Computers and Concrete

  • 제5권2호
  • /
  • Pages.117-134
  • /
  • 2008
  • /
  • 1598-8198(pISSN)
  • /
  • 1598-818X(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Deep-beams with indirect supports: numerical modelling and experimental assessment

  • 투고 : 2007.02.05
  • 심사 : 2008.03.11
  • 발행 : 2008.04.25
⟨ 이전 논문 다음 논문 ⟩

초록

An experimental and numerical research was conducted to gain a deeper insight on the structural behaviour of deep-beams with indirect supports and to assess the size effects in the ultimate state behaviour. The experimental campaign focused on the influence of the reinforcement tie distribution height on the compression check of the support region and on the benefits of using unbonded prestressing steel. Three reduced scale specimens were tested and used to validate the results obtained with a nonlinear finite element model. As a good agreement could be found between the numerical and the experimental results, the numerical model was then further used to perform simulations in large scale deep-beams, with dimensions similar to the ones to be adopted in a practical case. Two sources of size effects were identified from the simulation results. Both sources are related to the concrete quasi-brittle behaviour and are responsible for increasing failure brittleness with increasing structural size. While in the laboratory models failure occurred both in the experimental tests as well as in the numerical simulations after reinforcement yielding, the numerically analysed large scale models exhibited shear failures with reinforcement still operating in the elastic range.

