G.T. (2000), "Classic Split-Hopkinson pressure bar testing", Mechanical Testing and Evaluation, Metals Handbook, American Society for Metals, Materials Park, OH, USA. 8, 462-476.
  19. Hao, Y., Hao, H. and Li, Z.X. (2010), "Numerical analysis of lateral inertial confinement effects on impact test of concrete compressive material properties", Int. J. Prot. Struct., 1(1), 145-167. https://doi.org/10.1260/2041-4196.1.1.145
  20. Imran, I. and Pantazopoulou, S.J. (1996), "Experimental study of plain concrete under triaxial stress", ACI Mater. J., 93(6), 589-601.
  21. Janach, W. (1976), "The role of bulking in brittle failure of rocks under rapid compression", Int. J. Rock. Mech. Mining. Sci. Geomech. Abstr., 13(6), 177-186. https://doi.org/10.1016/0148-9062(76)91284-5
  22. Katayama, M., Itoh, M., Tamura, S., Beppu, M. and Ohno, T. (2007), "Numerical analysis method for the RC and geological structures subjected to extreme loading by energetic materials", Int. J. Impact. Eng., 34(9), 1546-1561. https://doi.org/10.1016/j.ijimpeng.2006.10.013
  23. Kolsky, H. (1949), "An investigation of the mechanical properties of materials at very high rates of loading", Proc. Royal. Soc. Lond. B, 62, 676-700. https://doi.org/10.1088/0370-1301/62/11/302
  24. Kolsky, H. (1963), Stress Waves in Solids, Dover Publications Inc. New York, NY, USA.
  25. Kotsovos, M.D., Pavlovic, M.N. and Cotsovos, D.M. (2008), "Characteristic features of concrete behaviour: Implications for the development of an engineering finite-element tool", Comp. Concr., 5(3), 243-260. https://doi.org/10.12989/cac.2008.5.3.243
  26. Li, Q.M. and Meng, H. (2003), "About the dynamic strength enhancement of concrete-like materials in a split Hopkinson pressure bar test", Int. J. Sol. Struct., 40(2), 343-360. https://doi.org/10.1016/S0020-7683(02)00526-7
  27. Li, Q.M., Lu, Y.B. and Meng, H. (2009), "Further investigation on the dynamic compressive strength enhancement of concrete-like materials based on split Hopkinson pressure bar tests, part II: numerical simulations", Int. J. Impact. Eng., 36(12), 1335-1345. https://doi.org/10.1016/j.ijimpeng.2009.04.010
  28. Malinowski, J.Z. and Klepaczko, J.R. (1986), "A unified analytic and numerical approach to specimen behaviour in the split-Hopkinson pressure bar", Int. J. Mech. Sci., 28(6), 381-391. https://doi.org/10.1016/0020-7403(86)90057-3
  29. Mu, Z.C., Dancygier, A.N., Zhang, W. and Yankelevsky, D.Z. (2012), "Revisiting the dynamic compressive behavior of concrete-like materials", Int. J. Impact. Eng., 49, 91-102. https://doi.org/10.1016/j.ijimpeng.2012.05.002
  30. Murray, Y.D. (2007), "Users manual for LS_DYNA concrete material Model 159", Report FHWA-HRT-05-062 Fed. Highway Admin., USA.
  31. Murray, Y.D., AbuOdeh, A. and Bligh, R. (2007), Evaluation of Concrete Material Model 159, Report FHWA-HRT-05-063 Fed. Highway Admin., USA.
  32. Polanco-Loria, M., Hopperstad, O.S., Borvik, T. and Berstad, T. (2008), "Numerical predictions of ballistic limits for concrete slabs using a modified version of the HJC concrete model", Int. J. Impact. Eng., 35(5), 290-303. https://doi.org/10.1016/j.ijimpeng.2007.03.001
  33. Rossi, P. (1991), "A physical phenomenon which can explain the mechanical behaviour of concrete under high strain rates", Mat. Struct., 24(6), 422-424. https://doi.org/10.1007/BF02472015
  34. Samanta, S.K. (1971), "Dynamic deformation of aluminium and copper at elevated temperatures", J. Mech. Phys. Sol., 19(3), 117-122. https://doi.org/10.1016/0022-5096(71)90023-8
  35. Sfer, D., Carol, I., Gettu, R. and Etse, G. (2002), "Study of the behavior of concrete under triaxial compression", J. Eng. Mech., 128(2), 156-163. https://doi.org/10.1061/(ASCE)0733-9399(2002)128:2(156)
  36. Tham, C.Y. (2006), "Numerical and empirical approach in predicting the penetration of a concrete target by an ogive-nosed projectile", Finite Elem. Anal. Des., 42(14-15), 1258-1268. https://doi.org/10.1016/j.finel.2006.06.011
  37. Zhang, M., Li, Q.M., Huang, F.L., Wu, H.J. and Lu, Y.B. (2010), "Inertia-induced radial confinement in an elastic tubular specimen subjected to axial strain acceleration", Int. J. Impact Eng., 37(4), 459-464. https://doi.org/10.1016/j.ijimpeng.2009.09.009
  38. Zhang, M., Wu, H.J., Li, Q.M. and Huang, F.L. (2009), "Further investigation on the dynamic compressive strength enhancement of concrete-like materials based on split Hopkinson pressure bar tests part I: experiments", Int. J. Impact. Eng., 36(12), 1327-1334. https://doi.org/10.1016/j.ijimpeng.2009.04.009

피인용 문헌

  1. Strain Rate Dependent Behavior and Modeling for Compression Response of Hybrid Fiber Reinforced Concrete vol.13, pp.9, 2016, https://doi.org/10.1590/1679-78252717
  2. A nonlinear dynamic uniaxial strength criterion that considers the ultimate dynamic strength of concrete vol.103, 2017, https://doi.org/10.1016/j.ijimpeng.2017.01.011