DOI QR코드

DOI QR Code

Shake-table responses of a low-rise RC building model having irregularities at first story

  • Lee, Han Seon (School of Civil, Environmental, and Architectural Engineering, Korea University) ;
  • Jung, Dong Wook (Structural Engineer, OPUS PEARL Co.) ;
  • Lee, Kyung Bo (School of Civil, Environmental, and Architectural Engineering, Korea University) ;
  • Kim, Hee Cheul (Department of Architectural Engineering, Kyunghee University) ;
  • Lee, Kihak (Department of Architectural Engineering, Sejong University)
  • 투고 : 2011.02.08
  • 심사 : 2011.10.11
  • 발행 : 2011.11.25

초록

This paper presents the seismic responses of a 1:5-scale five-story reinforced concrete building model, which represents a residential apartment building that has a high irregularity of weak story, soft story, and torsion simultaneously at the ground story. The model was subjected to a series of uni- and bi-directional earthquake simulation tests. Analysis of the test results leads to the following conclusions: (1) The model survived the table excitations simulating the design earthquake with the PGA of 0.187 g without any significant damages, though it was not designed against earthquakes; (2) The fundamental mode was the torsion mode. The second and third orthogonal translational modes acted independently while the torsion mode showed a strong correlation with the predominant translational mode; (3) After a significant excursion into inelastic behavior, this correlation disappeared and the maximum torsion and torsion deformation remained almost constant regardless of the intensity of the two orthogonal excitations; And, (4) the lateral resistance and stiffness of the critical columns and wall increased or decreased significantly with the large variation of acting axial forces caused by the high bi-directional overturning moments and rocking phenomena under the bi-directional excitations.

키워드

과제정보

연구 과제 주관 기관 : National Research Foundation of Korea

참고문헌

  1. American Society of Civil Engineers (2006), ASCE/SEI 41-06, Seismic Rehabilitation of Existing Building, Reston, VA.
  2. Architectural Institute of Korea (2005), Korean Building Code (KBC2005), Seoul, Korea. (in Korean)
  3. Bousias, S.N., Fardis, M.N., Spathis, A.L. and Kosmopoulos, A.J. (2007), "Pseudo-dynamic response of torsionally unbalanced two storey test structure", Earthq. Eng. Struct. D., 36(8), 1065-1087. https://doi.org/10.1002/eqe.672
  4. Bracci, J.M., Reinhorn, A.M. and Mander, J.B. (1995), "Seismic resistance of reinforced concrete frame structures designed for gravity loads: performance of structural system", ACI Struct. J., 92(5), 597-609.
  5. Del La LLera, J.C. and Chopra, A.K. (1995), "Understanding the inelastic seismic behavior of asymmetric-plan buildings", Earthq. Eng. Struct. D., 24, 549-572. https://doi.org/10.1002/eqe.4290240407
  6. FEMA (2000), "Pre-standard and commentary for the seismic rehabilitation of buildings", Rep. No. FEMA-356, Federal Emergency Management Agency, Washington, D.C.
  7. Fukuta, T., Kabeyasawa, T., Kuramoto, H. and Sanada, Y. (2001), "Shaking table tests and design analysis of a wall frame structure with soft first story", Proceedings of the 4th International Symposium on Earthquake Engineering for the Moderate Seismicity Regions, Seoul, Korea.
  8. Harris, H.G. and Sabnis, G.M. (1999), Structural Modeling and Experimental Techniques, CRC Press, Boca Raton, FL.
  9. Hashemi, A. and Mosalam, K.M. (2006), "Shake table experiment on reinforced concrete structure containing masonry infill wall", Earthq. Eng. Struct. D., 35(14), 1827-1852. https://doi.org/10.1002/eqe.612
  10. Hosoya, H., Abe, I., Kitagawa, Y. and Okada, T. (1995), "Shaking table tests of three dimensional scale models of reinforced concrete high rise frame structures with wall columns", ACI Struct. J., 92(6), 765-780.
  11. International Code Council (2000), International Building Code, Falls church, VA.
  12. Jung, D.W. (2010), "Earthquake simulation tests on a 1:5 scale piloti type low rise RC residential building model", Master Thesis, Korea University, Seoul, Korea. (in Korean)
  13. Kang, T.H.K. (2004), "Shake table tests and analytical studies of reinforced concrete flat plate frames and post tensioned flat plate frames", Ph.D thesis, Univ. of California, Los Angeles.
  14. Ko, D.W. and Lee, H.S. (2006), "Shaking table tests on a high-rise RC building model having torsional eccentricity in soft lower storeys", Earthq. Eng. Struct. D., 35, 1425-1451. https://doi.org/10.1002/eqe.590
  15. Lee, H.S. and Woo, S.W. (1998), An Experimental Study on the Similitude in Structural Behaviors for Smallscale Modeling of Reinforced Concrete Structures, Paper No. 308, 6th U.S. National Conference on Earthquake Engineering, Seattle, USA.
  16. Lee, H.S. and Woo, S.W. (2002), "Effect of masonry infills on seismic performance of a 3 storey R/C frame with non seismic detailing", Earthq. Eng. Struct. D., 31(2), 353-378. https://doi.org/10.1002/eqe.112
  17. Lee, H.S. (2010), "Seismic performance evaluation and retrofit of piloti-type low-rise RC apartment buildings", Final Research Report, National Research Foundation of Korea, Korea. (in Korean)
  18. Di Ludovico, M., Manfredi, G., Mola, E., Negro, P. and Prota, A. (2008), "Seismic behavior of a full scale RC structure retrofitted using GFRP laminates", J. Struct. Eng., 134(5), 810-821. https://doi.org/10.1061/(ASCE)0733-9445(2008)134:5(810)
  19. Paulay, T. (2001), "Some design principles relevant to torsional phenomena in ductile buildings", J. Earthq. Eng., 5(3), 273-308.
  20. Rutenberg, A. (1992), "Nonlinear response of asymmetric building structures: a state of the art review", Nonlinear Seismic Analysis and Design of Reinforced Concrete Buildings, Eds. Fajfar, P. and Krawinkler, H., Elsevier Applied Science, Amsterdam.
  21. Wu, C.L., Kuo, W.W., Yang, Y.S., Hwang, S.J., Elwood, K.J., Loh, C.H. and Moehle, J.P. (2009), "Collapse of nonductile concrete frame: shaking table tests", Earthq. Eng. Struct. D., 38, 205-224. https://doi.org/10.1002/eqe.853
  22. Zhao, B., Taucer, F. and Rossetto, T. (2009), "Field investigation on the performance of building structures during the 12 May 2008 Wenchuan earthquake in China", Eng. Struct., 31(8), 1707-1723. https://doi.org/10.1016/j.engstruct.2009.02.039

