DOI QR코드

DOI QR Code

Flow Analyses Inside Jet Pumps Used for Oil Wells

  • Samad, Abdus (Department of Ocean Engineering, Indian Institute of Technology Madras) ;
  • Nizamuddin, Mohammad (Department of Ocean Engineering, Indian Institute of Technology Madras)
  • Received : 2012.07.20
  • Accepted : 2012.10.27
  • Published : 2013.03.31

Abstract

Jet pump is one type of artificial lifts and is used when depth and deviation of producing wells increases and pressure depletion occurs. In the present study, numerical analysis has been carried out to analyze the flow behavior and find the performance of the jet pump. Reynolds-averaged Navier Stokes equations were solved and k-${\varepsilon}$ turbulence model was used for simulations. Water and light oil as primary fluids were used to pump water, light oil and heavy oil. The ratios of area and length to diameter of the mixing tube were considered as design parameters. The pump efficiency was considered to maximize for the downhole conditions. It was found that the increase in viscosity and density of the secondary fluid reduced efficiency of the system. Water as primary fluid produced better efficiency than the light oil. It was also found that the longer throat length increased efficiency upto 40% if light oil was used as primary fluid and secondary fluid viscosity was 350 cSt.

Keywords

References

  1. Alemi, M., Jalalifer, H., Kamali, G., and Kalbasi, M., 2010, "A Prediction to the Best Artificial Lift Method Selection on the Basis of TOPSIS Model," Journal of Petroleum and Gas Engineering, Vol. 1(1), pp. 009-015.
  2. Corteville, J.C., Ferschneider, G., Hoffmann, F.C., and Valentin, E.P., 1987, "Research on Jet Pumps for Single and Multiphase Pumping of Crudes," Annual Technical Conference and Exhibition of SPE, Dallas.
  3. Mallela, R., and Chatterjee, D., 2011, "Numerical Investigations of the Effect of Geometry on the Performance of Jet Pump," Journal of Mechanical Engineering Science, vol. 225, pp. 1-12. https://doi.org/10.1243/09544062JMES2267
  4. Hesham, A.M.A., Mikhail, S., and Mohsen, A., 2006, "Jet Pump Performance With Secondary Fluids Differ in Density and Viscosity From Primary Fluid," International Petroleum Exhibition and Conference, Abu Dhabi.
  5. Hatzlavramidis, D.T., 1989 "Modelling and Design of Jet Pumps," SPE Annual Technical Conference and Exhibition, San Antonio.
  6. DeFrate, L.A., and Hoerl, A.E., 1956, "Optimum Design of Ejectors Using Digital Computers," Chemical Engineering Symposium Series, Vol. 55, No. 21, p. 43.
  7. Zhang, Q., 2000, "Principle and Design of Oil Production Engineering," Journal of China University of Petroleum, Vol. 24, Issue 9, pp. 21-24.
  8. DeGhetto, G., Riva, M., and Giunta, P., 1994, "Jet Pump Testing in Italian Heavy Oils," SPE European Production Operations Conference and Exhibition, Aberdeen.
  9. Chen, S., Heng, L., Qi, Z., Jun, H., and Daoyong, Y, 2005, "Circulating Usage of Partial Produced Fluid For Jet Pump in Deep Heavy Oil Production," SPE International Thermal Operations and Heavy Oil Symposium, Alberta, Canada.
  10. Christ, F.C., and Petrie, H, L., 1989, "Obtaining Low Bottomhole Pressure in Deep Wells With Hydraulic Jet Pumps," SPE Journal of Production Engineering, Vol. 4, No. 3, pp. 290-294. https://doi.org/10.2118/15177-PA
  11. Chen, S., Zhang, Q., Yang, Q., and He, J., 2010, "Parametric Design and Application of Jet Pumping in an Ultra-Deep Heavy Oil Reservoir," SPE International Oil and Gas Conference and Exhibition, Beijing, China.
  12. Quan, Z., 1985, "Study on the Calculation Method for the Viscosity of Diluted Heavy Oil," Journal of Oil and Gas Storage and Transportation, Vol. 4(5), pp. 33-36.
  13. Liu, T. and Xu, C., 1992, "Calculation Methods and Amelioration for the Viscosity of Diluted Heavy Oil," Journal of Oil and Gas Storage and Transportation, Vol. 11 (2), pp. 56-62.
  14. Chen, S., Li, H., Yang, D., Zhang, Q., and He, J., 2008, "Reduction of Light Oil Usage as Power Fluid for Jet Pumping in Deep Heavy Oil Reservoirs," International Thermal Operations and Heavy Oil Symposium, Alberta, Cananda.
  15. Cunningham, R.G., 1957, "Jet Pump Theory and Performance With Fluids of High Viscosity," Trans. ASME 79: 1807-1820.
  16. Grupping, A.W., Coppes, J.L.R., and Groot, J.G., 1988, "Fundamentals of Oil Well Jet Pumping," Journal of SPE Production Engineering, Vol. 3 (1), pp. 9-14. https://doi.org/10.2118/15670-PA
  17. Knight, G.B., 1959, "Five Ways to Automatically Control Pressure for Ejector Vacuum Systems," Journal of Chemical Engineering, Vol. 66, Issue 6, pp. 69-83.
  18. Simpson, D.A., 2003, "Coal Bed Methane Production," SPE Production and Operations Symposium, Oklahoma, USA.
  19. Drozdov, A.N., Malyavko, E.A., Alekseev, Y.L. and Shashel, O.V., 2011, "Stand Research and Analysis of Liquid-Gas Jet-Pump's Operation Characteristics for Oil and Gas Production," SPE Annual Technical Conference and Exhibition, Colarado, USA.
  20. Fan, J., Eves, J., Thompson, H.M., Toropov, V.V., Kapur, N., Copley, D., and Mincher, A., 2011, "Computational Fluid Dynamic Analysis and Design Optimization of Jet Pumps," Journal of Computers and Fluids, Vol. 46, Issue 1, pp. 212-217. https://doi.org/10.1016/j.compfluid.2010.10.024
  21. Song, X.G., Park, J.H., Kim, S.G., and Park, Y.C., 2011, "Performance Comparison and Erosion Prediction of Jet Pumps by Using a Numerical Method," doi:10.1016/j.mcm.2011.06.040.
  22. Krishnamurthy, P., 1975, "Design, Fabrication and Testing of Multiple Nozzle Jet Pump," MTech Thesis, Department of Mechanical Engineering, IIT Madras, India.
  23. Gresho, P.M., 1991, "Incompressible Fluid Dynamics: Some Fundamental Fluid Dynamic Issues," Ann. Rev. Fluid Mech., Vol. 23, pp. 413-453. https://doi.org/10.1146/annurev.fl.23.010191.002213
  24. Samad, A., and Kim, K.Y., 2009, "Surrogate Based Optimization Techniques for Aerodynamic Design of Tubomachinery", International Journal of Fluid Machinery and Systems, Vol. 2, No. 2, pp. 179-188. https://doi.org/10.5293/IJFMS.2009.2.2.179