A Study on Reduction Method of Electromagnetic Noise of PCB for Vehicle Cluster

자동차 클러스터용 PCB의 전자기 노이즈 저감 방안 연구

  • 김병우 (울산대학교 전기전자정보시스템학과부) ;
  • 허진 (울산대학교 전기전자정보시스템학과부)
  • Published : 2009.07.01

Abstract

In this paper, an EMI reduction effects using an EMC chamber is described and reduction methods is proposed. In the case of general electronic components a working frequency is low. But in this paper the vehicle cluster works 75MHz in the main clock frequency, becoming weak by noise because of being attached in TFT LCD. As the outer case installed in the vehicle is made up of plastic materials, the noise is radiated if not protecting noise in the PCB itself. Therefore, This paper will explain the theoretical basis and propriety with respect to the discussion and need about the guide for PCB design considering EMC, through the reduction of PCB noise.

Keywords

References

  1. CISPR 12 Ed.6/CDV IEC.,'Vehicles, Boats and Internal Combustion Radio Disturbance Characteristics-Limits and Methods of Measurement for the Protection of Off-Board Receivers', pp. 1-52, 2006.
  2. Todd Hubing., 'PCB EMC Design Guidelines : A Brief Annotated List', 2003 IEEE EMC Symposium, pp. 260-263, 2003
  3. Mark I. Montrose, 'EMC And The Printed Circuit Board ', pp 97-101, 2005
  4. Emere Tuncer, Chenung-Wei Lam, Frank Y. Yuan., 'Modeling Ground Plane Cuts Using Transmission Line Theory', pp. 229-230, 2005.
  5. Felix D. Mbairi, W. Peter Siebert, Hjalmar Hesselbom., 'On The Problem of Using Guard Traees for High Frequeney Differential Lines Crosstalk Reduction', IEEE Transactions on Components and Paekaging Technologies, vol. 30, no. 1, pp. 67-74, 2007 https://doi.org/10.1109/TCAPT.2007.892072
  6. Goldfarb, M. E. and R. A. Pucel., 'Modeling Via Hole Grounds in Microstrip', IEEE Micowave Guided Letter, Vol. 1, No. 6, pp. 135-137, June 1991 https://doi.org/10.1109/75.91090