DOI QR코드

DOI QR Code

Modified Ammonia Removal Model Based on Equilibrium and Mass Transfer Principles

  • Shanableh, A. (Department of Civil and Environmental Engineering, University of Sharjah, Sharjah, United Arab Emirates) ;
  • Imteaz, M. (Faculty of Engineering and Industrial Science, Swinburne University of Technology)
  • Received : 2009.12.11
  • Accepted : 2010.05.10
  • Published : 2010.07.20

Abstract

Yoon et $al.^1$ presented an approximate mathmatical model to describe ammonia removal from an experimental batch reactor system with gaseous headspace. The development of the model was initially based on assuming instantaneous equilibrium between ammonia in the aqueous and gas phases. In the model, a "saturation factor, $\beta$" was defined as a constant and used to check whether the equilibrium assumption was appropriate. The authors used the trends established by the estimated $\beta$ values to conclude that the equilibrium assumption was not valid. The authors presented valuable experimental results obtained using a carefully designed system and the model used to analyze the results accounted for the following effects: speciation of ammonia between $NH_3$ and $NH^+_4$ as a function of pH; temperature dependence of the reactions constants; and air flow rate. In this article, an alternative model based on the exact solution of the governing mass-balance differential equations was developed and used to describe ammonia removal without relying on the use of the saturation factor. The modified model was also extended to mathematically describe the pH dependence of the ammonia removal rate, in addition to accounting for the speciation of ammonia, temperature dependence of reactions constants, and air flow rate. The modified model was used to extend the analysis of the original experimental data presented by Yoon et $al.^1$ and the results matched the theory in an excellent manner.

Keywords

References

  1. Yoon, H.; Lim, J.-H.; Chung, H.-K. Bull. Korean Chem. Soc. 2008,29(3), 555-561. https://doi.org/10.5012/bkcs.2008.29.3.555
  2. Smith, P. G.; Arab, F. K. 1988, 38, 333-343.
  3. Cheung, K. C.; Chu, L. M.; Wong, M. H. 1997, 94, 209-220.
  4. Howe, K. J.; Lawler, D. F. Jour. AWWA 1989, 81, 61-66.
  5. Shanableh, A. Amer. J. Eng. Appli. Sci. 2(4), 726-734.

Cited by

  1. Mechanistic Modeling of Pollutant Removal, Temperature, and Evaporation in Chemical Air Scrubbers vol.39, pp.10, 2016, https://doi.org/10.1002/ceat.201500664