래핑의 공정변수가 표면거칠기에 미치는 영향

Effect of Process Parameters on Surface Roughness in Lapping Operation

  • 최만성 (한국기술교육대학교 메카트로닉스공학부)
  • Choi, Mansung (School of Mechatronics Engineering, Korea University of Technology and Education)
  • 투고 : 2013.11.04
  • 심사 : 2013.11.30
  • 발행 : 2013.12.31

초록

Lapping is a very complicated and random process resulting from the variation of abrasive grains in its sizes and shapes and from the numerous factors having an effect on the process quality. This paper presents a study of a $2^4$ full factorial experimental design and analysis to optimize surface quality in lapping operation. The optimization of the factors to obtain minimum surface roughness was carried out by incorporating effect plots, main effect plots, interaction plots, analysis of variance(ANOVA), surface plots, and contour plots. The statistical design experiments, designed to reduce the total number of experiments required, indicated that, within the selected conditions, all the parameters influenced at a significance level of 5%. In addition, some of the possible interactions between these parameters also influenced the lapping process, especially those that were of third order. A regression model was suggested and fitted the experimental data very well.

키워드

참고문헌

  1. Lynah P., Hoffman PR., "Lapping," ASM Hand Book, 16 : 492-505, 1989.
  2. Le X., Peterson ML., "Material Removal Rate in Flat Lapping," J. of Manufacturing Process Vol. 6(1), pp. 71-78, 1999.
  3. Davis JR., "Surface Engineering of Carbon and Alloy Steels," ASM Handbook 5: pp.701-710, 1994.
  4. Deshpande LS., "Influence of Abrasive Material Properties on the Surface Generated in Flat Lapping," Published Master's Thesis, University of Oklahoma, Norman, OK, pp 19-30, 2005.
  5. Pronzato L., "Optimal Experimental Design and Some Related Control problems," Automatica, Vol. 44, pp. 303-325, 2008. https://doi.org/10.1016/j.automatica.2007.05.016
  6. Lee, K. and Kim, J., "Controller Gain Tuning of a Simultaneous Multi-Axis PID Control System Using the Taguchi Method," Control Eng. Practice., vol. 8, pp. 949-958, 2000. https://doi.org/10.1016/S0967-0661(99)00201-4
  7. Kumar S., Kumar P., Shan H. S., "Effect of evaporative pattern casting process parameters on the surface roughness of Al7%Si alloy casting," Journal of Materials Processing Technology, Vol. 182, pp. 615623. 2007.
  8. Griffiths W. D., Davies P. J., "The permeability of lost foam pattern coatings for Al alloy castings," Journal of Materials Science," Vol. 43, pp. 54415447, 2008.
  9. Vijian P., Arunachalam P., "Optimization of squeeze cast parameters of LM6 aluminium alloy for surface roughness using Taguchi method," J. of Materials Science and Technology, Vol. 180. pp 161166. 2006.