DOI QR코드

DOI QR Code

Damage identification of substructure for local health monitoring

  • Huang, Hongwei (Department of Bridge Engineering, Tongji University) ;
  • Yang, Jann N. (Department of Civil & Environmental Engineering, University of California)
  • 투고 : 2007.06.10
  • 심사 : 2007.11.29
  • 발행 : 2008.11.25

초록

A challenging problem in structural damage detection based on vibration data is the requirement of a large number of sensors and the numerical difficulty in obtaining reasonably accurate results when the system is large. To address this issue, the substructure identification approach may be used. Due to practical limitations, the response data are not available at all degrees of freedom of the structure and the external excitations may not be measured (or available). In this paper, an adaptive damage tracking technique, referred to as the sequential nonlinear least-square estimation with unknown inputs and unknown outputs (SNLSE-UI-UO) and the sub-structure approach are used to identify damages at critical locations (hot spots) of the complex structure. In our approach, only a limited number of response data are needed and the external excitations may not be measured, thus significantly reducing the number of sensors required and the corresponding computational efforts. The accuracy of the proposed approach is illustrated using a long-span truss with finite-element formulation and an 8-story nonlinear base-isolated building. Simulation results demonstrate that the proposed approach is capable of tracking the local structural damages without the global information of the entire structure, and it is suitable for local structural health monitoring.

키워드

참고문헌

  1. Bernal, D. (2002), "Load vectors for damage localization", ASCE, J. Eng. Mech., 128(1), 7-14. https://doi.org/10.1061/(ASCE)0733-9399(2002)128:1(7)
  2. Bernal, D. and Beck, J., (2004), "Special section: Phase I of the IASC-ASCE structural health monitoring benchmark", ASCE, J. Eng. Mech., 130(1), 1-127. https://doi.org/10.1061/(ASCE)0733-9399(2004)130:1(1)
  3. Gao, Y. and Spencer, Jr. B. F. (2002), "Damage localization under ambient vibration using changes in flexibility", Earthq. Eng. Eng. Vib., 1(1), 136-144. https://doi.org/10.1007/s11803-002-0017-x
  4. Huang, H. (2006), "System identification and damage detection of structures", PhD Dissertation, Department of Civil & Environmental Engineering, University of California, Irvine, CA.
  5. Koh, C. G., See, L. M. and Balendra, T. (1991), "Estimation of structural parameters in time domain: a substructure approach", Earthq. Eng. Struct. Dyn., 20, 787-801. https://doi.org/10.1002/eqe.4290200806
  6. Koh, C. G., Hong, B. and Liaw, C. Y. (2003), "Substructural and progressive structural identification methods", Eng. Struct., 25, 1551-1563. https://doi.org/10.1016/S0141-0296(03)00122-6
  7. Lin, J. W., Betti, R., Smyth, A. W. and Longman, R. W. (2001), "On-line identification of nonlinear hysteretic structural systems using a variable trace approach", Earthq. Eng. Struct. Dyn., 30, 1279-1303. https://doi.org/10.1002/eqe.63
  8. Lin, S., Yang, J. N. and Zhou, L. (2005), "Damage identification of a benchmark problem for structural health monitoring", J. Smart Mater. Struct., 14, S162-S169. https://doi.org/10.1088/0964-1726/14/3/019
  9. Wen, Y. K. (1989), "Methods of random vibration for inelastic structures", ASME Applied Mechanics Review, 42(2), 39-52. https://doi.org/10.1115/1.3152420
  10. Yang, J. N. and Lin, S. (2004), "On-line identification of nonlinear hysteretic structures using an adaptive tracking technique", Int. J. Non-linear Mech., 39, 1481-1491. https://doi.org/10.1016/j.ijnonlinmec.2004.02.010
  11. Yang, J. N. and Lin, S. (2005), "Identification of parametric variations of structures based on least square estimation and adaptive tracking technique", ASCE, J. Eng. Mech., 131(3), 290-298. https://doi.org/10.1061/(ASCE)0733-9399(2005)131:3(290)
  12. Yang, J. N., Lin, S., Huang, H. and Zhou, L. (2006a), "An adaptive extended kalman filter for structural damage identification", J. Struct. Control. Health Monitoring, 13, 849-867. https://doi.org/10.1002/stc.84
  13. Yang, J. N., Huang, H. and Lin, S. (2006b), "Sequential non-linear least-square estimation for damage identification of structures", Int. J. Non-linear Mechanics, 41, 124-140. https://doi.org/10.1016/j.ijnonlinmec.2005.06.006
  14. Yang, J. N. and Huang, H. (2006c), "Damage tracking of base-isolated building using sequential nonlinear LSE with unknown inputs and unknown outputs", Smart Structures and Materials 2006: Sensors and Smart Structures Technologies for Civil, Mechanical and Aerospace Systems, Proc. of SPIE, Vol.6174, pp.11-1-11-8, San Diego, CA, 2006.
  15. Yang, J. N. and Huang, H. (2006d), "Damage identification of substructure using an adaptive tracking technique", Proceeding of US-Taiwan Workshop on Smart Structural Technology for Seismic Hazard Mitigation, CD ROM, October 12-14, 2006, Taipei, Taiwan.
  16. Yang, J. N., Pan, S. and Lin, S. (2007a), "Least squares estimation with unknown excitations for damage identification of structures", ASCE, J. Eng. Mech., 133(1), 12-21. https://doi.org/10.1061/(ASCE)0733-9399(2007)133:1(12)
  17. Yang, J. N., Pan, S. and Huang, H. (2007b), "An adaptive extended kalman filter for structural damage identification II: unknown inputs", J. Struct. Control. Health Monitoring, 14(3), 497-521. https://doi.org/10.1002/stc.171
  18. Yang, J. N. and Huang, H. (2007c), "Sequential nonlinear least-square estimation for damage identification of structures with unknown inputs and unknown outputs", Int. J. Non-linear Mech., 42, 789-801. https://doi.org/10.1016/j.ijnonlinmec.2007.03.004
  19. Yang, J. N. and Huang, H. (2007d), "Substructure damage identification using a damage tracking technique", Proc. of SPIE 07, Vol. 6529, 65292R-1 to 65292R-10, Sensors and Smart Structures Technologies for Civil, Mechanical, and Aerospace Systems, March 19-22, 2007, San Diego, CA.
  20. Zhou, L. and Yan, G. (2006), "HHT method for system identification and damage detection: an experimental study", Smart Struct. Sys., 2(2), 141-154. https://doi.org/10.12989/sss.2006.2.2.141

