Steel and Composite Structures

  • 제9권1호
  • /
  • Pages.77-87
  • /
  • 2009
  • /
  • 1229-9367(pISSN)
  • /
  • 1598-6233(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Influence of polyvinylpyrrolidone on rebar corrosion in sulphate solution

  • Gurten, A. Ali (Department of Chemistry, Faculty of Science and Art, Nigde University) ;
  • Bayol, Emel (Department of Chemistry, Faculty of Science and Art, Nigde University) ;
  • Kayakirilmaz, Kadriye (Department of Chemistry, Faculty of Science and Art, Nigde University) ;
  • Erbil, Mehmet (Department of Chemistry, Faculty of Science and Art, Cukurova University)
  • 투고 : 2008.01.21
  • 심사 : 2009.01.29
  • 발행 : 2009.01.25
⟨ 이전 논문 다음 논문 ⟩

초록

This paper reports the results of an experimental investigation of the polyvinylpyrrolidone (PVP) influence on the steel reinforcement corrosion and compressive strength of concretes in sulphate medium. The effect of admixture of PVP in concrete on the corrosion resistance of steel reinforced concrete was assessed by measuring electrochemical test during 60 days immersion in two different external solutions. AC impedance spectrum indicated that the resistance of PVP mixed electrodes were higher than those without PVP. The compressive strength of concrete specimens containing PVP was measured and an increase of 19%~24% was observed.

