Computers and Concrete

  • 제10권4호
  • /
  • Pages.349-360
  • /
  • 2012
  • /
  • 1598-8198(pISSN)
  • /
  • 1598-818X(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Permeability and abrasion resistance of concretes containing high volume fine fly ash and palm oil fuel ash

  • Homwuttiwong, S. (Department of Civil Engineering, Faculty of Engineering, Mahasarakham University) ;
  • Jaturapitakkul, C. (Department of Civil Engineering, Faculty of Engineering, King Mongkut's University of Technology Thonburi (KMUTT)) ;
  • Chindaprasirt, P. (Sustainable Infrastructure Research and Development Center, Department of Civil Engineering, Faculty of Engineering, Khon Kaen University)
  • 투고 : 2011.06.22
  • 심사 : 2012.04.17
  • 발행 : 2012.10.25
⟨ 이전 논문 다음 논문 ⟩

초록

In this paper, compressive strength, water permeability and abrasion resistance of concretes containing high volume fine fly ash (FFA) and fine ground palm oil fuel ash (GPA) were studied. Portland cement type I was replaced with FFA and GPA at dosages up to 70% by weight of binder. Ground river sand (GRS) was also used to replace Portland cement in order to indicate the level of filler effect. Results indicated that FFA was slightly more reactive than GPA. The replacement of 40-70% of FFA produced concretes with compressive strength, permeability and abrasion resistance comparable to those of normal concretes. The incorporation of GPA slightly reduced the performances of concretes as compared to those of FFA concretes. The reduction of Portland cement was partly compensated by the increase in pozzolanic activity of the fine fly ash and palm oil fuel ash and thus enabled the large replacement levels.

