IE interfaces (산업공학)

Korean Institute of Industrial Engineers (대한산업공학회)
권호 표지
DOI QR코드

DOI QR Code

A Case Study of an Optimum Lot Size of Press Line

프레스 라인 적정 로트 크기의 결정에 관한 사례 연구

  • Kim, Yearn-Min (Department of Industrial Engineering, University of Ulsan)
  • 김연민 (울산대학교 산업경영공학부)
  • Received : 2010.06.08
  • Accepted : 2011.05.16
  • Published : 2011.09.01
Download PDF
⟨ Previous Next ⟩

Abstract

This paper develops a mathematical model which searches an optimum lot size of a press line, and applies this model to the scheduling of the press line. This mathematical model is not a widely studied cost model but a model which considers the utilization of the press line under a lean production system. In this paper, the optimum lot size is a minimum lot size which does not exceed the total work time of the press line. A production volume and the priority of the production in the press line are adjusted using this optimum lot size. A mathematical model developed in this paper will allow determining the optimum lot size easily in case of variable production environments such as an introduction of a new product and a fluctuation of production volume of each item. Therefore, our model will make a better scheduling of the press line and will enhance the utilization of it.

Keywords

References

  1. Askin, R. G. and Goldberg, J. B. (2002), Design and Analysis of Lean Production Systems, Wiley.
  2. Ha, Y. H., U, S. B., An, H. S., Han, H. S., and Park, Y. J. (2003), An Implementation of the Production Sequence Module in Automobile Production Scheduling Sysemm using Constraint Satisfaction Method, IE Interface, 16(3).
  3. Hopp and Spearman (2000), Factory Physics, 2nd, Ed., McGrawHill.
  4. Jans, R. and Degraeve, Z. (2008), Modeling industrial lot sizing problems : a review, International Journal of Production Research, 46(6), 1619-1643. https://doi.org/10.1080/00207540600902262
  5. Jamshidi, H. (2005), Lean Manufacturing and Formation of Production Cycles with the Wagner-Whitin Algorithm, The Journal of Global Business Issues, 3(1).
  6. Moon, S., .U, Sun, J. W., Lee, S.,Cha, C. N., Han, K. H., Hong, S. P., and Hwang, H. (1996), Production Planning and Scheduling System Development for Vehicle Side Frame Process, IE Interface, 9(2).
  7. Robinson, Powell, Arunachalam Narayanan, Funda Sahin (2009), Coordinated deterministic dynamic demand lot-sizing problem : A review of models and algorithms, Omega, 37, 3-15. https://doi.org/10.1016/j.omega.2006.11.004
  8. Shmanske, S. (2003), JIT and the Complementarity of Buffers and Lot Size, American Business Review, 21(1), 100-106.
  9. Zangwill, W. I. (1987), From EOQ towards ZI, Management Science, 33(10), 1216-1223.