DOI QR코드

DOI QR Code

Recovery of spectral absolute acceleration and spectral relative velocity from their pseudo-spectral counterparts

  • Papagiannopoulos, George A. (Department of Civil Engineering, University of Patras) ;
  • Hatzigeorgiou, George D. (Department of Environmental Engineering, Democritus University of Thrace) ;
  • Beskos, Dimitri E. (Department of Civil Engineering, University of Patras)
  • 투고 : 2012.01.17
  • 심사 : 2012.11.21
  • 발행 : 2013.05.25

초록

Design spectra for damping ratios higher than 5% have several important applications in the design of earthquake-resistant structures. These highly damped spectra are usually derived from a 5%-damped reference pseudo-acceleration spectrum by using a damping modification factor. In cases of high damping, the absolute acceleration and the relative velocity spectra instead of the pseudo-acceleration and the pseudo-velocity spectra should be used. This paper elaborates on the recovery of spectral absolute acceleration and spectral relative velocity from their pseudo-spectral counterparts. This is accomplished with the aid of correction factors obtained through extensive parametric studies, which come out to be functions of period and damping ratio.

키워드

참고문헌

  1. ATC-40 (1996), Seismic evaluation and retrofit of concrete buildings, Applied Technology Council: Redwood City, California.
  2. Bommer, J.J. and Mendis, R. (2005), "Scaling of spectral displacements ordinates with damping ratios", Earthq. Eng. Struct. D., 34(2), 145-165. https://doi.org/10.1002/eqe.414
  3. Cameron, W.I. and Green, R.U. (2007), "Damping correction factors for horizontal ground-motion response spectra", B. Seismol. Soc. Am., 97, 934-960. https://doi.org/10.1785/0120060034
  4. Cardone, D., Dolce, M. and Rivelli, M. (2009), "Evaluation of reduction factors for high-damping design response spectra", B. Earthq. Eng., 7(1), 273-291. https://doi.org/10.1007/s10518-008-9097-y
  5. Eurocode 8 (2004), Design of structures for earthquake resistance, Part 1: General rules - Seismic actions and general requirements for structures, European pre-norm ENV 1998-1, CEN: Brussels.
  6. Hatzigeorgiou, G.D. (2010), "Damping modification factors for SDOF systems subjected to near-fault, far-fault and artificial earthquakes", Earthq. Eng. Struct. D., 39(11), 1239-1258. https://doi.org/10.1002/eqe.991
  7. Lin, Y.Y. and Chang, K.C. (2003), "A study on damping reduction factor for buildings under earthquake ground motion", J. Struct. Eng.-ASCE, 129(2), 206-214. https://doi.org/10.1061/(ASCE)0733-9445(2003)129:2(206)
  8. Lin, Y.Y. and Chang, K.C. (2004), "Effects of site classes on damping reduction factors", J. Struct. Eng.-ASCE, 130(11), 1667-1675. https://doi.org/10.1061/(ASCE)0733-9445(2004)130:11(1667)
  9. Lin, Y.Y., Miranda, E. and Chang, K.C. (2005), "Evaluation of damping reduction factors for estimating elastic response of structures with high damping", Earthq. Eng. Struct. D., 34(11), 1427-1443. https://doi.org/10.1002/eqe.499
  10. Mavroeides, G.P., Dong, G. and Papageorgiou, A.S. (2004), "Near-fault ground motions, and the response of elastic and inelastic single-degree-of-freedom (SDOF) system", Earthq. Eng. Struct. D., 33(9), 1023-1049. https://doi.org/10.1002/eqe.391
  11. Naeim, F. and Kelly, J.M. (1999), Design of seismic isolated structures, Wiley: Chichester, UK.
  12. NEHRP (2000), Recommended provisions for seismic regulations for new buildings and other structures, Federal Emergency Management Agency (FEMA): Washington, DC.
  13. Newmark, N.M. and Hall, W.J. (1982), Earthquake spectra and design, EERI Monograph Series. Earthquake Engineering Research Institute: Oakland, California.
  14. Papagiannopoulos, G.A. and Beskos, D.E. (2010), "Towards a seismic design method for plane steel frames by using equivalent modal damping ratios", Soil Dyn. Earthq. Eng., 30(10), 1106-1118. https://doi.org/10.1016/j.soildyn.2010.04.021
  15. Papagiannopoulos, G.A. and Beskos, D.E. (2011), "Modal strength reduction factors for seismic design of plane steel frames", Earthq. Struct., 2, 65-88. https://doi.org/10.12989/eas.2011.2.1.065
  16. Pekcan, G., Mander, J.B. and Chen, S.S. (1999), "Fundamental considerations for the design of non-linear viscous dampers", Earthq. Eng. Struct. D., 29(7), 1405-1425.
  17. Priestley, M.J.N., Calvi, G.M. and Kowalsky, M.J. (2007), Displacement based seismic design of structures, IUSS Press: Pavia, Italy.
  18. Ramirez, O.M., Constantinou, M.C., Whittaker, A.S., Kircher, C.A. and Chrysostomou, C.Z. (2002), "Elastic and inelastic seismic response of buildings with damping systems", Earthq. Spectra, 18, 531-547. https://doi.org/10.1193/1.1509762
  19. Rupakhety, R., Sigurdsson, S., Papageorgiou, A.S. and Sigbjornsson, R. (2011), "Quantification of ground-motion parameters and response spectra in the near-fault region", B. Seismol. Soc. Am., 9(4), 893-930.
  20. Sadek, F., Mohraz, B. and Riley, M.A. (2000), "Linear procedures for structures with velocity-dependent dampers", J. Struct. Eng.-ASCE, 126(8), 887-895. https://doi.org/10.1061/(ASCE)0733-9445(2000)126:8(887)
  21. Shibata, A. and Sozen, M.A. (1976), "Substitute-structure method for seismic design in R/C", J. Struct. Div.-ASCE, 102, 1-18.
  22. Song, J., Chu, Y.L., Liang, Z. and Lee, G.C. (2007), "Estimation of peak relative velocity and peak absolute acceleration of linear SDOF systems", Earthq. Eng. Eng. Vib., 6(1), 1-10. https://doi.org/10.1007/s11803-007-0702-x
  23. Soong, T.T. and Constantinou, M.C. (1994), Passive and active structural vibration control in civil engineering, Springer Verlag: New York.
  24. Stafford, P.J., Mendis, R. and Bommer, J.J. (2008), "The dependence of spectral damping ratios on duration and number of cycles", J. Struct. Eng.-ASCE, 134, 1364-1373. https://doi.org/10.1061/(ASCE)0733-9445(2008)134:8(1364)
  25. Table Curve 3D (2002), Version 4, SYSTAT Software Inc.
  26. Weitzmann, R., Ohsaki, M. and Nakashima, M. (2006), "Simplified methods for design of base-isolated structures in the long-period high-damping range", Earthq. Eng. Struct. D., 35(4), 497-515. https://doi.org/10.1002/eqe.544