피인용 문헌

  1. Damage Identification of Bolt Connections in a Steel Frame vol.140, pp.3, 2014, https://doi.org/10.1061/(ASCE)ST.1943-541X.0000831
  2. Substructural interface force identification with limited vibration measurements vol.6, pp.3, 2016, https://doi.org/10.1007/s13349-016-0157-8
  3. Application of substructural damage identification using adaptive Kalman filter vol.4, pp.1, 2014, https://doi.org/10.1007/s13349-013-0054-3
  4. Calculation of Dynamic Response Sensitivity to Substructural Damage Identification under Moving Load vol.16, pp.9, 2013, https://doi.org/10.1260/1369-4332.16.9.1621
  5. Experimental study of the substructure isolation method for local health monitoring vol.19, pp.4, 2012, https://doi.org/10.1002/stc.443
  6. An improved substructural identification strategy for large structural systems vol.19, pp.8, 2012, https://doi.org/10.1002/stc.463
  7. Locating damaged storeys in a shear building based on its sub-structural natural frequencies vol.39, 2012, https://doi.org/10.1016/j.engstruct.2012.02.002
  8. Elevated Temperature Modal Response and Delamination Detection in Carbon-Epoxy Beams vol.10, pp.1, 2017, https://doi.org/10.4271/2016-01-9082
  9. Substructural Damage Detection With Incomplete Information of the Structure vol.79, pp.4, 2012, https://doi.org/10.1115/1.4005552
  10. Substructure damage identification based on wavelet-domain response reconstruction vol.13, pp.4, 2014, https://doi.org/10.1177/1475921714532991
  11. A finite-element based damage detection technique for nonlinear reinforced concrete structures vol.22, pp.10, 2015, https://doi.org/10.1002/stc.1736
  12. Damage Detection of Hysteretic Structures with a Pinching Effect vol.140, pp.3, 2014, https://doi.org/10.1061/(ASCE)EM.1943-7889.0000581
  13. Substructural Response Reconstruction in Wavelet Domain vol.78, pp.4, 2011, https://doi.org/10.1115/1.4003738
  14. Damage detection in an experimental bridge model using Hilbert-Huang transform of transient vibrations vol.20, pp.1, 2013, https://doi.org/10.1002/stc.466
  15. Substructural Time-Varying Parameter Identification Using Wavelet Multiresolution Approximation vol.138, pp.1, 2012, https://doi.org/10.1061/(ASCE)EM.1943-7889.0000307
  16. Substructure based structural damage detection with limited input and output measurements vol.12, pp.6, 2013, https://doi.org/10.12989/sss.2013.12.6.619
  17. Damage identification of a target substructure with moving load excitation vol.30, 2012, https://doi.org/10.1016/j.ymssp.2012.02.002
  18. Finite element model updating of Kömürhan highway bridge based on experimental measurements vol.6, pp.4, 2008, https://doi.org/10.12989/sss.2010.6.4.373
  19. Reliability analysis for fatigue damage of railway welded bogies using Bayesian update based inspection vol.22, pp.2, 2008, https://doi.org/10.12989/sss.2018.22.2.193