DOI QR코드

DOI QR Code

Strengthening of deficient RC frames with high strength concrete panels: an experimental study

  • Baran, Mehmet (Department of Civil Engineering, Kirikkale University) ;
  • Susoy, Melih (OM Engineering Services, Inc.) ;
  • Tankut, Tugrul (Department of Civil Engineering, Middle East Technical University)
  • 투고 : 2010.02.08
  • 심사 : 2010.09.25
  • 발행 : 2011.01.25

초록

An economic, structurally effective and practically applicable strengthening technique was developed for reinforced concrete (RC) framed buildings. The idea of the technique is to convert the existing hollow brick infill wall into a load carrying system acting as a cast-in-place RC infill wall by bonding relatively thin high strength precast concrete PC panels to the plastered hollow brick infill. For this purpose, a total of eight one-third scale, one bay, one story frames were tested under reversed-cyclic lateral loads. Test frames were designed and constructed with common deficiencies observed in practice. Four different panel types were used for strengthening. Test results showed that both strength and stiffness of the frames were significantly improved by the introduction of PC panels. Experimental results were compared with the analytical approaches suggested by the authors.

키워드

참고문헌

  1. Altin, S., Ersoy, U. and Tankut, T. (1992), "Hysteretic response of reinforced concrete infilled frames", J. Struct. Eng.-ASCE, 118(8), 2133-2150. https://doi.org/10.1061/(ASCE)0733-9445(1992)118:8(2133)
  2. Baran, M., Duvarci, M., Tankut, T., Ersoy, U. and Ozcebe, G. (2003), "Occupant friendly seismic retrofit (OFR) of RC framed buildings", Seismic Assessment and Rehabilitation of Existing Buildings, Nato Science Series, IV, Earth and Environmental Series, 29, 433-456.
  3. Baran, M., Canbay, E. and Tankut, T. (2010), "Seismic strengthening with precast concrete panels-theoretical approach", UCTEA, Turkish Chamber of Civil Engineers, Tech. J., 21(2), 4959-4978. (in Turkish)
  4. Canbay, E., Ersoy, U. and Ozcebe, G. (2003), "Contribution of RC infills to the seismic behavior of structural system", ACI Struct. J., 100(5), 637-643.
  5. Canbay, E. and Frosch, R.J. (2005), "Bond strength of lap-spliced bars", ACI Struct. J., 102(4), 605-614.
  6. Cho, C.G., Ha, G.J. and Kim, Y.Y. (2008), "Nonlinear model of reinforced concrete frames retrofitted by in-filled HPFRCC walls", Struct. Eng. Mech., 30(2), 211-223. https://doi.org/10.12989/sem.2008.30.2.211
  7. Ersoy, U. and Uzsoy, S. (1971), "The behavior and strength of infilled frame", TUBITAK MAG-205 Report, Ankara, Turkey. (in Turkish)
  8. Federal Emergency Management Agency (FEMA) 306 (1998), Evaluation of Earthquake Damaged Concrete and Masonry Wall Buildings.
  9. Frosch, R.J. (1996), "Seismic rehabilitation using precast infill walls", Ph.D. Dissertation, Department of Civil Engineering, The University of Texas at Austin.
  10. Frosch, R.J., Li, W., Jirsa, J.O. and Kreger, M.E. (1996), "Retrofit of non-ductile moment-resisting frames using precast infill wall panels", Earthq. Spectra, 12(4), 741-760. https://doi.org/10.1193/1.1585908
  11. Frosch, R.J., Li, W., Kreger, M.E. and Jirsa, J.O. (1996), "Seismic strengthening of a nonductile RC frame using precast infill panels", Proceedings of the Eleventh World Conference on Earthquake Engineering, Acapulco, Mexico.
  12. Frosch, R.J. (1999), "Panel connections for precast concrete infill walls", ACI Struct. J., 96(4), 467-474.
  13. Frosch, R.J., Jirsa, J.O. and Kreger, M.E. (2003), "Experimental response of a precast infill wall system", Seismic Assessment and Rehabilitation of Existing Buildings, Nato Science Series, IV, Earth and Environmental Series, 29, 383-406.
  14. Gregorian, Z.B. and Gregorian, G.B. (1996), "Seismic upgrading of hospital building No. 6 and 7, VA Medical Center, Bedford, Mass", Seismic Rehabilitation of Concrete Structures, SP-160, ACI, Farmington Hills, MI, 131-147.
  15. Hanson, R.D. (1980), "Repair and strengthening of buildings", Proceedings of the 7th WCEE, Istanbul, Turkey, 9, 71-74.
  16. Higashi, Y., Endo, T., Ohkubo, M. and Shimizu, Y. (1980), "Experimental study on strengthening reinforced concrete structure by adding shear wall", Proceedings of the 7th WCEE, Istanbul, Turkey, 7, 173-180.