키워드

참고문헌

  1. ASTM C1138-97, Standard test method for abrasion resistance of concrete (Underwater method), Philadelphia.
  2. ASTM C618-08a, Standard specification for coal fly ash and raw or calcined natural pozzolan for use in concrete, philadelphia.
  3. Awal, A.S.M.A. and Hussin, M.W. (1997), "The effectiveness of palm oil fuel ash in preventing expansion due to alkali-silica reaction", Cement Concrete Comp., 19(4), 367-372. https://doi.org/10.1016/S0958-9465(97)00034-6
  4. Basheer, L., Kropp, J. and Cleland, D.J. (2001), "Assessment of the durability of concrete from its permeation properties: a review", Constr. Build. Mater., 15(2-3), 93-103. https://doi.org/10.1016/S0950-0618(00)00058-1
  5. Chindaprasirt, P., Chareerat, T., Hatanaka, S. and Cao, T. (2010a), "High strength geopolymer using fine high calcium fly ash", J. Mater. Civil Eng., 23(3), 264-270.
  6. Chindaprasirt, P., Chotetanorm, C. and Rukzon, S. (2010b), "The use of palm oil fuel ash to improve the chloride and corrosion resistance of high-strength and high-workability concrete", J. Mater. Civil Eng., 23(4), 499-503.
  7. Chindaprasirt, P., Homwuttiwong, S. and Sirivivatnanon, V. (2004), "Influence of fly ash fineness on strength, drying shrinkage and sulfate resistance of blended cement mortar", Cement Concrete Res., 34(7), 1087-1092. https://doi.org/10.1016/j.cemconres.2003.11.021
  8. Chindaprasirt, P., Jaturapitakkul, C. and Sinsiri, T. (2005), "Effect of fly ash fineness on compressive strength and pore size of blended cement paste", Cement Concrete Comp., 27(4), 425-428. https://doi.org/10.1016/j.cemconcomp.2004.07.003
  9. Chindaprasirt, P., Jaturapitakkul, C. and Sinsiri, T. (2007), "Efffect of fly ash fineness on microstructure of blended cement paste", Constr. Build. Mater., 21(7), 1534-1541. https://doi.org/10.1016/j.conbuildmat.2005.12.024
  10. Concrete Society Ltd. (1987), "Permeability testing of site concrete: a review of methods and experience", Report No. 31. Report of a concrete society working party. The Concrete Society, London.
  11. Erdogdu, K. and Turker, P. (1998), "Effects of fly ash particle size on strength of Portland cement fly ash mortars", Cement Concrete Res., 28(9), 1217-1222. https://doi.org/10.1016/S0008-8846(98)00116-1
  12. Govindarajan, D. and Gopalakrishnan, R. (2009), "Magnetic susceptibility measurements on metakaolin admixtured cement hydrated with ground water and sea water", Int. J. Miner. Metall. Mater., 16(3), 349-354. https://doi.org/10.1016/S1674-4799(09)60063-7
  13. Isaia, G.C., Gastaldini, A.L.G. and Moraes, R. (2003), "Physical and pozzolanic action of mineral additions on the mechanical strength of high-performance", Cement Concrete Comp., 25(1), 69-76. https://doi.org/10.1016/S0958-9465(01)00057-9
  14. Jiang, L.H. and Malhotra, V.M. (2000), "Reduction in water demand of non-air-entrained concrete incorporating large volumes of fly ash", Cement Concrete Res., 30(11), 1785-1789. https://doi.org/10.1016/S0008-8846(00)00397-5
  15. Khan, M.I. (2003), "Permeation of high performance concrete", J. Mater. Civil Eng., 15(1), 84-92. https://doi.org/10.1061/(ASCE)0899-1561(2003)15:1(84)
  16. Khatri, R.P. and Sirivivatnanon, V. (1997), "Methods for the determination of water permeability of concrete", ACI Mater. J., 94(3), 257-261.
  17. Li, H., Zhang, M.H. and Ou, J.P. (2006), "Abrasion resistance of concrete containing nano-particles for pavement", Wear, 260(11-12), 1262-1266. https://doi.org/10.1016/j.wear.2005.08.006
  18. Liu, Y.W., Yen, T. and Hsu, T.H. (2006), "Abrasion erosion of concrete by water-borne sand", Cement Concrete Res., 36(10), 1814-1820. https://doi.org/10.1016/j.cemconres.2005.03.018
  19. Malhotra, V.M. (2002), "Introduction: sustainable development and concrete technology", ACI Concrete Int., 24(7), 22.
  20. Naik, T.R., Singh, S.S. and Hossain, M.M. (1996), "Permeability of high-strength concrete containing low cement factor", J. Energy Eng., 122(1), 21-39. https://doi.org/10.1061/(ASCE)0733-9402(1996)122:1(21)
  21. Naik, T.R., Singh, S.S. and Ramme, B.W. (2002), "Effect of source of fly ash on abrasion resistance of concrete", J. Mater. Civil Eng., 14(5), 417-426. https://doi.org/10.1061/(ASCE)0899-1561(2002)14:5(417)
  22. Nehdi, M., Mindess, S. and Aitcin, P.C. (1998), "Rheology of high-performance concrete: effect of ultrafine particles", Cement Concrete Res., 28(5), 687-697. https://doi.org/10.1016/S0008-8846(98)00022-2
  23. Neville, A.M. (1995), Properties of concrete, 4th and final edition, London, Addison Wesley Longman Limited.
  24. Poon, C.S., Azhar, S., Anson, M. and Wong, Y.L. (2001), "Comparison of the strength and durability performance of normal and high-strength pozzolanic concretes at elevated temperatures", Cement Concrete Res., 31(9), 1291-1300. https://doi.org/10.1016/S0008-8846(01)00580-4
  25. Ramezanianpour, A.A. and Malhotra, V.M. (1995), "Effect of curing on the compressive strength, resistance to chloride-ion penetration and porosity of concretes incorporating slag, fly ash or silica fume", Cement Concrete Comp., 17(2), 125-133. https://doi.org/10.1016/0958-9465(95)00005-W
  26. Rukzon, S. and Chindaprasirt, P. (2009a), "Strength and chloride penetration of Portland cement mortar containing palm oil fuel ash and ground river sand", Comput. Concrete, 6(5), 391-401. https://doi.org/10.12989/cac.2009.6.5.391
  27. Rukzon, S. and Chindaprasirt, P. (2009b), "Strength and chloride resistance of blended Portland cement mortar containing palm oil fuel ash and fly ash", Int. J. Miner., Metall. Mater., 16(4), 475-481. https://doi.org/10.1016/S1674-4799(09)60083-2
  28. Sata, V., Khammathit, P. and Chindaprasirt, P. (2011), "Efficiency factor of high calcium Class F fly ash concrete", Comput. Concrete, 8(5), 583-595. https://doi.org/10.12989/cac.2011.8.5.583
  29. Sathonsaowaphak, A., Chindaprasirt, P. and Pimraksa, K. (2009), "Workability and strength of lignite bottom ash geopolymer mortar", J. Hazard. Mater., 168(1), 44-50. https://doi.org/10.1016/j.jhazmat.2009.01.120
  30. Serdar, A., Halit, Y., Hüseyin, Y. and Bülent, B. (2007), "Sulfuric acid resistance of high-volume fly ash concrete", Build. Environ., 42(2), 717-721. https://doi.org/10.1016/j.buildenv.2005.10.024
  31. Siddique, R. (2003), "Effect of fine aggregate replacement with Class F fly ash on the abrasion resistance of concrete", Cement Concrete Res., 33(11), 1877-1881. https://doi.org/10.1016/S0008-8846(03)00212-6
  32. Tangchirapat, W., Jaturapitakkul, C. and Chindaprasirt, P. (2009), "Use of palm oil fuel ash as a supplementary cementitious material for producing high-strength concrete", Constr. Build. Mater., 23(7), 2641-2646. https://doi.org/10.1016/j.conbuildmat.2009.01.008
  33. Tangpagasit, J., Cheerarot, R., Jaturapitakkul, C. and Kiattikomol, K. (2005), "Packing effect and pozzolanic reaction of fly ash in mortar", Cement Concrete Res., 35(6), 1145-1151. https://doi.org/10.1016/j.cemconres.2004.09.030
  34. Tay, J.H. (1990), "Ash from oil-palm waste as concrete material", J. Mater. Civil Eng., 2(2), 94-105. https://doi.org/10.1061/(ASCE)0899-1561(1990)2:2(94)
  35. Vedalakshmi, R., Sundara Raj, A., Srinivasan, S. and Ganesh Babu, K. (2003), "Quantification of hydrated cement products of blended cements in low and medium strength concrete using TG and DTA technique", Thermochim Acta, 407(1-2), 49-60. https://doi.org/10.1016/S0040-6031(03)00286-7

피인용 문헌

  1. Parametric Study for Replacement of Sand by Fly Ash for Better Packing and Internal Curing vol.05, pp.01, 2015, https://doi.org/10.4236/ojce.2015.51012
  2. Testing of the permeability of concrete box beam with ion transport method in service vol.15, pp.3, 2015, https://doi.org/10.12989/cac.2015.15.3.461
  3. Probabilistic modeling of geopolymer concrete using response surface methodology vol.19, pp.6, 2012, https://doi.org/10.12989/cac.2017.19.6.737