A Study on the Performance of Hardmetal with Whetstone Saw

초경톱과 숫돌톱의 성능에 관한 연구

  • Published : 2009.10.15

Abstract

An experimental study was performed to select cutting parameters for better quality-products in hard metals such as steels. Usually, a hard metal can be cut with a rotary cutting knife and the process provides a good cutting quality result. However, the cutting machine is much sensitive in cutting conditions because of its complicated mechanism. By this reason, careful processing conditions must be taken to improve the quality of the products. This experimental study for better quality products with a rotary cutting knife was carried out with two main factors; cutting speeds and cutting and pooling forces. A two-dimensional profile measuring instrument is used to evaluate its cutting faces and the effects of processing factors are analyzed by a commercial software.

Keywords

References

  1. Chung, N. Y. and Jin, Y. H., 2005, "Characteristics of Cut Surface by Abrasive Waterjet Cutting of Titanium Alloy," Journal of KWS, Vol. 23, No. 1, pp. 86-93.
  2. Stoecker, W. F., 1989, Design of Thermal Systems, McGraw-Hill, America, pp. 62-65.
  3. Ahn, S. H., Lee, C. M. and Shin, S. H., 2008, "A Study on the Selection of Cutting Conditions in high Speed Cutting Machine Lee, anactions of the Korea, 2008, "A Stuchine Tool Engineers, Vol. 17, No. 1, pp. 144-149.
  4. Ahn, D. G. and Yoo, T. T., 2006, "Investigation of Cutting Characteristics in the Sharp Edge for the Case of Cutting of a Low Carbon Steel Sheet using High-power CW Nd: YAG Laser," Journal of KWS, Vol. 24, No. 4, pp. 316-322.
  5. Park, K. C. and Ryu, J. H., 2008, "Residual Stress Evolution during Leveling of Hot Rolled High Strngth Coil and Camber Prediction by Residual Stress Distribution," Transactions of Materials Processing, Vol. 17, No. 2, pp. 107-112.
  6. Min, H. D., Lee, Y. J., Song, Y. S. and Kim, H. J., 2005, "A Study of Cutting Method of H-Pile for Explosive Demolition of SRC Structure," J. of Korea Society of Explosives & Blasting Engineering, Vol. 23, No. 3, pp. 83-89.
  7. Ahn, D. G., Kim, M. S., Lee, S. H., Yoo, Y. T. and Park, H. J., 2004, "Influence of Process Parameters on Characteristics of the Cut Surface for the Case of Cutting of CSP 1N Sheet Using High Power CW Nd:YAG Laser," Transactions of the Korea Society of Machine Tool Engineers, Vol. 17, No. 1, pp. 286-291.