  17. Higashi, Y., Endo, T. and Shimizu, Y. (1984), "Experimental studies on retrofitting of reinforced concrete building frames", Proceedings of the 8th World Conference on Earthquake Engineering, San Francisco CA., 1, 477-484.
  18. Isao, M., Hiroshi, T. and Ryoji, H.A. (1999), "Seismic strengthening method for existing R/C buildings by shear walls installed precast concrete panel", Jpn. Sci. Tech. Ag., 37(11), 20-26.
  19. Kahn, L.F. and Hanson, R.D. (1979), "Infilled walls for earthquake strengthening", Proc., ASCE, 105, 283-296.
  20. Kaldjian, M.J. and Yuzugullu, O. (1983), "Efficiency of bolt connected shear panels to strengthen building structures", Proceedings of the First International Conference on Concrete Technology for Developing Countries, Yarmouk University, Irbid, Jordan, October.
  21. Kesner, K. and Billington, S.L. (2005), "Investigation of infill panels made from engineered cementitious composites for seismic strengthening and retrofit", J. Struct. Eng. ASCE, 131(11), 1712-1720. https://doi.org/10.1061/(ASCE)0733-9445(2005)131:11(1712)
  22. Li, W. (1997), "Experimental evaluation and computer simulation of post tensioned precast infill wall system", Ph.D. Dissertation, Department of Civil Engineering, The University of Texas at Austin.
  23. Matsumoto, T. (1998), "Structural performance of SRC multi-story shear walls with infilled precast concrete panels", JCI, Tokyo.
  24. Miller, J.T. and Reaveley, L.D. (1996), "Historic hotel Utah remodel and seismic upgrade", Seismic Rehabilitation of Concrete Structures, SP-160, ACI, Farmington Hills, MI, 115-130.
  25. Phan, T.L., Cheok, S.G. and Todd, R.D. (1995), "Strengthening methodology for lightly reinforced concrete specimens, recommended guidelines for strengthening with infill walls", Building and Fire Research Laboratory, National Institute of Standards and Technology (NIST), Gaithersburg, MD.
  26. Smith, B.S. (1962), "Lateral stiffness of infilled frames", J. Struct. Div.-ASCE, 88(6), 183-199.
  27. Smith, B.S. (1966), "Behaviour of square infilled frames", J. Struct. Div.-ASCE, 92(1).
  28. Smith, B.S. (1967), "Methods for predicting the lateral stiffness and strength of multi-storey infilled frames", Build. Sci., 2, 247-257. https://doi.org/10.1016/0007-3628(67)90027-8
  29. Smith, B.S. (1968), "Model test results of vertical and horizontal loading of infilled specimens", ACI Struct. J., 618-624.
  30. Smith, B.S. and Carter, C.A. (1969), "Method of analysis for infilled frames", Proc., ICE, 44, 31-48. https://doi.org/10.1680/iicep.1969.7290
  31. Sonuvar, M.O., Ozcebe, G. and Ersoy, U. (2004), "Rehabilitation of reinforced concrete frames with reinforced concrete infills", ACI Struct. J., 101(4), 494-500.
  32. Susoy, M. (2004), "Seismic strengthening of masonry infilled reinforced concrete frames with precast concrete panels", M. Sc. Thesis, Civil Engineering Department, Middle East Technical University, Ankara, Turkey.
  33. Turk, A.M. (1998), "Rehabilitation of reinforced concrete infill walls", Ph. D. Dissertation, Bogazici University, Istanbul, Turkey.
  34. Turkish Seismic Code (2006), Ministry of Public Work and Settlement, Government of Republic of Turkey, Ankara.
  35. Yuzugullu, O. (1979), "Strengthening of reinforced concrete frames damaged by earthquake using precast panel elements", Turkish Scientific and Technical Council, Project No. MAG-494, Ankara, Turkey. (in Turkish)
  36. Zhou, X.T., Ko, J.M. and Ni, Y.Q. (2007), "Experimental study on identification of stiffness change in a concrete frame experiencing damage and retrofit", Struct. Eng. Mech., 25(1), 39-52. https://doi.org/10.12989/sem.2007.25.1.039

피인용 문헌

  1. Experimental investigation of existing R/C frames strengthened by high dissipation steel link elements vol.5, pp.2, 2013, https://doi.org/10.12989/eas.2013.5.2.143
  2. Performance Examination of Two Seismic Strengthening Procedures by Pseudodynamic Testing vol.138, pp.1, 2012, https://doi.org/10.1061/(ASCE)ST.1943-541X.0000434
  3. Experimental study on seismic performance of reinforced concrete frames retrofitted with eccentric buckling-restrained braces (BRBs) vol.12, pp.1, 2011, https://doi.org/10.12989/eas.2017.12.1.079
  4. Strengthening of reinforced concrete frames with engineered cementitious composite panels vol.173, pp.4, 2011, https://doi.org/10.1680/jstbu.18.00001