Smart Structures and Systems

  • 제5권6호
  • /
  • Pages.663-679
  • /
  • 2009
  • /
  • 1738-1584(pISSN)
  • /
  • 1738-1991(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Design and characterization of a compact array of MEMS accelerometers for geotechnical instrumentation

  • Bennett, V. (Department of Civil and Environmental Engineering, Rensselaer Polytechnic Institute) ;
  • Abdoun, T. (Department of Civil and Environmental Engineering, Rensselaer Polytechnic Institute) ;
  • Shantz, T. (California Department of Transportation, Division of Research and Innovation) ;
  • Jang, D. (Branch A Geotechnical Design - South 1, California Department of Transportation, Division of Engineering Services, Geotechnical Services) ;
  • Thevanayagam, S. (Department of Civil and Environmental Engineering, University at Buffalo)
  • 투고 : 2008.11.10
  • 심사 : 2009.04.27
  • 발행 : 2009.11.25
⟨ 이전 논문 다음 논문 ⟩

초록

The use of Micro-Electro-Mechanical Systems (MEMS) accelerometers in geotechnical instrumentation is relatively new but on the rise. This paper describes a new MEMS-based system for in situ deformation and vibration monitoring. The system has been developed in an effort to combine recent advances in the miniaturization of sensors and electronics with an established wireless infrastructure for on-line geotechnical monitoring. The concept is based on triaxial MEMS accelerometer measurements of static acceleration (angles relative to gravity) and dynamic accelerations. The dynamic acceleration sensitivity range provides signals proportional to vibration during earthquakes or construction activities. This MEMS-based in-place inclinometer system utilizes the measurements to obtain three-dimensional (3D) ground acceleration and permanent deformation profiles up to a depth of one hundred meters. Each sensor array or group of arrays can be connected to a wireless earth station to enable real-time monitoring as well as remote sensor configuration. This paper provides a technical assessment of MEMS-based in-place inclinometer systems for geotechnical instrumentation applications by reviewing the sensor characteristics and providing small- and full-scale laboratory calibration tests. A description and validation of recorded field data from an instrumented unstable slope in California is also presented.

키워드

참고문헌

  1. Abdoun, T., Danisch, L., Ha, D. and Bennett, V. (2006), "Advanced sensing for real-time monitoring of geotechnical systems", Transportation Research Board (TRB) 85th Annual Meeting, Washington, D.C., January 22-26.
  2. Abdoun, T., Bennett, V., Danisch, L., Shantz, T. and Jang, D. (2007), "Field installation details of a wireless shapeacceleration array system for geotechnical applications", Proc. of SPIE, San Diego, CA, March 19-22, Vol. 6529.
  3. Danisch, L.A. (1998), Fiber optic bending and positioning sensor, PCT 0,702,780, International PCT patent.
  4. Danisch, L.A., Danisch, J.F. and Lutes, J. (2003), Topological and motion measuring tool II (ShapeRope), US Patent Notice of Issue.
  5. Danisch, L.A., Lowery-Simpson, M.S. and Abdoun, T. (2004), Shape-Acceleration measurement Device and Method, Patent Application.
  6. Elgamal, A.W., Zeghal, M., Tang, H.T. and Stepp, J.C. (1995), "Lotung downhole seismic array: evaluation of site dynamic properties", J. Geotech. Eng. ASCE, 121(4), 350-362. https://doi.org/10.1061/(ASCE)0733-9410(1995)121:4(350)
  7. Elgamal, A.W., Zeghal, M. and Parra, E. (1996), "Liquefaction of an artificial island in kobe, japan", J. Geotech. Eng. ASCE, 122(1).
  8. Hoffman, K., Varuso, R. and Fratta, D. (2006), "The use of low-cost MEMS accelerometers in near-surface travel-time tomography", Proc. of GeoCongress 2006 Conf., Atlanta, GA.
  9. Lynch, J.P., Law, K.H., Kiremidjian, A.S., Carryer, E., Farrar, C.R., Sohn, H., Allen, D., Nadler, B. and Wait, J. (2004), "Design and performance validation of a wireless sensing unit for structural monitoring applications", Struct. Eng. Mech., 17(3).
  10. Pakzad, S.N. and Fenves, G.L. (2004), "Structural health monitoring applications using MEMS sensor networks", 4th Int. Workshop on Structural Control, Columbia University, June 10-11, 47-56.
  11. Reigles, D. (2005), "Smart base isolation systems for seismic response control of plan-asymmetric buildings", Ph.D. Dissertation, Rensselaer Polytechnic Institute, Troy, NY.
  12. Sellers, B. and Taylor, R. (2008), "MEMS basics", Geotechnical News Magazine, 26(1), 32-33.
  13. Tanner, N., Wait, J., Farrar, C. and Sohn, H. (2003), "Structural health monitoring using modular wireless sensors", J. Intel. Mat. Syst. Str., 14(1), 43-56. https://doi.org/10.1177/1045389X03014001005
  14. Youd, T.L. and Holzer, T. (1994), "Piezometer performance at wildlife liquefaction site, california", J. Geotech. Eng. ASCE, 120(6), 975-995. https://doi.org/10.1061/(ASCE)0733-9410(1994)120:6(975)
  15. Zeghal, M. and Elgamal, A.W. (1994), "Analysis of site liquefaction using earthquake records", Geotech. Eng. ASCE, 120(6), 996-1017. https://doi.org/10.1061/(ASCE)0733-9410(1994)120:6(996)
  16. Zeghal, M., Elgamal, A.W., Tang, H.T. and Stepp, J.C. (1995), "Lotung downhole seismic array: evaluation of soil nonlinear properties", J. Geotech. Eng. ASCE, 121(4), 363-378. https://doi.org/10.1061/(ASCE)0733-9410(1995)121:4(363)

피인용 문헌

  1. Real-Time Monitoring System and Advanced Characterization Technique for Civil Infrastructure Health Monitoring vol.2011, 2011, https://doi.org/10.1155/2011/870383
  2. Toward transportation asset management: what is the role of geotechnical monitoring? vol.7, pp.5, 2017, https://doi.org/10.1007/s13349-017-0249-0
  3. MEMS accelerometers for measuring dynamic penetration events in geotechnical centrifuge tests vol.14, pp.2, 2014, https://doi.org/10.1680/ijpmg.13.00020
  4. In Situ Measurement of the Dynamic Penetration of Free-Fall Projectiles in Soft Soils Using a Low-Cost Inertial Measurement Unit vol.39, pp.2, 2016, https://doi.org/10.1520/GTJ20140135
  5. Precursors of instability in a natural slope due to rainfall: a full-scale experiment vol.15, pp.9, 2018, https://doi.org/10.1007/s10346-018-0994-0
  6. Use of a MEMS accelerometer to measure orientation in a geotechnical centrifuge vol.18, pp.5, 2018, https://doi.org/10.1680/jphmg.16.00077
  7. A novel technique to monitor subsurface movements of landslides vol.55, pp.5, 2018, https://doi.org/10.1139/cgj-2016-0338
  8. Laminar Box System for 1-g Physical Modeling of Liquefaction and Lateral Spreading vol.32, pp.5, 2009, https://doi.org/10.1520/gtj102154
  9. Wireless sensor networks for long-term structural health monitoring vol.6, pp.3, 2009, https://doi.org/10.12989/sss.2010.6.3.263