회귀분석법을 이용한 사출금형의 수축률 분석에 관한 연구

A Study Shrinkage Analysis of Injection mold using Regression Analysis

  • 류미라 (인제대학교 2단계 BK21 미래형자동차 사업팀) ;
  • 배희은 (라온엑스 솔루션즈(주)) ;
  • 박정호 (창원문성대학) ;
  • 박종상 (창원문성대학) ;
  • 박성호 (창원문성대학) ;
  • 이대희 (인제대학교 기계자동차공학부) ;
  • 이성범 (인제대학교 기계자동차공학부)
  • 투고 : 2011.08.18
  • 심사 : 2011.09.15
  • 발행 : 2011.09.30

초록

It is not easy to predict the shrinkage rate of a plastic injection mold in its design process. The shrinkage rate should be considered as one of the important performances to produce the reliable products. The shrinkage rate can be determined by using the CAE tools in the design produces. However, since the analysis can take minutes to hours, the high computational costs of performing the analysis limit their use in design optimization. Therefore this study was carried out to presume for mutual relation of analysis condition to get the optimum average shrinkage by regression analysis. The results shown that coefficient of determination of regression equation has a fine reliability over 87% and regression equation of average shrinkage is made by regression analysis.

키워드

참고문헌

  1. M. R. Ryu, Y. H. Kim, S. J. LEE, K. H. Lee, H. S. Park, "Injection mold Design Optimization using Regression Analysis", KSPE, Autumn Conference, 2005.
  2. M. R. Ryu, H. J. PARK, B. H. KIM, J. H. KIM, D.H. LEE, S.B. LEE, "Optimization of Bevel Gear Injection mold Using Taguchi Design", Jou. of Korean Soc. of Mechanical Technology, Vol. 11(3) 2010.
  3. Suzanne L. B. Woll, Duglas J. Cooper and Blair V. Souder, "Online Pattern-Beased Part Quality monitoring of the Injection Molding Process," Polymer Eng. & Sci., Mid-jun, Vol. 36, No. 11, 1996.
  4. V. Leo and Ch. Cuvelliez, "The Effect of the Parking Parameters, Gate Geometry, And Mold Elasticity on the Final Dimensions of a Molded Part," Polymer Eng. & Sci., Mid-August, Vol. 36, No. 15, 1996.
  5. C. Y. Zhang, J. Leonard and R. g. Speight, "Adaptive Controller Performance Used for Ram Velocity Control during Filling Phase," Byeong- Hyeon Min, "An Analysis of Shrinkge of Injection Molded part Based on the GMDH Alhorithm," J. of injection Molding Tech., Dec., Vol1, No. 4, 1997.
  6. D. Yao, "Diract Search-Based Automatic Minimization of Warpage and Weldlines in Injection Molded Parts", Masters Thesis, University of Massachusetts, MA., pp.80-88, 1998.
  7. 박성현, "현대실험계획법," 민영사, 제 13권, 2002.