DOI QR코드

DOI QR Code

Structural analysis of high-rise reinforced concrete building structures during construction

  • Song, Xiaobin (Department of Building Engineering, Tongji University) ;
  • Gu, Xianglin (Department of Building Engineering, Tongji University) ;
  • Zhang, Weiping (Department of Building Engineering, Tongji University) ;
  • Zhao, Tingshen (Department of Civil Engineering, Huazhong University of Science and Technology) ;
  • Jin, Xianyu (Department of Civil Engineering, Zhejiang University)
  • 투고 : 2009.10.28
  • 심사 : 2010.08.10
  • 발행 : 2010.11.10

초록

This paper presents a three-dimensional finite element method based structural analysis model for structural analysis of reinforced concrete high-rise buildings during construction. The model considered the time-dependency of the structural configuration and material properties as well as the effect of the construction rate and shoring stiffness. Uniaxial compression tests of young concrete within 28 days of age were conducted to establish the time-dependent compressive stress-strain relationship of concrete, which was then used as input parameters to the structural analysis model. In-situ tests of a RC high-rise building were conducted, the results of which were used for model verification. Good agreement between the test results and model predictions was achieved. At the end, a parametric study was conducted using the verified model. The results indicated that the floor position and construction rate had significant effect on the shore load, whereas the influence of the shore removal timing and shore stiffness have much smaller. It was also found that the floors are more prone to cracking during construction than is ultimate bending failure.

키워드

참고문헌

  1. Duan, M.Z. and Chen, W.F. (1986), "Design guidelines for safe concrete construction", Concrete Int., 18(10), 44-49.
  2. Eldukair, Z.A. and Ayyub, B.M. (1991). "Analysis of recent U.S. structural and construction failures", J. Perform. Constr. Fac., 5(1), 57-73. https://doi.org/10.1061/(ASCE)0887-3828(1991)5:1(57)
  3. Epaarachchi, D.C., Stewart, M.G. and Rosowsky, D.V. (2002), "Structural reliability of multistory buildings during construction", J. Struct. Eng.-ASCE, 128(2), 205-213. https://doi.org/10.1061/(ASCE)0733-9445(2002)128:2(205)
  4. Fang, D.P., Zhu, H.Y., Geng, C.D. and Liu, X.L. (2001), "On-site measurements of structural characteristics of reinforced concrete buildings during construction", ACI Struct. J., 98(2), 157-163.
  5. Fang, D.P., Zhu, H.Y., Geng, C.D. and Liu, X.L. (2001), "Structural analysis of reinforced concrete buildings during construction", ACI Struct. J., 98(2), 149-156.
  6. Gardner, N.J. and Sau, P.L. (1986), "Strength development and durability of CSA type 30 cement/slag/fly-ash concrete for arctic marine applications", Durab. Build. Mater., 4(2), 179-200.
  7. Grundy, P. and Kabaila, A. (1963), "Construction loads on slabs with shored formwork in multistory buildings", ACI J., 60(12), 1729-1738.
  8. Hadipriono, F.C. and Wang, H.K. (1986), "Analysis of causes of false-work failures in concrete structures", J. Constr. Eng. M. ASCE, 112(1), 112-121. https://doi.org/10.1061/(ASCE)0733-9364(1986)112:1(112)
  9. Hognestad, E. (1951), "A study of combined bending and axial load in reinforced concrete members", University of Illinois Engineering Experimental Station, Bulletin Series No.399, 128.
  10. Klieger, P. (1958), "Effect of mixing and curing temperature on concrete strength", ACI J. Proceed., 29(12), 1063-1081.
  11. Kwak, H.G. and Kim, J.K. (2006), "Time-dependent analysis of RC frame structures considering construction sequences", Build. Environ., 41, 1423-1434. https://doi.org/10.1016/j.buildenv.2005.05.013
  12. Liu, X.L., Chen, W.F. and Bowman, M.D. (1985), "Construction load analysis for concrete structures", J. Struct. Eng.-ASCE, 111(5), 1019-1036. https://doi.org/10.1061/(ASCE)0733-9445(1985)111:5(1019)
  13. Mossallam, K.H. and Chen, W.F. (1991), "Determining shoring loads for reinforced concrete construction", ACI Struct. J., 88(3), 340-350.
  14. Oluokun, F.A., Burdette, E.G. and Deatherage, J.H. (1991), "Elastic modulus, poisson's ratio and compressive strength relationships at early ages", ACI Mater. J., 88(1), 3-10.
  15. Parsons, T.J. and Naik, T.R. (1985), "Early age concrete strength determination by maturity", Concrete Int., 7(2), 37-43.
  16. Plowman, J.M. (1956), "Maturity and strength of concrete", Mag. Concrete Res., 8(22), 13-22. https://doi.org/10.1680/macr.1956.8.22.13
  17. Stivaros, R.C. and Halvorsen, G.T. (1991), "Equivalent frame analysis of concrete buildings during construction", Concrete Int., 13(8), 57-62.
  18. Zhao, T.S. (2002), "Safety analysis of R.C. high-rise buildings during construction", Ph.D. Thesis, Department of Building Engineering, Tongji University, Shanghai China. (in Chinese)
  19. Zhu, B.F. (1996), "Relationship between ultimate tensile strain and tensile and compressive strengths", China Civil Eng. J., 5, 72-75.
  20. Chen, P., Li, H., Sun, S.L. and Yuan, M.W. (2006), "A fast construction sequential analysis strategy for tall buildings", Struct. Eng. Mech., 23(6), 675-689. https://doi.org/10.12989/sem.2006.23.6.675

피인용 문헌

  1. Bond behaviour of reinforcing steel bars in early age concrete vol.94, 2015, https://doi.org/10.1016/j.conbuildmat.2015.06.060
  2. Temperature and Displacement Monitoring to Steel Roof Construction of Shenzhen Bay Stadium vol.16, pp.04, 2016, https://doi.org/10.1142/S0219455416400204