DOI QR코드

DOI QR Code

Application of fiber element in the assessment of the cyclic loading behavior of RC columns

  • Sadjadi, R. (Department of Civil Engineering, Ryerson University) ;
  • Kianoush, M.R. (Department of Civil Engineering, Ryerson University)
  • 투고 : 2008.03.04
  • 심사 : 2009.10.19
  • 발행 : 2010.02.20

초록

This paper studies the reliability of an analytical tool for predicting the lateral load-deformation response of RC columns while subjected to lateral cyclic displacements and axial load. The analytical tool in this study is based on a fiber element model implemented into the program DRAIN-2DX (fiber element). The response of RC column under cyclic displacement is defined by the behavior of concrete, and reinforcing steel under general reversed-cyclic loading. A tri-linear stress-strain relationship for the cyclic behavior of steel is proposed and the improvement in the analytical results is studied. This study only considers the behavior of columns with flexural dominant mode of failure. It is concluded that with the implementation of appropriate constitutive material models, the described analytical tools can predict the response of the columns with reasonable accuracy when compared to experimental data.

키워드

참고문헌

  1. Allahabadi, R. and Powell, G.H. (1988), "DRAIN-2DX User Guide", Technical Report UCB/EERC 88/06, University of California, Berkeley.
  2. Bae, S. and Bayrak, O. (2004), "Performance-based design of confining reinforcement: research and seismic design provisions", International Symposium on Confined Concrete, Changsha, China.
  3. Bauschinger, J. (1887), "Variations in the elastic limit of iron and steel", J. Iron Steel Inst., 12(1), 442-444.
  4. Bechtoula, H., Kono, S. and Watanebe, F. (2009), "Seismic performance of high strength reinforced concrete columns", Struct. Eng. Mech., 31(6), 697-716. https://doi.org/10.12989/sem.2009.31.6.697
  5. Dhakal, R.P. (2006), "Post-peak response analysis of SFRC columns including spalling and buckling", Struct. Eng. Mech., 22(3), 311-330. https://doi.org/10.12989/sem.2006.22.3.311
  6. Dodd, L. and Restrepo-Posada, J. (1995), "Model for predicting cyclic behavior of reinforcing steel", J. Struct. Eng., 121(3), 433-445. https://doi.org/10.1061/(ASCE)0733-9445(1995)121:3(433)
  7. El-Bahy, A., Kunnath, S.K., Stone, W.C. and Taylor, A.W. (1999), "Cumulative seismic damage of circular bridge columns: Benchmark and low-cycle fatigue tests", ACI Struct. J., 96(4), 633-641.
  8. Elwood, K.J. and Eberhard, M.O. (2006), "Effective stiffness of reinforced concrete columns", PEER Research Digest No. 2006-1.
  9. Elwood, K.J. and Moehle, J.P. (2003), "Shake table tests and analytical studies on the gravity load collapse of reinforced concrete frames", PEER report 2003/01, Pacific Earthquake Engineering Research Center, Univ. of California, Berkeley, 346 pages.
  10. Esmaeily-Gh, A. and Xiao, Y. (1999), "Behavior of reinforced concrete columns under variable axial loads", Report No. USC-SERP 99/01, Department of Civil Engineering University of Southern California, Los Angeles, California.
  11. Filippou, F.C. and Issa, A. (1988), ''Nonlinear analysis of reinforced concrete frames under cyclic load reversals", Rep. EERC 88/12, Earthquake Engineering Research Center, Univ. of California, Berkeley, California.
  12. Furlong, R.W. (1979), "Concrete columns under biaxially eccentric thrust", ACI J., Proceedings, 76(10).
  13. Golafshani, A.A., Aval, S.B.B. and Saadeghvaziri, M.A. (2002), "The fiber element technique for analysis of concrete- filled steel tubes under cyclic loads", Struct. Eng. Mech., 14(2), 119-133. https://doi.org/10.12989/sem.2002.14.2.119
  14. Hoshikuma, J., Kawashima, K., Nagaya, K., and Taylor, A.W. (1997), "Stress-strain model for confined concrete in bridge piers", J. Struct. Eng-ASCE, 123(5), 624-633. https://doi.org/10.1061/(ASCE)0733-9445(1997)123:5(624)
  15. Kent, D.C. and Park, R. (1971), "Flexural members with confined concrete", J. Struct. Div., 97(7), 1969-1990.
  16. Krauberger, N., Saje, M., Planinc, I. and Bratina, S. (2007), "Exact buckling load of a restrained RC column", Struct. Eng. Mech., 27(3), 293-310. https://doi.org/10.12989/sem.2007.27.3.293
  17. Kunnath, S.K. (2004), "Influence of confinement modeling on cyclic response of reinforced concrete columns", International Symposium on Confined Concrete, Changsha, China.
  18. Kwon, S.H., Zhao, Z. and Shah, S.P. (2008), "Effect of specimen size on fracture energy and softening curve of concrete: Part II. Inverse analysis and softening curve", Cement Concrete Res., 38(8-9), 1061-1069. https://doi.org/10.1016/j.cemconres.2008.03.014
  19. Lokuge, W.P., Sanjayan, J.G. and Setunge, S. (2004), "Constitutive model for confined high strength concrete subjected to cyclic loading", J. Mater. Civil Eng., 16, 297. https://doi.org/10.1061/(ASCE)0899-1561(2004)16:4(297)
  20. Lee, T.K. and Pan, A.D.E. (2001), "Analysis of composite beam-columns under lateral cyclic loading", J. Struct. Eng-ASCE, 127(2), 186-193. https://doi.org/10.1061/(ASCE)0733-9445(2001)127:2(186)
  21. Lu, X.Z., Jiang, J.J. and Ye, L.P. (2006), "A composite crack model for concrete based on meshless method", Struct. Eng. Mech., 23(3), 217-232. https://doi.org/10.12989/sem.2006.23.3.217
  22. Maekawa, K., Pimanmas, A. and Okamura, H. (2003), Nonlinear Mechanics of Reinforced Concrete, Spon Press, New York, USA.
  23. Mander, J.B. (1983), Seismic Design of Bridge Piers, Ph.D. Thesis, Dept. of Civ. Engrg., University of Canterbury, Christchurch, New Zealand.
  24. Mander, J.B., Priestley, M.J.N. and Park, R. (1988), "Theoretical stress-strain behavior of confined concrete", J. Struct. Eng-ASCE, 114(8), 1804-1826. https://doi.org/10.1061/(ASCE)0733-9445(1988)114:8(1804)
  25. Mander, J.B., Priestley, M.J.N. and Park, R. (1988), "Observed stress-strain behavior of confined concrete", J. Struct. Eng-ASCE, 114(8), 1827-1849. https://doi.org/10.1061/(ASCE)0733-9445(1988)114:8(1827)
  26. Otani, S. (1980), "Nonlinear dynamic analysis of reinforced concrete building structures", Can. J. Civil Eng., 7(2).
  27. Park, R. and Paulay, T. (1990), "Use of interlocking spirals for transverse reinforcement in bridge columns", Strength and Ductility of Concrete Substructures of Bridges, RRU (Road Research Unit) Bulletin, 84(1), 77-92.
  28. Paulay, T. and Priestly, M.J.N. (1992), Seismic Design of Reinforced Concrete and Masonry Building, Wiley, New York.
  29. Ramamurthy, L.N. (1966), "Investigation of the ultimate strength of square and rectangular columns under biaxially eccentric loads", ACI-SP, 13, 263-298.
  30. Roesler, J., Paulino, G.H., Park, K. and Gaedicke, C. (2007), "Concrete fracture prediction using bilinear softening", Cement Concrete Comp., 29(4), 300-312. https://doi.org/10.1016/j.cemconcomp.2006.12.002
  31. Sakai, K. and Sheikh, S.A. (1989), "What do we know about confinement in reinforced concrete columns?" ACI Struct. J., 86(2), 192-207.
  32. Shayanfar, M.A., Kheyroddin, A. and Mirza, M.S. (1997), "Finite element size effects in nonlinear analysis of RC structures", J. Comput. Struct., 62(2), 339-352. https://doi.org/10.1016/S0045-7949(96)00007-7
  33. Shima, H., Chou, L. and Okamura, H. (1987), "Micro and macro models for bond behavior in reinforced concrete", J. Fac. Eng. Univ. Tokyo, 39(2), 133-194.
  34. Taucer, F.F., Spacone, E. and Filippou, F.C. (1991), "A fiber beam-column element for seismic response analysis of reinforced concrete structures", Report to the National Science Foundation and the California Department of Transportation, Earthquake Engineering Research Center, University of California, Berkeley, California.
  35. Vebo, A. and Gali, A. (1977), "Moment-curvature relation of reinforced concrete slabs", J. Struct. Div., 103(3), 515-531.