피인용 문헌

  1. Estimation of Damping Correction Factors Using Duration Defined by the Standard Deviation of Phase Difference vol.31, pp.2, 2015, https://doi.org/10.1193/103012EQS321M
  2. Impact of Damping Scaling Factors on Direct Displacement-Based Design vol.32, pp.2, 2016, https://doi.org/10.1193/021815EQS031M
  3. Damping coefficients for soil–structure systems and evaluation of FEMA 440 subjected to pulse-like near-fault earthquakes vol.61-62, 2014, https://doi.org/10.1016/j.soildyn.2014.02.009
  4. Modal strength reduction factors for seismic design of steel moment resisting frames vol.154, 2018, https://doi.org/10.1016/j.engstruct.2017.10.071
  5. A seismic design method for reinforced concrete moment resisting frames using modal strength reduction factors pp.1573-1456, 2018, https://doi.org/10.1007/s10518-018-0436-3
  6. Wave shape analysis of seismic records at borehole of TTRH02 and IWTH25 (KiK-net) vol.18, pp.3, 2013, https://doi.org/10.12989/eas.2020.18.3.297
  7. A Damping Modification Factor Prediction Model for Horizontal Displacement Spectrum from Subduction Interface Earthquakes in Japan Accounting for Site Conditions vol.110, pp.3, 2013, https://doi.org/10.1785/0120190275
  8. An improvement of direct displacement-based design approach for steel moment-resisting frames controlled by fluid viscous dampers vol.24, pp.10, 2013, https://doi.org/10.1177/1369433221992496
  9. Effects of Earthquake Magnitude, Distance, and Site Conditions on Spectral and Pseudospectral Velocity Relationship vol.111, pp.6, 2013, https://doi.org/10.1785/012021015