Structural Engineering and Mechanics

  • 제41권4호
  • /
  • Pages.509-525
  • /
  • 2012
  • /
  • 1225-4568(pISSN)
  • /
  • 1598-6217(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Strain distribution between CFRP strip and concrete at strengthened RC beam against shear

  • Anil, Ozgur (Civil Engineering Department, Gazi University) ;
  • Bulut, Nalan (Civil Engineering Department, Gazi University) ;
  • Ayhan, Murat (Civil Engineering Department, Gazi University)
  • 투고 : 2010.12.31
  • 심사 : 2012.01.28
  • 발행 : 2012.02.25
⟨ 이전 논문 다음 논문 ⟩

초록

In recent years, CFRP material usage in strengthening applications gradually became widespread. Especially, the studies on the strengthening of shear deficient reinforced concrete beams with CFRP strips are chosen as a subject to numerous experimental studies and research on this subject are increased rapidly. The most important variable, that is affected on the failure mode of CFRP strips and that is needed for determining the shear capacity of the strengthened reinforced concrete beams, is the strain distribution between CFRP strips and concrete. Numerous experimental studies are encountered in the literature about the determination of strain distribution between CFRP strips and concrete. However, these studies mainly focused on the CFRP strips under axial tension. There are very limited numbers of experimental and analytic studies examining the strain distribution between concrete and CFRP strips, which are under combined stresses due to the effects of shear force and bending moment. For this reason, existing experimental study in the literature is used as model for ANSYS finite element software. Nonlinear finite element analysis of RC beams strengthened against shear with CFRP strips under reverse cyclic loading is performed. The strain distributions between CFRP strips and concrete that is obtained from finite element analysis are compared with the results of experimental measurements. It is seen that the experimental results are consisted with the results derived from the finite element analysis and important findings on the strain distribution profile are reached by obtaining strain values of many points using finite element method.

키워드

참고문헌

  1. Anil, O. (2008), "Strengthening of RC T-section beams with low strength concrete using CFRP composites subjected to cyclic load", Constr. Build. Mater., 22, 2355-2368. https://doi.org/10.1016/j.conbuildmat.2007.10.003
  2. Baran, A. and Anil, O. (2010), "Nonlinear finite element analysis of effective CFRP bonding length and strain distribution along concrete-CFRP interface", Comput. Concrete, 7(5), 427-453.
  3. Chen, J.F. and Teng, J.G. (2001), "Anchorage strength models for FRP and steel plates bonded to concrete", J. Struct. Eng.-ASCE, 127(7), 784-791. https://doi.org/10.1061/(ASCE)0733-9445(2001)127:7(784)
  4. Chen, J.F. and Teng, J.G. (2003), "Shear capacity of FRP strengthened RC beams: FRP debonding", Constr. Build. Mater., 17(1), 27-41. https://doi.org/10.1016/S0950-0618(02)00091-0
  5. Ersoy, U. (2000), "Reinforced concrete", METU, Ankara.
  6. Lu, X.Z., Ye, L.P., Teng, J.G. and Jiang, J.J. (2005a), "Meso-scale finite element model for FRP sheets-plates bonded to concrete", Eng. Struct., 27, 564-575. https://doi.org/10.1016/j.engstruct.2004.11.015
  7. Lu, X.Z., Teng, J.G., Ye, L.P. and Jiang, J.J. (2005b), "Bond-slip models for FRP sheets-plates bonded to concrete", Eng. Struct., 27, 920-937. https://doi.org/10.1016/j.engstruct.2005.01.014
  8. Mohamed Ali, M.S., Oehlers, D.J. and Bradford, M.A. (2001), "Shear peeling of steel plates bonded to the tension faces of RC beams", J. Struct. Eng.-ASCE, 127(12), 1453-1460. https://doi.org/10.1061/(ASCE)0733-9445(2001)127:12(1453)
  9. Mohamed Ali, M.S., Oehlers, D.J. and Bradford, M.A. (2002), "Interaction between flexure and shear on the debonding of RC beams retrofitted with compression face plates", Adv. Struct. Eng., 5(4), 223-230. https://doi.org/10.1260/136943302320974590
  10. Oehlers, D.J. and Moran, J.P. (1990), "Premature failure of externally plated reinforced concrete beams", J. Struct. Div.-ASCE, 116(4), 978-995. https://doi.org/10.1061/(ASCE)0733-9445(1990)116:4(978)
  11. Oehlers, D.J., Park, S.M. and Mohamed Ali, M.S. (2003), "A structural engineering approach to adhesive bonding longitudinal plates to RC beams and slabs", Compos. Part A, 34(12), 887-897. https://doi.org/10.1016/S1359-835X(03)00153-2
  12. Pham, H.B., Al-Mahaidi, R. and Saouma, V. (2006), "Modeling of CFRP-concrete bond using smeared and discrete cracks", Compos. Struct., 75, 145-150. https://doi.org/10.1016/j.compstruct.2006.04.039
  13. Smith, S.T. and Teng, J.G. (2002a), "FRP-strengthened RC beams-I: review of debonding strength models", Eng. Struct., 24(4), 385-395. https://doi.org/10.1016/S0141-0296(01)00105-5
  14. Smith, S.T. and Teng, J.G. (2002b), "FRP-strengthened RC beams-II: assessment of debonding strength models", Eng. Struct., 24(4), 397-417. https://doi.org/10.1016/S0141-0296(01)00106-7
  15. Smith, S.T. and Teng, J.G. (2003), "Shear-bending interaction in debonding failures of FRP-plated RC beams", Adv. Struct. Eng., 6(3), 183-199. https://doi.org/10.1260/136943303322419214
  16. Teng, J.G., Smith, S.T., Yao, J. and Chen, J.F. (2003), "Intermediate crack-induced debonding in RC beams and slabs", Constr. Build. Mater., 17(6-7), 447-462. https://doi.org/10.1016/S0950-0618(03)00043-6
  17. Teng, J.G., Chen, J.F., Smith, S.T. and Lam, L. (2002), FRP-strengthened RC Structures, Chichester, Wiley.
  18. William, K.J. and Warnke, E.P. (1974), "Constitutive model for the triaxial behavior of concrete", IABSE Report No.19, 19, 1-30.
  19. Yao, J., Teng, J.G. and Chen, J.F. (2005), "Experimental study on FRP-to-concrete bonded joints", Compos. Part B-E., 36(4), 99-113. https://doi.org/10.1016/j.compositesb.2004.06.001

피인용 문헌

  1. High-strength concrete deep beams with web openings strengthened by carbon fiber reinforced plastics vol.15, pp.1, 2015, https://doi.org/10.12989/cac.2015.15.1.021
  2. Flexural behaviour of reinforced low-strength concrete beams strengthened with CFRP plates vol.47, pp.6, 2013, https://doi.org/10.12989/sem.2013.47.6.819
  3. Embedded Connector in Severe Optimization of Steel Plate for Shear Strengthening of RC Beam: Experimental and Numerical Investigations vol.2018, pp.1687-8094, 2018, https://doi.org/10.1155/2018/4721431