Structural Engineering and Mechanics

  • 제40권4호
  • /
  • Pages.471-488
  • /
  • 2011
  • /
  • 1225-4568(pISSN)
  • /
  • 1598-6217(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Simulation of vibrations of Ting Kau Bridge due to vehicular loading from measurements

  • Au, F.T.K. (Department of Civil Engineering, The University of Hong Kong) ;
  • Lou, P. (Department of Civil Engineering, The University of Hong Kong) ;
  • Li, J. (Department of Civil Engineering, The University of Hong Kong) ;
  • Jiang, R.J. (Department of Civil Engineering, The University of Hong Kong) ;
  • Zhang, J. (Department of Civil Engineering, The University of Hong Kong) ;
  • Leung, C.C.Y. (Department of Civil Engineering, The University of Hong Kong) ;
  • Lee, P.K.K. (Department of Civil Engineering, The University of Hong Kong) ;
  • Lee, J.H. (Department of Civil Engineering, The University of Hong Kong) ;
  • Wong, K.Y. (Bridges and Structures Division, Highways Department, The Government of the Hong Kong Special Administrative Region) ;
  • Chan, H.Y. (Bridges and Structures Division, Highways Department, The Government of the Hong Kong Special Administrative Region)
  • 투고 : 2010.12.15
  • 심사 : 2011.08.18
  • 발행 : 2011.11.25
⟨ 이전 논문 다음 논문 ⟩

초록

The Ting Kau Bridge in Hong Kong is a cable-stayed bridge comprising two main spans and two side spans. The bridge deck is supported by three towers, an end pier and an abutment. Each of the three towers consists of a single reinforced concrete mast strengthened by transverse cables and struts. The bridge deck is supported by four inclined planes of cables emanating from anchorages at the tower tops. In view of the heavy traffic on the bridge, and threats from typhoons and earthquakes originated in areas nearby, the dynamic behaviour of long-span cable-supported bridges in the region is always an important consideration in their design. Baseline finite element models of various levels of sophistication have been built not only to match the bridge geometry and cable forces specified on the as-constructed drawings but also to be calibrated using the vibration measurement data captured by the Wind and Structural Health Monitoring System. This paper further describes the analysis of axle loading data, as well as the generation of random axle loads and simulation of vibrations of the bridge using the finite element models. Various factors affecting the vehicular loading on the bridge will also be examined.

