Earthquakes and Structures

  • 제2권2호
  • /
  • Pages.189-206
  • /
  • 2011
  • /
  • 2092-7614(pISSN)
  • /
  • 2092-7622(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

System identification of highway bridges from ambient vibration using subspace stochastic realization theories

  • Ali, Md. Rajab (Graduate School of Science and Technology, Nagasaki University) ;
  • Okabayashi, Takatoshi (Department of Civil Engineering, Faculty of Engineering, Nagasaki University)
  • 투고 : 2010.09.02
  • 심사 : 2010.12.14
  • 발행 : 2011.06.25
⟨ 이전 논문 다음 논문 ⟩

초록

In this study, the subspace stochastic realization theories (SSR model I and SSR model II) have been applied to a real bridge for estimating its dynamic characteristics (natural frequencies, damping constants, and vibration modes) under ambient vibration. A numerical simulation is carried out for an arch-type steel truss bridge using a white noise excitation. The estimates obtained from this simulation are compared with those obtained from the Finite Element (FE) analysis, demonstrating good agreement and clarifying the excellent performance of this method in estimating the structural dynamic characteristics. Subsequently, these methods are applied to the vibration induced by both strong and weak winds as obtained by remote monitoring of the Kabashima bridge (an arch-type steel truss bridge of length 136 m, and situated in Nagasaki city). The results obtained with this experimental data reveal that more accurate estimates are obtained when strong wind vibration data is used. In contrast, the vibration data obtained from weak wind provides accurate estimates at lower frequencies, and inaccurate accuracy for higher modes of vibration that do not get excited by the wind of lower intensity. On the basis of the identified results obtained using both simulated data and monitored data from a real bridge, it is determined that the SSR model II realizes more accurate results than the SSR model I. In general, the approach investigated in this study is found to provide acceptable estimates of the dynamic characteristics of highway bridges as well as for the vibration monitoring of bridges.

