Extraction of Expansion Length for Expansion Jiont Bridge using Imagery

영상을 이용한 교량 신축이음부의 신축량 추출

  • Seo, Dong-Ju (Department of Civil Engineering, Dong-Eui University) ;
  • Kim, Ga-Ya (Department of Urban Engineering, Dong-Eui University)
  • Received : 2008.10.28
  • Accepted : 2008.12.29
  • Published : 2008.12.31

Abstract

A load effect by vehicles running on a road and an increase of traffic is distinguished as a serious issue in the level of bridges' maintenance and management since it causes a quick damage of bridges. The expansion joint is the most important since it makes vehicles' traveling amicable and stress or additional load harmful to molding patterns minimized. However, it is very difficult to measure its expansion length since vehicles continue to pass on the expansion joint. Therefore, the study could see that it was possible to carry out a qualitative and quantitative maintenance and management if its expansion length is extracted with images. The study could acquire three dimensional coordinates of expansion joints with images. As the results of calculating RMSE of check point residual at 32 points in A area and at 28 points in B area, both A and B areas had very good results of RMSEsms 0.829mm~1.680mm. As the results of analyzing expansion length and immediate value extracted by images, the study analyzed that RMSE of A area was 0.64mm and RMSE of B area was 0.28. The average residual of A area was 0.60% and the average rresidual of B area was 0.27%. Therefore, it is judged that it is more scientific and efficient than the past to measure expansion length with images at the time of repairing and managing bridges in the future.

도로를 통과하는 차량하중 및 통행량의 증가로 인해 발생하는 하중효과는 교량에 급격한 손상을 유발시키기 때문에 교량의 유지관리차원에서 심각한 문제로 대두되고 있다. 그중 신축이음부는 차량의 주행을 원활하게 해주면서 주형에 유해한 응력이나 부가 하중이 최소화되도록 해주는 것이 가장 중요한 부분이다. 그러나 신축이음부는 향시 차량이 지나감으로 신축량을 측정하기란 매우 어려운 실정이다. 따라서, 신축이음부를 영상을 이용하여 신축량을 추출하면 정량적이고, 정성적인 유지관리를 할 수 있음을 알 수 있었다. 영상을 이용하여 량신축이음부에 대한 3차원 좌표를 취득할 수 있었으며, A지역 32개소과 B지역 28개소에 있어서 검사점(Check Point)의 잔차에 대한 RMSE를 산정한 결과 A,B지역 모두 RMSE는 0.829mm~1.680mm의 매우 양호한 결과가 나타났다. 영상에 의해서 추출한 신축량과 실측값과 비교분석한 결과, A지역 RMSE는 0.64mm, B지역 RMSE는 0.28mm로 분석하였으며, A지역 평균잔차는 0.60%, B지역평균잔차는 0.27%로 나타났다. 또한, 향후 교량의 유지관리시 신축량을 측정은 영상을 이용하여 측정하므로서 과거에 비해 과학적이고, 효율적인 방법으로 판단된다.

Keywords