키워드

참고문헌

  1. Al-Amoudi, O.S.B., Maslehuddin, M., Lashari, A.N. and Almusallam, A.A. (2003), "Effectiveness of corrosion inhibitors in contaminated concrete", Cement Concrete Comp., 25, 439-449. https://doi.org/10.1016/S0958-9465(02)00084-7
  2. Al-Dulaijan, S.U., Maslehuddin, M., Al-Zahrani, M.M., Sharif, A.M., Shameem, M. and Ibrahim, M. (2003), "Sulfate resistance of plain and blended cements exposed to varying concentrations of sodium sulphate", Cement Concrete Comp., 25, 429-437. https://doi.org/10.1016/S0958-9465(02)00083-5
  3. Al-Mehthel, M., Al-Dulaijan, S., Al-Idi, S.H., Shameem, M. and Maslehuddin, M.R.A.M. (2008), "Performance of generic and proprietary corrosion inhibitors in chloride-contaminated silica fume cement concrete", Constr. Build. Mater., in press.
  4. ASTM C 876, Standard test method for half cell potentials of reinforcing steel in concrete, Vol.4.02, Philadelphia: American Society concrete.
  5. Assaad, V., Jofriet, J., Negi, S. and Hayward, G. (2005), "Corrosion of reinforced concrete specimens exposed to hydrogen sulfide and sodium sulfate", Agricultural Engineering Int., the CIGR Ejournal: 03, 013.
  6. Batis, G., Pantazopoulou, P. and Routoulas, A. (2001), "Synergistic effect of corrosion inhibitor and inorganic coating on reinforcement corrosion", Anti-Corros. Method. M., 48, 107-115. https://doi.org/10.1108/00035590110384092
  7. Batis, G., Pantazopoulou, P. and Routoulas, A. (2001), "Synergistic effect of corrosion inhibitor and inorganic coating on reinforcement corrosion", Anti-Corros. Method.M., 8, 107-115.
  8. Batis, G., Kouloumbi, N. and Pantazopoulou, P. (2000), "Protection of reinforced concrete by coatings and corrosion inhibitors", Pigm. Resin Technol., 29, 159-163. https://doi.org/10.1108/03699420010334312
  9. Carnot, A., Frateur, I., Zanna, S., Tribollet, B., Brugger, I.D. and Marcus, P. (2003), "Corrosion mechanisms of steel concrete moulds in contact with a demoulding agent studied by EIS and XPS", Corros. Sci., 45, 2513-2524. https://doi.org/10.1016/S0010-938X(03)00076-3
  10. Chen, W.H. (1998), "Cracking damage assessment of reinforced concrete members", Proc. Natl. Sci. Counc., 22, 765-774.
  11. Dehri, I. and Erbil, M. (2000), "The effect of relative humidity on the atmospheric corrosion of defective organic coatings materials: An EIS study with a new approach", Corros. Sci., 42 969-978. https://doi.org/10.1016/S0010-938X(99)00126-2
  12. El-Shafei, A.A., Moussa, M.N.H. and El-Far, A.A. (2001), "The corrosion inhibition character of thiosemicarbazide and its derivatives for C-steel in hydrochloric acid solution", Mater. Chem. Phys., 70, 175-180. https://doi.org/10.1016/S0254-0584(00)00496-X
  13. Erbil, M. and Doga, M. (1987), "Corrosion rate measurement by alternating current (a.c.) impedance method", TU. Kim. D.c. 11, 100-111.
  14. Gaidis, J.M. (2004), "Chemistry of corrosion inhibitors", Cement Concrete Comp., 26, 181-189. https://doi.org/10.1016/S0958-9465(03)00037-4
  15. Gurten, A.A., Erbil, M. and Kayakirimaz, K. (2005), "Effect of polyvinylpyrrolidone on the corrosion resistance of steel", Cement Concrete Comp., 27, 802-808. https://doi.org/10.1016/j.cemconcomp.2005.03.002
  16. Gurten, A.A., Kayakirilmaz, K. and Erbil, M. (2007), "The effect of thiosemicarbazide on corrosion resistance of steel reinforcement in concrete", Constr. Build. Mater., 21, 669-676. https://doi.org/10.1016/j.conbuildmat.2005.12.010
  17. Hou, J. and Chung, D.D.L. (2000), "Effect of admixtures in concrete on the corrosion resistance of steel reinforced concrete", Corros. Sci., 42, 1489-1507. https://doi.org/10.1016/S0010-938X(99)00134-1
  18. Huang, R., Chang, J.J. and Wu, J.K. (1996), "Correlation between corrosion potential and polarization resistance of rebar in concrete", Mater. Lett., 28, 445-450. https://doi.org/10.1016/0167-577X(96)00099-7
  19. Jamil, H.E., Shriri, A., Boulif, R., Montemor, M.F. and Ferreira, M.G.S.(2005), "Corrosion behaviour of reinforcing steel exposed to an amino alcohol based corrosion inhibitor", Cement Concrete Comp., 27, 671-678. https://doi.org/10.1016/j.cemconcomp.2004.09.019
  20. Loto, C.A. (1992), "Effect of inhibitors and admixed chloride on electrochemical corrosion behaviour of mild steel reinforcement in concrete in seawater", Corros. NACE, 48, 759-763. https://doi.org/10.5006/1.3315997
  21. Monticelli, C., Frignani, A. and Trabanelli, G. (2000), "A Study of corrosion inhibitors for concrete application", Cement Concrete Res., 30, 635-642. https://doi.org/10.1016/S0008-8846(00)00221-0
  22. Nmai, C.K., Farrington, S.A. and Bobrowski, G.S. (1992), "Organic-based corrosion-inhibiting admixture for reinforced concrete", Concrete Int., 14, 45-51.
  23. Ozyilmaz, A.T., Erbil, M. and Yazici, B. (2006), "The corrosion behaviours of polyaniline coated stainless steel in acidic solutions", Thin Solid Films., 496, 431-437. https://doi.org/10.1016/j.tsf.2005.08.306
  24. Pech-Canul, M.A. and Castro, P. (2002), "Corrosion measurements of steel reinforcement in concrete exposed to a tropical marine atmosphere", Cement Concrete Res., 32, 491-498. https://doi.org/10.1016/S0008-8846(01)00713-X
  25. Ramyar, K. and Inan, G. (2007), "Sodium sulfate attack on plain and blended cements", Build. Environ., 42, 1368-1372. https://doi.org/10.1016/j.buildenv.2005.11.015
  26. Sadegzadeh, M., Page, C.L. and Vassie, P.W.R. (1993), "Effects of urea on durability of reinforced concrete", Mag. Concrete Res., 45, 179-186. https://doi.org/10.1680/macr.1993.45.164.179
  27. Soylev, T.A. and Richardson, M.G. (2008), "Corrosion inhibitors for steel in concrete: State-of-the-art report" Constr. Build. Mater., 22, 609-622. https://doi.org/10.1016/j.conbuildmat.2006.10.013
  28. Turkmen, I. and Gavgali, M. (2003), "Influence of mineral admixtures on the some properties and corrosion of steel embedded in sodium sulfate solution of concrete", Mater. Lett., 4316, 1-12.
  29. Tuken, T., Tansu , G., Yazici, B. and Erbil, M. (2007), "Poly(N-methyl pyrrole) and its copolymer with pyrrole for mild steel protection", Surf. Coat. Tech., 202, 146-154. https://doi.org/10.1016/j.surfcoat.2007.05.022
  30. Vu, K.A.T. and Stewart, M.G. (2000), "Structural reliability of concrete bridges including improved chlorideinduced corrosion models", Struct. Saf., 22, 313-333. https://doi.org/10.1016/S0167-4730(00)00018-7
  31. Wang, S.X., Lin, W.W., Ceng, S.A., Zhang, J.Q. (1998), "Corrosion inhibition of reinforcing steel by using acrylic latex", Cement Concrete Res., 28, 649-653. https://doi.org/10.1016/S0008-8846(98)00048-9
  32. Yilmaz, A.B., Yazici, B. and Erbil, M. (1997), "The effects of sulphate ion on concrete and reinforced concrete", Cement Concrete Res., 27, 1271-1279. https://doi.org/10.1016/S0008-8846(97)00105-1

피인용 문헌

  1. A new corrosion inhibitor for steel rebar in concrete: Synthesis, electrochemical and theoretical studies vol.1225, pp.None, 2021, https://doi.org/10.1016/j.molstruc.2020.129257