Efficient Drying Conditions for a Condensing Clothes Dryer

응축식 의류건조기의 효율적인 건조 조건

  • Chung, Hae-Won (Dept. of Fashion Design and Textiles, Inha University) ;
  • Kim, Hyo-Jeong (Dept. of Fashion Design and Textiles, Inha University) ;
  • Hwang, So-Yeon (Dept. of Fashion Design and Textiles, Inha University)
  • 정혜원 (인하대학교 의류디자인학과) ;
  • 김효정 (인하대학교 의류디자인학과) ;
  • 황소연 (인하대학교 의류디자인학과)
  • Received : 2008.08.28
  • Accepted : 2008.12.07
  • Published : 2008.12.31

Abstract

The use of clothes dryers is increasing in Korea and throughout Asia, because of preference for the drum type washer dryer. Clothes dryers consume more energy than almost any other home appliance. This paper suggests efficient ways for drying laundry with condensing clothes drier. We dried cotton fabrics with the condensing clothes dryers and observed the energy input, temperature and RH of the dryer during the drying process. In the early stages of drying process, the air temperature inside the clothes dryer decreased and the RH and the drying time increased as the weight of fabrics increased. We found that it was important to consider the total weight of the fabrics that included heat-sensitive fibers. It took more than half the drying time and the energy input for a 2.5 kg load that it did for a 5 kg load. Therefore, drying larger one load was more efficient than divided smaller loads, because increasing the weight of the fabrics reduced the energy input per kg of drying clothes. The lower the initial moisture regains of the fabrics were, the lower the energy input and the drying time were. The energy input for spinning after washing was much less than that for drying in the dryer. Consequently, it is more efficient to reduce the moisture content of the clothes by lengthening the spinning time of the washer to reduce the energy consumption and the drying time. During the drying process opening the door twice for 30 seconds each time lowered the air temperature and the RH of the dryer, but did not affect the moisture regain of the fabrics, the drying time, and the energy input.

Keywords

References

  1. 김상용, 장동호, 최영엽. (1982). 섬유물리학. 이우출판사, pp53-55
  2. 김성련. (1998). 세제와 세탁의 과학. 교문사, pp218-220
  3. 栗津光明, 奧山春彦, 皆川基. (1991). 洗劑.洗淨事典. 朝倉書店, pp381-386
  4. Bansal, P. K. Braun, J. E. & Groll, E. A. (2001). Improving the energy efficiency of conventional tumbler clothes drying systems. Int. J. Energy Res., 25(15), 1315-1332 https://doi.org/10.1002/er.752
  5. Bassily, A. M. & Colver, G. M. (2005). Numerical optimization of the annual cost of a clothes dryer. Drying Technology, 23(7), 1515-1540 https://doi.org/10.1081/DRT-200063541
  6. Buisson, Y., Rajasekarna, L. K., & French, A. D. (2000). Qualitative and Quantitative Evaluation of Cotton Fabric Damage by Tumble Drying, Textile Res. J. 70(8), 739-743 https://doi.org/10.1177/004051750007000813
  7. Hekmat, D. & Fisk, W. J. (1983). Improving the energy efficiency of residential clothes dryers. NTIS report no. LBNL16813
  8. Ng, Ah Bing & Deng, Shiming. (2008). A new termination control method for a clothes drying process in a clothes dryer, Applied Energy, 85(9), 818-829 https://doi.org/10.1016/j.apenergy.2007.10.016
  9. Park, Chunghee, Chung, Seung Eun & Yun, Chang Sang. (2007). Effect of drying condition on the electrostatic characteristics of the laundry, Fibers and Polymers, 8(4), 432-437 https://doi.org/10.1007/BF02875834
  10. To, W. M., Yu,Y.W., Lai, T. M. & Li, S. P. (2007). Characterization of commercial clothes dryers based on energy efficiency analysis, International J. Clothing Sci. Tech. 19(5), 277-290 https://doi.org/10.1108/09556220710819492
  11. Yadav, V. & Moon, C. G. (2008). Fabric-drying process in domestic dryers. Applied Energy, 85(2/3), 143-158 https://doi.org/10.1016/j.apenergy.2007.06.007