초록
본 연구는 진단용 CT 장치를 이용한 CT-모의치료기의 테이블 및 레이저 정렬 시스템과 횡단면 영상의 중심간 정렬을 개선하기 위한 효율적인 방법을 제안하고자 하였다. 본원에서 제작한 팬텀을 이용하여 AAPM TG66에서 제시하는 일일 정도관리를 시행하고 기하학적 삼각함수를 이용하여 레이저 정렬 시스템을 교정하였으며 교정 전, 후를 비교함으로서 교정방법에 대한 효율성을 검토하였다. 교정 전 영상의 중심간 오차는 3.82mm, 테이블 종축은 $0.436^{\circ}$ 틀어져 진행하였다. 기하학적 삼각함수를 이용한 레이저 정렬 시스템의 교정 후 0.7mm의 중심간 오차가 발생하여 ${\pm}2mm$의 허용오차 범위를 만족하였다. 설치 가동 중인 진단용 CT 장치를 방사선치료 전용 CT-모의치료기로 활용하는 경우 기하학적 정확도를 만족시키기 위한 테이블 교정은 기술적인 한계 뿐 만 아니라 시간 및 경제적 손실에 비하여 매우 비효율적이다. 그러나 레이저 정렬 시스템을 이용한 교정 방법은 경제적이고 비교적 간단하면서도 만족스러운 기하학적 정확도를 얻을 수 있어 임상에서 적용할 수 있는 효율적인 방법이라 사료된다.
This study suggested that the table of CT-simulator and the laser alignment system using diagnostic CT scanner have an efficient method for improvement in alignment between the planned target center of traverse image with CT scanner. It was conducted on the daily QA when presented in the AAPM TG66 with correcting the laser alignment system using geometric trigonometric functions and investigated the effectiveness of correction methods as compared with those before and after correction. Before correction error was 3.82mm between the planned target center of image, the table longitudinal axis was twisted with 0.436o. The laser alignment system using geometric trigonometric functions in after correction was satisfied with tolerance limits of ${\pm}2mm$ when occurred about 0.7mm in errors between the planned target center. The table correction to satisfy the geometric accuracy is very inefficient over against the time and economic loss as well as technical limits in the case of application as only radiation therapy associated with CT-simulator with diagnostic CT scanner in use. But, the method which corrects the laser alignment system is economic and relatively simple with possibility of getting well geometric accuracy and we suppose that it is efficient method for applying in the clinic.