키워드

참고문헌

  1. Abdelghani, M., Verhaegen, M., Overschee, P.V. and Moor, B.D. (2001), "Comparison study of subspace identification methods applied to flexible structures", Mech. Syst. Signal Pr., 12(5), 679-692.
  2. Akaike, H. (1976), Canonical correlation analysis of time series and the use of an information criterion, in system identification, Advanced Case study (R. Mehra and D. Lainiotis,eds.), Academic, 27-96.
  3. Aoki, M. (1987), State space modeling of time series, Springer-Verlag, NewYork.
  4. Basseville, M., Benveniste, A., Goursat, M., Hermans, L., Mevel, L. and Van der Auweraer, H. (2001), "Output only subspace-based structural identification: from theory to industrial testing practice", Trans. - ASME, 123, 668-676.
  5. Carden, E.P. and Brownjohn, M.W. (2008), "ARMA modeled time-series classification for structural health monitoring of civil structure", Mech. Syst. Signal Pr., 22, 295-314. https://doi.org/10.1016/j.ymssp.2007.07.003
  6. Desai, U.B., Pal, D. and Kirkpatrik, R.D. (1985), "A realization approach to stochastic model reduction", Int. J. Control, 42(4), 821-839. https://doi.org/10.1080/00207178508933398
  7. Gevers, A. (2006), "A personal view on the development of system identification a 30-year journey through an exciting field", IEEE Contr. Syst. Mag., 26(6) 93-105.
  8. Garibaldi, L., Giotrcelli, E. and Piombo, B.A.D. (1998), "ARMAV techniques for traffic excited bridges", J. Vib. Accoust. - ASME, 120, 713-718. https://doi.org/10.1115/1.2893888
  9. Jimin, H. and Zhi-Fang, F. (2001), Modal analysis, Butterworth-Heinemann, Englewood cliffs, NJ.
  10. Juang, J.N. (1994), Applied System Identification, Prentice Hall PTR, Upper saddle River, NJ.
  11. Juang, J.N., Cooper, J.E. and Pappa, R.S. (1985), "An eigensystem realization algorithm for modal parameter identification and model reduction", J. Guid. Control Dyn., 8(5), 620-627. https://doi.org/10.2514/3.20031
  12. Katayama, T. (2005), Subspace methods for system identification, Springer Verlag, Berlin.
  13. Moustafa, A., Mahadevan, S., Daigle, M. and Biswas, G. (2010), "Structural and sensor damage identification using the bond graph approach", Struct. Control Health Monit., 17, 178-197. https://doi.org/10.1002/stc.285
  14. Nagayama, T., Abe, M., Fujino, Y., and Ikeda, K. (2005), "Structural identification of non proportionally damped system and its application to full-scale suspension bridge", J. Struct. Eng., 131(10), 1536-1545. https://doi.org/10.1061/(ASCE)0733-9445(2005)131:10(1536)
  15. Overschee, P.V. and Moor, B.D. (1996), Subspace identification for linear systems, Kluwer Academic Publishers, U.S.A.
  16. Papakos, V. and Fassois, S.D. (2003), "Multichannel identification of aircraft skeleton structures under unobservable excitation, A vector AR/ARMA framwok", Mech. Syst. Signal Pr., 17(6), 1271-1290. https://doi.org/10.1006/mssp.2002.1575
  17. Peeters, B. and Roeck, G.D. (2001), "Stochastic system identification for operational modal analysis: a review", J. Dyn. Syst. Measure. Control, 123, 659-667. https://doi.org/10.1115/1.1410370
  18. Reyenders, E. and Roeck, G.D. (2008), "Reference-based combined deterministic-stochastic subspace identificationfor experimental and operational modal analysis", Mech. Syst. Signal Pr., 22, 617-637. https://doi.org/10.1016/j.ymssp.2007.09.004
  19. Sohn, H., Farrar, C.R., Hemez, F.M., Shunk, D.D., Stinemates, D.W. and Nadler, B.R. (2003), "A review of structural health monitoring literature: 1996-2001", Los Alamos National Lab., Report LA-13976-MS.
  20. Sirinngoringo, D.M. and Fujino, Y. (2008), "System identification of suspension bridge from ambient vibration response", Eng. Struct., 30(2), 462-477. https://doi.org/10.1016/j.engstruct.2007.03.004
  21. Takewaki, I. and Nakamura, M. (2005), "Stiffness-damping simultaneous identification user limited observation", J. Eng. Mech. - ASCE, 131(10), 1027-1035. https://doi.org/10.1061/(ASCE)0733-9399(2005)131:10(1027)

피인용 문헌

  1. Identifying the stiffness parameters of a structure using a subspace approach and the Gram–Schmidt process in a wavelet domain vol.9, pp.7, 2017, https://doi.org/10.1177/1687814017707649
  2. Identifying the Modal Parameters of a Structure from Ambient Vibration Data via the Stationary Wavelet Packet vol.29, pp.10, 2014, https://doi.org/10.1111/mice.12115
  3. Automated data interpretation for practical bridge identification vol.46, pp.3, 2013, https://doi.org/10.12989/sem.2013.46.3.433
  4. A study on Gabor frame for estimating instantaneous dynamic characteristics of structures vol.19, pp.1, 2017, https://doi.org/10.21595/jve.2016.17894
  5. Ambient vibration testing of existing buildings: Experimental, numerical and code provisions vol.10, pp.4, 2018, https://doi.org/10.1177/1687814018772718
  6. Time and frequency domain identification of seismically isolated structures: advantages and limitations vol.3, pp.3, 2012, https://doi.org/10.12989/eas.2012.3.3_4.249
  7. Dynamic analysis of a cable-stayed bridge using continuous formulation of 1-D linear member vol.3, pp.3, 2011, https://doi.org/10.12989/eas.2012.3.3_4.271
  8. Influence of some relevant parameters in the seismic vulnerability of RC bridges vol.3, pp.3, 2011, https://doi.org/10.12989/eas.2012.3.3_4.365
  9. Some properties of the Green's function of simplified elastodynamic problems vol.3, pp.3, 2011, https://doi.org/10.12989/eas.2012.3.3_4.507
  10. Damping identification procedure for linear systems: mixed numerical-experimental approach vol.4, pp.2, 2011, https://doi.org/10.12989/eas.2013.4.2.203