초록
본 논문은 A/D 변환기(Analog-to-Digital Converter) 회로에서 신호선의 터미네이션 조건이 crosstalk에 의해 왜곡되기 쉬운 특성을 가지며 동작 주파수가 높아짐에 따라 이에 대한 주의가 더욱 요구된다. 그중에서도 아날로그 신호인 입력 신호와 레퍼런스 전압 신호는 crosstalk에 의해 왜곡되기 쉬운 아날로그 신호이면서, A/D 변환 전체의 동작 성능을 좌우하는 신호들이다. 이 두 신호들은 각각의 회로 구성에 따라 독특한 터미네이션 조건을 가지므로 본 논문에서는 주파수 영역에서 임피던스 불일치 조건을 고려한 crosstalk를 모델링하고 해당 터미네이션 조건이 crosstalk에 미치는 영향을 확인한다. 먼저, A/D 변환기 회로에서 두 신호의 회로 구성을 파악한 후 near-end와 far-end에서 임피던스 불일치를 고려한 crosstalk 모델을 유도한다. 유도한 crosstalk 모델을 이용하여 입력 신호의 near-end와 터미네이션 임피던스 불일치와 레퍼런스 전압 신호의 far-end 커패시턴스 터미네이션이 crosstalk에 미치는 영향을 예측하고, 실험을 통해 예측 결과를 확인한다. 신호선으로는 가장 널리 사용되는 microstrip 구조를 사용하였으며 skin effect에 의한 손실 증가를 반영하였다.
In this study, crosstalk between dominant interconnect pairs in an A/D converter circuit is analyzed in frequency domain and effects of termination conditions on crosstalk are described, based on the practical circuit conditions. An A/D converter circuit is a mixed circuit where both clean and noisy signals coexist such that the circuit probably suffers from distortion by crosstalk. An analog input signal and the reference voltage signal, which dominate the overall conversion performance of the A/D converter circuit, are ready to be distorted by crosstalk and include specific termination conditions, such as non-matching and capacitive termination, respectively. Thus, this study presents the model of crosstalk considering impedance mismatch at both ends and analyzes effects of the practical termination conditions in the analog input and the reference voltage interconnects on crosstalk. A typical circuit configuration of the two interconnects is described and crosstalk including near-end and far-end termination impedances is modeled. Effects of the near-end impedance mismatch in the analog input interconnect and the far-end capacitive termination in the reference voltage interconnect are estimated in the frequency domain by using the model of crosstalk and experiments are performed to confirm the estimated results. Microstrip lines are used as interconnects, involving the increase of loss in high frequencies.