Abstract
A numerical analysis of reactive flow in a MILD(Moderate and Intense Low oxygen Dilution) combustor is accomplished to elucidate the characteristics of combustion phenomena in the furnace with the variation of air fuel ratio. For the smaller magnitude of air injection velocity(10 m/s), the air flow could not penetrate toward upper part of furnace. On the other hand, the air flow suppresses the fuel flow for the case of air injection velocity 30 m/s. The air velocity 18 m/s is corresponding to the stoichiometric air flow velocity, and for that case, the air flows to relatively more upper part of the furnace when compared with the case of air injection velocity 10 m/s. The reaction zone is produced with the previous flow pattern, so that the reaction zone of the air injection velocity 10 m/s is biased to the air nozzle side and for the case of air injection velocity 30 m/s, the reaction zone is inclined to the fuel nozzle side. For the cases with the air injection velocities 16, 18, 20 m/s, the reaction zone is nearly located at the center between air nozzle and fuel nozzle. The maximum temperatures and NOx concentrations for the cases of air injection velocity 16, 18, 20 m/s are lower than the cases with air injection velocity 10, 30 m/s. From the present study, the stoichiometric air fuel ratio is considered as the most optimal operating condition for the NOx reduction.
연소과정 중에 발생하는 질소산화물을 저감하는 기술인 MILD 연소에 대하여 공연비를 변화시키면서 나타나는 연소 특성을 수치해석을 통하여 연구하였다. 작은 크기의 공기분출속도(10 m/s)에서는 공기가 연소로 내 상부영역까지 침투하지 못한다. 반면에 공기분출속도가 30 m/s인 경우에는 공기유동이 연료유동을 억제하고 상부영역까지 흘러간다. 이론공기량에 해당하는 공기분출속도 18 m/s에서는 10 m/s 보다 상대적으로 상부영역까지 침투하였다. 이러한 유동 양상으로 공기분출속도가 작은 10 m/s에서는 연소반응대가 공기노즐 측에 치우쳐 나타나고 30 m/s에서는 연료노즐 측에 형성되었다. 공기분출속도 16, 18, 20 m/s에서는 공기노즐과 연료노즐 중간 영역에서 연소반응대가 형성되었다. 연소로 내 최대온도와 NOx 생성은 공기분출속도가 10 m/s, 30 m/s인 경우 보다 이론공기량이거나 이에 가까운 16, 18, 20 m/s에서 낮게 나타났다. 본 연구로부터 MILD 연소로에서 이론공기량 조건이 NOx를 저감하는 최적의 조건이라는 것을 밝혔다.