키워드

참고문헌

  1. Au, F.T.K., Jiang, R.J., Leung, C.C.Y., Xie, L.Z., Lee, P.K.K., Wong, K.Y. and Chan, W.Y. (2007), "Development and calibration of finite element models for structural health monitoring of Ting Kau Bridge", Invited Lecture, Proceedings of International Symposium on Environmental Vibrations (ISEV 2007), Taipei, Taiwan, November.
  2. Au, F.T.K., Tham, L.G., Lee, P.K.K., Su, C., Han, D.J., Yan, Q.S. and Wong, K.Y. (2003), "Ambient vibration measurements and finite element modelling for the Hong Kong Ting Kau Bridge", Struct. Eng. Mech., 15(1), 115-134. https://doi.org/10.12989/sem.2003.15.1.115
  3. Au, F.T.K., Wang, J.J. and Cheung, Y.K. (2002), "Impact study of cable-stayed railway bridges with random rail irregularities", Eng. Struct., 24(5), 529-541. https://doi.org/10.1016/S0141-0296(01)00119-5
  4. Bickel, P.J. and Doksum, K.A. (2001), Mathematical Statistics: Basic Ideas and Selected Topics, Vol. 1, 2nd Edition, Prentice-Hall Inc., New Jersey.
  5. British Standards Institution (1980), BS5400: Part 10, Steel, Concrete and Composite Bridges - Code of Practice for Fatigue, London.
  6. Chang, T.P., Liu, M.F. and O, H.W. (2009), "Vibration analysis of a uniform beam traversed by a moving vehicle with random mass and random velocity", Struct. Eng. Mech., 31(6), 737-749. https://doi.org/10.12989/sem.2009.31.6.737
  7. Coussy, O., Said, M. and Vanhoove, J.P. (1989), "The influence of random surface irregularities on the dynamic response of bridges under suspended moving loads", J. Sound Vib., 130(2), 313-320. https://doi.org/10.1016/0022-460X(89)90556-7
  8. Jo, J.S., Jung, H.J. and Kim, H. (2008), "Finite element analysis of vehicle-bridge interaction by an iterative method", Struct. Eng. Mech., 30(2), 165-176. https://doi.org/10.12989/sem.2008.30.2.165
  9. Law, S.S. and Zhu, X.Q. (2005), "Bridge dynamic responses due to road surface roughness and braking of vehicle", J. Sound Vib., 282(3-5), 805-830. https://doi.org/10.1016/j.jsv.2004.03.032
  10. Lee, C.H., Kawatani, M., Kim, C.W., Nishimura, N. and Kobayashi, Y. (2006), "Dynamic response of a monorail steel bridge under a moving train", J. Sound Vib., 294(3), 562-579. https://doi.org/10.1016/j.jsv.2005.12.028
  11. Li, Q., Xu, Y.L., Wu, D.J. and Chen, Z.W. (2010), "Computer-aided nonlinear vehicle-bridge interaction analysis", J. Vib. Control, 16(12), 1791-1816. https://doi.org/10.1177/1077546309341603
  12. Kawatani, M., Kobayashi, Y. and Takamori, K. (1998), "Non-stationary random analysis with coupling vibration of bending and torsion of simple girder-bridge under moving vehicles", Struct. Eng. Earthq. Eng., 15(1), 107-114.
  13. Kwasniewski, L. and Li, H.Y. (2006), "Finite element analysis of vehicle-bridge interaction", Finite Elem. Anal. Des., 42(11), 950-959. https://doi.org/10.1016/j.finel.2006.01.014
  14. Song, M.K. and Choi, C.K. (2002), "Analysis of high-speed vehicle-bridge interactions by a simplified 3-D model", Struct. Eng. Mech., 13(5), 505-532. https://doi.org/10.12989/sem.2002.13.5.505
  15. Song, M.K. and Fujino, Y. (2008), "Dynamic analysis of guideway structures by considering ultra high-speed Maglev train-guideway interaction", Struct. Eng. Mech., 29(4), 355-380. https://doi.org/10.12989/sem.2008.29.4.355
  16. The University of Hong Kong (2000), Ting Kau Bridge: Ambient Vibration Measurement of Complete Bridge, Report Prepared for the Bridges and Structures Division, Highways Department, Government of the Hong Kong Special Administrative Region.
  17. The University of Hong Kong (2007), Ting Kau Bridge: 3D Finite Element Grid Beam Model of the Global Bridge Structure, Report Prepared for the Bridges and Structures Division, Highways Department, Government of the Hong Kong Special Administrative Region.
  18. Wang, T.L. and Huang, D.Z. (1992), "Cable-stayed bridge vibration due to road surface roughness", J. Struct. Eng.-ASCE, 118(5), 1354-1373. https://doi.org/10.1061/(ASCE)0733-9445(1992)118:5(1354)
  19. Wiriyachai, A., Chu, K.H. and Garg, V.K. (1982), "Bridge impact due to wheel and track irregularities", J. Eng. Mech.-ASCE, 108(4), 648-666.
  20. Wu, Y.S. and Yang, Y.B. (2003), "Steady-state response and riding comfort of trains moving over a series of simply supported bridges", Eng. Struct., 25(2), 251-265. https://doi.org/10.1016/S0141-0296(02)00147-5
  21. Yang, Y.M., Pan, J.Y. and Cheng, Q.G. (1995), "Theoretical and experimental studies of the dynamic response of long span railway bridge (in Chinese)", China Railway Science, 16(4), 1-15.
  22. Yang, Y.B. and Lin, C.W. (2005), "Vehicle bridge interaction dynamics and potential applications", J. Sound Vib., 284(1-2), 205-226. https://doi.org/10.1016/j.jsv.2004.06.032

피인용 문헌

  1. A framework for carrying out train safety evaluation and vibration analysis of a trussed-arch bridge subjected to vessel collision vol.59, pp.4, 2016, https://doi.org/10.12989/sem.2016.59.4.683
  2. Statistical analysis of modal parameters of a suspension bridge based on Bayesian spectral density approach and SHM data vol.98, 2018, https://doi.org/10.1016/j.ymssp.2017.05.005
  3. Effect of baseline calibration on assessment of long-term performance of cable-stayed bridges vol.35, 2013, https://doi.org/10.1016/j.engfailanal.2013.01.031
  4. Dynamic analysis of coupled train - ladder track - elevated bridge system vol.47, pp.5, 2013, https://doi.org/10.12989/sem.2013.47.5.661
  5. Performance study on the whole vibration process of a museum induced by metro vol.55, pp.2, 2015, https://doi.org/10.12989/sem.2015.55.2.413
  6. Improved block-wise MET for estimating vibration fields from the sensor vol.64, pp.3, 2011, https://doi.org/10.12989/sem.2017.64.3.279
  7. Finite element model updating of long-span cable-stayed bridge by Kriging surrogate model vol.74, pp.2, 2011, https://doi.org/10.12989/sem.2020.74.2.157