Steel and Composite Structures

  • 제13권5호
  • /
  • Pages.489-500
  • /
  • 2012
  • /
  • 1229-9367(pISSN)
  • /
  • 1598-6233(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Experimental investigations on composite slabs to evaluate longitudinal shear strength

  • Saravanan, M. (CSIR-Structural Engineering Research Centre, CSIR campus) ;
  • Marimuthu, V. (CSIR-Structural Engineering Research Centre, CSIR campus) ;
  • Prabha, P. (CSIR-Structural Engineering Research Centre, CSIR campus) ;
  • Arul Jayachandran, S. (CSIR-Structural Engineering Research Centre, CSIR campus) ;
  • Datta, D. (Institute for Steel Development And Growth (INSDAG))
  • 투고 : 2009.10.05
  • 심사 : 2012.09.16
  • 발행 : 2012.11.25
⟨ 이전 논문 다음 논문 ⟩

초록

Cold-formed steel profile sheets acting as decks have been popularly used in composite slab systems in steel structural works, since it acts as a working platform as well as formwork for concreting during construction stage and also as tension reinforcement for the concrete slab during service. In developing countries like India, this system of flooring is being increasingly used due to the innate advantage of these systems. Three modes of failure have been identified in composite slab such as flexural, vertical shear and longitudinal shear failure. Longitudinal shear failure is the one which is difficult to predict theoretically and therefore experimental methods suggested by Eurocode 4 (EC 4) of four point bending test is in practice throughout world. This paper presents such an experimental investigation on embossed profile sheet acting as a composite deck where in the longitudinal shear bond characteristics values are evaluated. Two stages, brittle and ductile phases were observed during the tests. The cyclic load appears to less effect on the ultimate shear strength of the composite slab.

키워드

참고문헌

  1. ASCE. (1992), "Standard for the structural design of composite slab", ANSI/AASCE 3-91, American Society of Civil Engineers, New York.
  2. Burnet, M. J. and Oehlers, D. J. (2001), "Rib shear connectors in composite profiled slabs", J. Constr. Steel Res., 57, 1267-1287. https://doi.org/10.1016/S0143-974X(01)00038-4
  3. Chen, S. (2003), "Load carrying capacity of composite slabs with various end constraints", J. Constr. Steel Res., 59, 385-403. https://doi.org/10.1016/S0143-974X(02)00034-2
  4. Crisinel, M. and Marimon, F. (2004), "A new simplified method for the design of composite slabs", J. Constr. Steel Res., 60, 481-491. https://doi.org/10.1016/S0143-974X(03)00125-1
  5. Emanuel Lopes and Rui Simoes, (2008), "Experimental and analytical behaviour of composite slabs", Steel and Composite Structures, 8(5), 361-388. https://doi.org/10.12989/scs.2008.8.5.361
  6. Eurocode 4. (2001), Design of composite steel and concrete structures. Part 1.1. General rules and rules for buildings.
  7. IS 10262. (1982), IS recommended guidelines for mix design. Bureau of Indian Standards.
  8. IS:875 (Part 2). (1987), IS Code of practice for design loads (other than earthquake) for buildings and structures: Pt.2 - Imposed loads. Bureau of Indian Standards.
  9. Makelainen, P. and Sun, Y. (1999), "The longitudinal behaviour of a new steel sheeting profile for composite floor slabs" J. Constr. Steel Res., 49, 117-128. https://doi.org/10.1016/S0143-974X(98)00211-9
  10. Marimuthu, V., Seetharamana, S., Arul Jayachandrana, S., Chellappana, A., Bandyopadhyayb, T. K. and Duttab, D. (2007), "Experimental studies on composite deck slabs to determine the shear bond characteristic (m-k) values of the embossed sheet", J. Constr. Steel Res., 63, 791-803. https://doi.org/10.1016/j.jcsr.2006.07.009
  11. Wright, H. D., Evans, H. R. and Harding, P. W. (1987), "The use of profiled steel sheeting in floor construction", J. Constr. Steel Res., 7, 279-295. https://doi.org/10.1016/0143-974X(87)90003-4

피인용 문헌

  1. Effect of fibers and welded-wire reinforcements on the diaphragm behavior of composite deck slabs vol.19, pp.1, 2015, https://doi.org/10.12989/scs.2015.19.1.153
  2. Experimental Study of In-Plane Shear Behavior of Fiber-Reinforced Concrete Composite Slabs vol.142, pp.3, 2016, https://doi.org/10.1061/(ASCE)ST.1943-541X.0001413
  3. Experimental investigation of longitudinal shear behavior for composite floor slab vol.23, pp.3, 2012, https://doi.org/10.12989/scs.2017.23.3.351
  4. Prediction of longitudinal shear resistance of steel-concrete composite slabs vol.193, pp.None, 2019, https://doi.org/10.1016/j.engstruct.2019.05.010
  5. Strengthening of steel-concrete composite beams with composite slab vol.34, pp.1, 2020, https://doi.org/10.12989/scs.2020.34.1.091
  6. An innovative system to increase the longitudinal shear capacity of composite slabs vol.35, pp.4, 2012, https://doi.org/10.12989/scs.2020.35.4.509
  7. Experimental and numerical study of continuous span concrete composite slabs vol.34, pp.None, 2021, https://doi.org/10.1016/j.istruc.2021.08.043