IE interfaces (산업공학)

Korean Institute of Industrial Engineers (대한산업공학회)
권호 표지

Development of the Assembly Line Tester of Power Transmission for Lift Truck

지게차용 동력전달장치의 조립라인 전용시험기 개발

  • Jang, Kyoung-Yeol (R&D Center, Wooyoung Hydraulics Corporation) ;
  • Yoo, Woo-Sik (Department of Industrial and Management Engineering, University of Incheon)
  • 장경열 (우영유압(주) 기술연구소) ;
  • 유우식 (인천대학교 산업경영공학과)
  • Received : 2009.10.05
  • Accepted : 2010.01.15
  • Published : 2010.03.01
Download PDF
⟨ Previous Next ⟩

Abstract

The purpose of this paper is to present the development processes of the assembly line tester of power transmission for lift truck. Because power transmission is most important part of lift truck, all assembled powertrain parts must be inspected for operational defects, pressures and RPM. Developed assembly line tester is designed to take about 25 minutes for inspecting each assembled power transmission and located it at the end of assembled line. The assembly line no-load tester consists of three parts: (1) the driving hardware part; for installing and operating the transmission. (2) control PCB part; send data from sensors to a computer and control driving part, (3) operation software of no-load tester; for an automatic inspection or manual inspection, for database management and printing transcripts.

Keywords

References

  1. Kim, O. S. (1998), No-load actuation Test of Hoist Cylinder using Dump Truck, KSPSE Fall Conference, 232-235.
  2. Park, H. S., Bae, H. J., Lee, S. J., Lee, C. K., and Kim, Y. H. (2005), An Influence of Frictional Factors on the Friction Characteristics of Automobile Transmission Gear Materials by using Design of Experiment, Journal of the KSTLE, 21(2), 93-99.
  3. Joh, W. S. and Kim, K. H. (1997), Development of Software for the Measurement of Fatigue Limit of Automobile Rear Axle, KSAE Spring Conference, 557-562.
  4. Jang, K. Y., Pang, J. S., and Yoo, S. K. (2007), A case study on development of the power transmission system for lift truck, KIIE Fall Conference.
  5. Jang, K. Y., Pang, J. S., and Yoo, S. K. (2009), A Study on the design and development of the power transmission system for lift truck, Journal of Society of Korea Industrial and Systems Engineering, 32(1), 34-43.
  6. Song, H. L. and Kim. H. S. (1997), A Study on Multi Pass Transmission System for a Flywheel Hybrid Vehicle, Transactions of the KSAE, 5(3), 106-116.
  7. Lee, W. G. (1996), The principles of statistics, Yulgok publishing co., Seoul, Korea.
  8. Park, S. H. (2005), Design of experiments, Minyeongsa, Seoul, Korea.