Journal of the Korea Academia-Industrial cooperation Society (한국산학기술학회논문지)

The Korea Academia-Industrial cooperation Society (한국산학기술학회)
권호 표지
DOI QR코드

DOI QR Code

Improvement of Compression Ignition for Gasoline Fuel Injected in the Diesel Engine

디젤기관에 분사되는 가솔린연료의 압축착화성 향상

  • Received : 2010.10.25
  • Accepted : 2011.01.13
  • Published : 2011.01.31
Download PDF
⟨ Previous Next ⟩

Abstract

In this study, it made to run conventional single direct injection(DI) diesel engine, which adapted bulk combustion system not following spark ignition system without any ignition apparatus. It was heated and controlled inlet-air into conventional single DI diesel engine. The maximum value of brake thermal efficiency was at 35 region of air-fuel ratio. On the contrary, when the region of air-fuel ratio leaner than 35, brake thermal efficiency was decreased suddenly. And brake thermal efficiency was increased as much as inlet-air heating temperature increased. So, when air-fuel ratio was decreased and inlet-air heating temperature was higher, the engine was in optimal operation condition.

본 논문은 기존의 스파크 점화 방식이 아닌 bulk combustion 방식을 도입하여 별도의 점화장치 없이 상용 단기통 디젤기관에 유입되는 흡입공기를 가열 및 제어하여 흡기관에 분사되는 가솔린연료의 압축착화성을 향상시킴으로서 기관작동을 가능하게 하였다. 제동열효율의 최대값은 공기-연료비가 35부근에서 나타나며, 35이상의 영역에서는 급격히 감소하고 흡입공기 가열온도가 올라갈수록 제동열효율은 증가한다. 따라서 공기-연료비를 감소시키면서 흡입공기의 가열온도를 상승시키는 방식이 열효율 측면에서 효과적이라는 것을 알 수 있다.

Keywords

References

  1. Kim, D.S., "A Study of Lean Combustion and Exhaust Emission Characteristics in a SI Engine Fueled with Ethanol According to Air-Fuel Ratio and Ethanol-Gasoline Fuel blending Ratio", Master Thesis, Hanyang University, 2010.
  2. Jun, C.H., "Development of a Methanol Reformulated Gasoline Fuel for Low Emission", Research Paper, Pusan University, 2004.
  3. Seplyarskii, B. S., Brauer, G. B. and Kostin, S. V., "Combustion of bulk density powder mixtures in a coflow of inert gas", Int. J. of self-propagating high-temperatures synthesis, Vol. 17, pp. 199-205, 2008. https://doi.org/10.3103/S1061386208030072
  4. Kim, N.Y., "A Study on the Characterization of SCR System for NOx Reduction of Diesel Engine", Master Thesis, Kyonggi University, 2007.
  5. Thring, R. H., "Homogeneous-charge compression-Ignition (HCCI) engines", SAE No. 892068, 1989.
  6. Taro, A., Yoshiaki, H., and Junichi, M., Yasuo, S., "An Experimental Study on Premixed-Charge Compression Ignition Gasoline Engine", SAE No. 960081, pp. 1-7, 1996.
  7. Magnus, C., and Bengt, J., Per A., and Fabian, M., "Supercharged Homogeneous Charge Compression Ignition," SAE No. 980787, pp. 129-1144, 1998.
  8. Onishi, S., et al., "Active Thermo-Atmosphere Combustion (ATAC)-A new combustion process for internal combustion engine", SAE No. 790501, 1999.
  9. Ma, T.;Zhao, H.;Li, J.;Ladommatos, N. "Experimental Investigation of Controlled Auto-Ignition Combustion in a 4-Stroke Multi-Cylinder Gasoline Engine and Drive Cycle Simulations", IFP International Congress 2001.
  10. Myung-Jun Lee, Jong-Youl Kim, Jong-Sang Park, "A Study on the Rapid Bulk Combustion of Premixture Using the Radical Seeding", KSME International Journal Vol.18 No. 9, pp. 1623-1629, 2004.
  11. Yu YongGang, CHANG XueXia, ZHOU YanHuang, MANG ShanShan, "Experiment and Numerical Simulation of Combustion and Propulsion of Bulk-loaded Energetic Liquid", Journal of engineering thermophysics, Vol. 29 No. 3, 2008.