피인용 문헌

  1. Serviceability design of reinforced concrete members – Closed form solution vol.49, 2013, https://doi.org/10.1016/j.engstruct.2012.12.010
  2. Improving design limits of strength and ductility of NSC beam by considering strain gradient effect vol.47, pp.2, 2013, https://doi.org/10.12989/sem.2013.47.2.185
  3. Normalised rotation capacity for deformability evaluation of high-performance concrete beams vol.1, pp.3, 2010, https://doi.org/10.12989/eas.2010.1.3.269
  4. Minimum deformability design of high-strength concrete beams in non-seismic regions vol.8, pp.4, 2010, https://doi.org/10.12989/cac.2011.8.4.445
  5. Inelastic design of high-axially loaded concrete columns in moderate seismicity regions vol.39, pp.4, 2010, https://doi.org/10.12989/sem.2011.39.4.559
  6. Concurrent flexural strength and deformability design of high-performance concrete beams vol.40, pp.4, 2010, https://doi.org/10.12989/sem.2011.40.4.541
  7. Nonlinear analysis of service stresses in reinforced concrete sections-closed form solutions vol.10, pp.5, 2010, https://doi.org/10.12989/cac.2012.10.5.541
  8. Uni-axial behaviour of normal-strength CFDST columns with external steel rings vol.13, pp.6, 2010, https://doi.org/10.12989/scs.2012.13.6.587