Computers and Concrete

Techno-Press (테크노프레스)
권호 표지
DOI QR코드

DOI QR Code

Nonlinear finite element modeling of FRP-wrapped UHPC columns

  • Guler, Soner (Faculty of Civil Engineering, Istanbul Technical University) ;
  • Copur, Alperen (Faculty of Civil Engineering, Istanbul Technical University) ;
  • Aydogan, Metin (Faculty of Civil Engineering, Istanbul Technical University)
  • Received : 2012.10.24
  • Accepted : 2013.05.11
  • Published : 2013.10.25
⟨ Previous Next ⟩

Abstract

The primary aim of this study is to develop a three dimensional finite element (FE) model to predict the axial stress-strain relationship and ultimate strength of the FRP-wrapped UHPC columns by comparing experimental results. The reliability of four selected confinement models and three design codes such as ACI-440, CSA-S806-02, and ISIS CANADA is also evaluated in terms of agreement with the experimental results. Totally 6 unconfined and 36 different types of the FRP-wrapped UHPC columns are tested under monotonic axial compression. The values of ultimate strengths of FRP-wrapped UHPC columns obtained from the experimental results are compared and verified with finite element (FE) analysis results and the design codes mentioned above. The concrete damage plasticity model (CDPM) in Abaqus is utilized to represent the confined behavior of the UHPC. The results indicate that agreement between the test results and the non-linear FE analysis results is highly satisfactory. The CSA-S806-02 design code is considered more reliable than the ACI-440 and the ISIS CANADA design codes to calculate the ultimate strength of the FRP-wrapped UHPC columns. None of the selected confinement models that are developed for FRP-wrapped low and normal strength concrete columns can safely predict the ultimate strength of FRP-wrapped UHPC columns.