피인용 문헌

  1. Comparative investigation of the costs and performances of torsional irregularity structures under seismic loading according to TEC vol.14, pp.4, 2014, https://doi.org/10.12989/cac.2014.14.4.405
  2. Torsion design implications from shake-table responses of an RC low-rise building model having irregularities at the ground story vol.44, pp.6, 2015, https://doi.org/10.1002/eqe.2492
  3. The effect of flexibility in ground storey of concrete walls and infilled frames on their seismic response vol.45, pp.4, 2014, https://doi.org/10.1002/mawe.201400224
  4. Limit states of RC structures with first floor irregularities vol.47, pp.6, 2013, https://doi.org/10.12989/sem.2013.47.6.791
  5. Least Favorable Probability of Failure for 5- and 10-story RC Frame Structures with Vertical Irregularities vol.19, pp.7, 2015, https://doi.org/10.1080/13632469.2015.1025315
  6. Investigation of the effect of weak-story on earthquake behavior and rough construction costs of RC buildings vol.16, pp.1, 2015, https://doi.org/10.12989/cac.2015.16.1.141
  7. Shake table responses of an RC low-rise building model strengthened with buckling restrained braces at ground story vol.5, pp.6, 2013, https://doi.org/10.12989/eas.2013.5.6.703
  8. Seismic Damage to RC Low-rise Building Structures Having Irregularities at the Ground Story During the 15 November 2017 Pohang, Korea, Earthquake vol.22, pp.3, 2018, https://doi.org/10.5000/EESK.2018.22.3.103
  9. Determination of torsional irregularity in response spectrum analysis of building structures vol.74, pp.5, 2011, https://doi.org/10.12989/sem.2020.74.5.699
  10. Estimation of elastic seismic demands in TU structures using interactive relations between shear and torsion vol.19, pp.1, 2011, https://doi.org/10.12989/eas.2020.19.1.59