Transactions of the Korean hydrogen and new energy society (한국수소및신에너지학회논문집)

The Korean Hydrogen and New Energy Society (한국수소및신에너지학회)
권호 표지
DOI QR코드

DOI QR Code

Numerical Studies of a Separator for Stack Temperature Control in a Molten Carbonate Fuel Cell

용융탄산염 연료전지 스택 온도 조절을 위한 분리판에 관한 수치 해석 연구

  • Received : 2011.04.05
  • Accepted : 2011.06.20
  • Published : 2011.06.30
Download PDF
⟨ Previous Next ⟩

Abstract

The use of a separator to control stack temperature in a molten carbonate fuel cell was studied by numerical simulation using a computational fluid dynamics code. The stack model assumed steady-state and constant-load operation of a co-flow stack with an external reformer at atmospheric pressure. Representing a conventional cell type, separators with two flow paths, one each for the anode and cathode gas, were simulated under conditions in which the cathode gas was composed of either air and carbon dioxide (case I) or oxygen and carbon dioxide (case II). The results showed that the average cell potential in case II was higher than that in case I due to the higher partial pressures of oxygen and carbon dioxide in the cathode gas. This result indicates that the amount of heat released during the electrochemical reactions was less for case II than for case I under the same load. However, simulated results showed that the maximum stack temperature in case I was lower than that in case II due to a reduction in the total flow rate of the cathode gas. To control the stack temperature and retain a high cell potential, we proposed the use of a separator with three flow paths (case III); two flow paths for the electrodes and a path in the center of the separator for the flow of nitrogen for cooling. The simulated results for case III showed that the average cell potential was similar to that in case II, indicating that the amount of heat released in the stack was similar to that in case II, and that the maximum stack temperature was the lowest of the three cases due to the nitrogen gas flow in the center of the separator. In summary, the simulated results showed that the use of a separator with three flow paths enabled temperature control in a co-flow stack with an external reformer at atmospheric pressure.

Keywords

References

  1. Y. Mugikura, J. Hoffmann, C. Y. Yuh, and J. A. Godula, and M. Farooque, "Molten carbonate fuel cells and systems", Handbook of Fuel Cells, Version 4, 2003, p. 905.
  2. S. Freni, S. Cavallaro, D. Ravida, and N. Giordano, "Lifetime-limiting factors for a molten carbonate fuel cell", Int. J. Hydrogen Energy, Vol. 19, 1994, p. 337. https://doi.org/10.1016/0360-3199(94)90065-5
  3. M. Farooque, S. Katikaneni, and H. C. Maru, "The Direct Carbonate Fuel Cell Technology and Products Review", Carbonate Fuel Cell Technology V, Electrochemical Society, Pennington, NJ, 1999, p. 47.
  4. www.fuelcellenergy.com.
  5. P. Greppi, B. Bosio, and E. Arato, "Feasibility of the integration of a molten carbonate fuel-cell system and an integrated gasification combined cycle", Int. J. Hydrogen Energy, Vol. 34, 2009, p. 8664. https://doi.org/10.1016/j.ijhydene.2009.08.012
  6. J. H. Koh, B. S. Kang, and H. C. Lim, "Effect of various stack parameters on temperature rise in molten carbonate fuel cell stack operation", J. Power Source, Vol. 91, 2000, p. 161. https://doi.org/10.1016/S0378-7753(00)00463-8
  7. J. H. Koh and B. S. Kang, "Theoretical study of a molten carbonate fuel cell stack for pressurized operation", Int. J. Energy Research, Vol. 25, 2001, p. 621. https://doi.org/10.1002/er.709
  8. 강승원, 김범주, 김도형, 이정현, 김의환, 임희천, "75kW MCFC 스택 운전 결과", 한국수소 및 신에너지학회 논문집, Vol. 20, No. 3, 2009, p. 202.
  9. J. H. Koh, B. S. Kang, and H. C. Lim, "Analysis of temperature and pressure fields in molten carbonate fuel cell stacks", AIChE. J., Vol. 47, 2001, p. 1941. https://doi.org/10.1002/aic.690470906
  10. C. Y. Yuh and J. R. Selman, "The polarization of molten carbonate fuel cell electrodes", J. Electrochem. Soc., Vol. 138, 1991, p. 3642. https://doi.org/10.1149/1.2085473
  11. 김도형, 김범주, 이정현, 강승원, 임희천, "전기부하에 따른 용융탄산염 연료전지 스택 온도 분포에 관한 수치해석연구", 한국수소 및 신에너지학회 논문집, Vol. 21, No. 4, p. 258.