Keywords

References

  1. Abaqus (2008), Abaqus version 6.8-1 Manual.
  2. ACI-440 Committee (2002), "Guide for the design and construction of externally bonded FRP systems for strengthening concrete structures", ACI 440, Detroit.
  3. Al-Salloum, Y.A. (2007), "Influence of edge sharpness on the strength of square concrete columns confined with FRP composite laminates", Compos. Part B, 38(5-6), 640-650 https://doi.org/10.1016/j.compositesb.2006.06.019
  4. Canadian Standard Association (CSA) (2002), "Design and construction of building components with fibre-reinforced polymers", CSA-S806-02, CSA Rexdale BD, Toronto.
  5. Cozmanciuc, C., Oltean, R. and Munteanu, V. (2009), "Strengthening Techniques of RC Columns Using Fibre Reinforced Polymeric Materials", Bul. Inst. Poliytehnic, Iasi, s. Constr., Archit., 3, 85-92.
  6. Doran, B., Koksal, H.O. and Turgay, T. (2009), "Nonlinear finite element modeling of rectangular/square concrete columns confined with FRP", Mater. Des., 30(8), 3066-3075. https://doi.org/10.1016/j.matdes.2008.12.007
  7. Drucker, D.C. and Prager, W. (1952), "Soil mechanics and plastic analysis for limit design", Q. Appl.Math., 10, 157-165. https://doi.org/10.1090/qam/48291
  8. Fardis, M.N. and Khalili, H.H. (1982), "FRP-encased concrete as a structural material", Mag. Concrete Res., 34(212), 191-202. https://doi.org/10.1680/macr.1982.34.121.191
  9. Harmon, T.G. and Slattery, K.T. (1992), "Advanced composite confinement of concrete", Proceeding of the 428 1st Int. Conf. on Advanced Composite Materials in Bridges and Structures, The Canadian Society for Civil Engineering, Montreal, QC, Canada, 299-306.
  10. Hu, B. and Wang, J.G. (2009), "Comparison of strength, ultimate strain models of concrete columns confined with FRP", J. Civil Archit. Environ. Eng., 31(5), 9-15.
  11. Intelligent Sensing for Innovative Structures (ISIS) (2001). "Externally bonded FRP for strengthening reinforced concrete structures." The Canadian Network of Centres of Excellence on ISIS, ISIS M04,Winnipeg, Manitoba, Canada.
  12. Lam, L. and Teng, J.G. (2003), "Design-oriented stress-strain model for FRP-confined concrete in rectangular columns", J. Reinf. Plas.t Compos., 22(13), 1149-1186. https://doi.org/10.1177/0731684403035429
  13. Lee, J. and Fenves, G.L. (1998), "A plastic-damage model for cyclic loading of concrete ctructures", J. Eng. Mech., 124, 892-900. https://doi.org/10.1061/(ASCE)0733-9399(1998)124:8(892)
  14. Lubliner, J., Oliver, J., Oller, S. and Onate, E. (1989), "A plastic- damage model for concrete", Int. J. Solid Struct., 25, 299-326. https://doi.org/10.1016/0020-7683(89)90050-4
  15. Mandal, S., Hoskin, A. and Fam, A. (2005), "Influence of concrete strength on confinement effectiveness of fiber-reinforced polymer circular jackets", ACI Struct. J., 102(3), 383-392.
  16. Mirmiran, A., Zagers, K. and Wenqing, Y. (2000), "Nonlinear finite element modeling of concrete confined by fiber composites", Finite elem. Anal. Des., 35(1), 79-96. https://doi.org/10.1016/S0168-874X(99)00056-6
  17. Ponmolar, V. (2012), "Strength comparision of fiber reinforced polymer wrapped concrete exposed to high temperature", Int. J. Appl. Sci. Eng. Res., 1(2), 146-151.
  18. Rochette, P. and Labossière, P. (2000), "Axial testing of rectangular column models confined with composites", ASCE J. Compos. Constr., 4(3), 129-136. https://doi.org/10.1061/(ASCE)1090-0268(2000)4:3(129)
  19. Saafi, M., Toutanji, H.A. and Li, Z. (1999), "Behavior of concrete columns confined with fiber reinforced polymer tubes", ACI Mater. J., 96(4), 500-509.
  20. Shehata, I.A.E.M., Carnerio, L.A.V., and Shehata, L.D.D. (2002), "Strength of short concrete columns confined with CFRP sheets", Mater. Struct., 35, 50-58. https://doi.org/10.1007/BF02482090
  21. Shahawy, M., Mirmiran, A. and Beitelman, B. (2000), "Tests and modeling of carbon-wrapped concrete columns", Compos.: Part B, 31, 471-480. https://doi.org/10.1016/S1359-8368(00)00021-4
  22. Samaan, M., Mirmiran, A. and Shahawy, M. (1997), "Model of concrete confined by fiber composites", J. Struct. Eng., 124(9), 1025-1031.
  23. Spoelstra, M.R. and Monti, G. (1999), "FRP-confined concrete model", J. Compos. Constr., 3(3), 143-150. https://doi.org/10.1061/(ASCE)1090-0268(1999)3:3(143)
  24. Wang, L.M. and Wu, Y.F. (2008), "Effect of corner radius on the performance of CFRP-confined square concrete columns:Test", Eng. Struct., 30(2), 493-505. https://doi.org/10.1016/j.engstruct.2007.04.016
  25. Waghmare, S.P.B. (2011), "Materials and jacketing technique for retrofitting of structures", Int. J. Adv. Eng. Res., 1(1), 15-19.
  26. Zohrevand, P. and Mirmiran, A. (2011), "Behavior of ultrahigh-performance concrete confined by fiber-reinforced polymers", J. Mater. Civil Eng., 23(12), 1727-1734. https://doi.org/10.1061/(ASCE)MT.1943-5533.0000324

Cited by

  1. Flexural behavior of UHPC-RC composite beam vol.22, pp.2, 2016, https://doi.org/10.12989/scs.2016.22.2.387
  2. A Design-Oriented Combined Model (7 MPa to 190 MPa) for FRP-Confined Circular Short Columns vol.7, pp.12, 2015, https://doi.org/10.3390/polym7101489
  3. Computer based estimation of backbone curves for hysteretic Response of reinforced concrete columns under static cyclic lateral loads vol.14, pp.2, 2014, https://doi.org/10.12989/cac.2014.14.2.193