키워드

참고문헌

  1. An, X., Maekawa, K. and Okamura, H. (1997), "Numerical simulation os size effect in shear strength of RC beams", J. Mater. Concrete Struct. Pavements, JSCE, 35, 297-316.
  2. Bazant, Z. P. (1984), "Size effect in blunt fracture: conrete, rock metal", J. Eng. Mech., 110(4), 518-535. https://doi.org/10.1061/(ASCE)0733-9399(1984)110:4(518)
  3. Bazant, Z. P. (1997), "Fracturing truss model: size effect in shear failure of reinforced concrete", J. Eng. Mech., 123(12), 1276-1288. https://doi.org/10.1061/(ASCE)0733-9399(1997)123:12(1276)
  4. Bazant, Z. P. (1999), "Size effect on structural strength: a review", Archive of Applied Mechanics, Springer-Verlag, Berlim, 703-725.
  5. Bazant, Z. P. (2001), "Size effect on structural strenght", Handbook of Materials Behaviour Models, J. Lemaitre, ed., Academic Press, San Diego, 30-68.
  6. Bazant, Z. P. and Kazemi, M. T. (1991), "Size effect on diagonal shear failure of beams without strirrups", ACI Struct. J., 88(3), 268-276.
  7. Bazant, Z. P., Ozbolt, J. and Eligehausen, R. (1994), "Fracture size effect: review of evidence for concrete structures", J. Struct. Eng., 120(8), 2377-2398. https://doi.org/10.1061/(ASCE)0733-9445(1994)120:8(2377)
  8. Bazant, Z. P. and Yu, Q. (2005a), "Designing against size effect on shear strength of reinforced concrete beams without stirrups: 1. Formulation", J. Struct. Eng., 131(12), 1877-1885. https://doi.org/10.1061/(ASCE)0733-9445(2005)131:12(1877)
  9. Bazant, Z. P. and Yu, Q. (2005b), "Designing against size effect on shear strength of reinforced concrete beams without stirrups: 2. Verification and calibration", J. Struct. Eng., 131(12), 1886-1896. https://doi.org/10.1061/(ASCE)0733-9445(2005)131:12(1886)
  10. Belarbi, A. and Hsu, T. T. C. (1995), "Constitutive laws of softened concrete in biaxial tension-compression", ACI Struct. J., 92(5), 562-573.
  11. Bigaj, A. and Walraven, J. C. (2002), "Size effects in plastic hinges of RC members", Heron, 47(1), 53-75.
  12. Borst, R. (1987), "Smeared cracking, plasticity, creep and thermal loading - A unified approach", Comput. Methods Appl. Mech. Eng., 62(1), 89-110. https://doi.org/10.1016/0045-7825(87)90091-0
  13. Borst, R. and Nauta, P. (1985), "Non-orthogonal cracks in a smeared finite element model", Eng. Computations, 2, 35-46. https://doi.org/10.1108/eb023599
  14. CEB (1993), CEB-FIP Model Code 1990, Thomas Telford, London.
  15. CEN (2004), Eurocode 2: Design of concrete structures - Part 1-1: General rules and rules for buildings, Brussels.
  16. CEN (2005), Eurocode 2 - Design of concrete structures - Concrete Bridges - Design and detailing rules, Brussels.
  17. Collins, M. P. and Kuchma, D. (1999). "How safe are our large, lightly reinforced concrete beams, slabs, and footings?", ACI Struct. J., 96(4), 482-490.
  18. Dahlblom, O. and Ottosen, N. S. (1990), "Smeared crack analysis using generalized fictious crack model", J. Eng. Mech., 116(1), 55-76. https://doi.org/10.1061/(ASCE)0733-9399(1990)116:1(55)
  19. fib (1999a), Bulletin $n^{\circ}1$: Structural Concrete. Text book on Behaviour, Design and Perfomance, Vol. 1, fib, Lausanne.
  20. fib (1999b), Bulletin $n^{\circ}2$: Structural Concrete. Text book on Behaviour, Design and Perfomance, Vol. 2, fib, Lausanne.
  21. Figueiras, J. A. (1983), "Ultimate load analysis of anisotropic and reinforced concrete plates and shells", PhD Thesis, University College of Swansea, Swansea, Walles.
  22. Jansen, D. C. and Shah, S. P. (1997), "Efect of length on compressive strain softening of concrete", J. Eng. Mech., 123(1), 25-35. https://doi.org/10.1061/(ASCE)0733-9399(1997)123:1(25)
  23. Kani, G. N. J. (1967), "How safe are our large reinforced reinforced concrete beams?", ACI J., 64(3), 128-141.
  24. Maekawa, K., Pimanmas, A. and Okamura, H. (2003), Nonlinear Mechanics of Reinforced Concrete, Spoon Press, London.
  25. Markeset, G. and Hilleborg, A. (1995), "Softening of concrete in compression - Localization and size effects", Cement Concrete Res., 25(4), 702-708. https://doi.org/10.1016/0008-8846(95)00059-L
  26. Muttoni, A. and Schwartz, J. (1991), "Behavior of beams and punching in slabs without shear reinforcement", IABSE Colloquium - Structural Concrete, 62, Stuttgart, 703-708.
  27. Ozbolt, J., Mestrovic, D., Li, Y.-J. and Eligehausen, R. (2000), "Compression failure of beams made of different concrete types and sizes", J. Struct. Eng., 126(2), 703-708.
  28. Pimentel, M. (2004), "Modelling and analysis of concrete laminar structures: challenges and possibilities (in Portuguese)", MSc., Faculty of Engineering of the University of Porto, Porto.
  29. Reineck, K.-H. (1991), "Modelling of members with transverse reinforcement", IABSE Colloquium - Structural Concrete, Vol.62, Stuttgart, 481-488.
  30. Reineck, K.-H. (1995), "Shear design based on truss models with crack-friction", Bulletin 223: Ultimate Limit State Design Models, CEB, ed., CEB, Lausanne.
  31. Rots, J. G. and Blaauwendraad, J. (1989), "Crack models for concrete: discrete or smeared? Fixed, multidirectional or rotating", Heron, 34(1).
  32. Schlaich, J. and Schafer, K. (1991), "Design and detailing of structural concrete using strut-and-tie models", Struct. Eng., 69(6).
  33. Schlaich, J., Schafer, K. and Jennewein, M. (1987), "Towards a consistent design of structural concrete", PCI-J., 32(3), 74-150. https://doi.org/10.15554/pcij.05011987.74.150
  34. Tan, K. H. and Cheng, G. H. (2006), "Size effect on shear strength of deep beams: Investigating with strut-andtie model", J. Struct. Eng., 132(5), 673-685. https://doi.org/10.1061/(ASCE)0733-9445(2006)132:5(673)
  35. Tommaso, A. (1989), "Size effects and brittleness", Fracture Mechanics of Concrete Structures, Report of the RILEM Comitee 90-FMA, L. Elfgren, ed., Chapman and Hall, London, 191-207.
  36. Van Mier, J. G. M. (1986), "Fracture of concrete under complex stress", Heron, 31(3).
  37. Vecchio, F. J. (2000), "Disturbed stress field model for reinforced concrete: formulation", J. Struct. Eng., 126(9), 1070-1077. https://doi.org/10.1061/(ASCE)0733-9445(2000)126:9(1070)
  38. Vecchio, F. J. and Collins, M. P. (1986), "The modified compression-field theory for reinforced concrete elements subjected to shear", ACI J., 83(2), 219-231.
  39. Vecchio, F. J. and Collins, M. P. (1993), "Compression response of cracked reinforced concrete", J. Struct. Eng., 119(12), 3590-3610. https://doi.org/10.1061/(ASCE)0733-9445(1993)119:12(3590)
  40. Vonk, R. A. (1993), "A micromechanical investigation of softening of concrete loaded in compression", Heron, 38(3), 3-90.
  41. Walraven, J. C. and Lehwalter, N. (1991), "Size effects in short beams loaded in shear", ACI Struct. J., 91(5), 585-593.
  42. Witte, F. C. and Kikstra, W. P. (2005), "DIANA User's Manual - Material Library", TNO DIANA, BV, Delft.

피인용 문헌

  1. Modelling dowel action of discrete reinforcing bars for finite element analysis of concrete structures vol.12, pp.1, 2013, https://doi.org/10.12989/cac.2013.12.1.019
  2. Identification of a suitable ANN architecture in predicting strain in tie section of concrete deep beams vol.46, pp.6, 2013, https://doi.org/10.12989/sem.2013.46.6.853
  3. Nonlinear finite element analysis of torsional R/C hybrid deep T-beam with opening vol.11, pp.5, 2013, https://doi.org/10.12989/cac.2013.11.5.399
  4. Behavior of continuous RC deep girders that support walls with long end shear spans vol.38, pp.4, 2008, https://doi.org/10.12989/sem.2011.38.4.385
  5. Evaluation of behavior and strength of prestressed concrete deep beams using nonlinear analysis vol.9, pp.1, 2008, https://doi.org/10.12989/cac.2012.9.1.063
  6. Application of artificial neural networks (ANNs) and linear regressions (LR) to predict the deflection of concrete deep beams vol.11, pp.3, 2013, https://doi.org/10.12989/cac.2013.11.3.237
  7. Winkler spring behavior in FE analyses of dowel action in statically loaded RC cracks vol.21, pp.5, 2008, https://doi.org/10.12989/cac.2018.21.5.593