DOI QR코드

DOI QR Code

Optimum study on wind-induced vibration control of high-rise buildings with viscous dampers

  • Zhou, Yun (School of Civil Engineering, GuangZhou University) ;
  • Wang, DaYang (School of Civil Engineering, GuangZhou University) ;
  • Deng, XueSong (School of Civil Engineering, GuangZhou University)
  • Received : 2008.07.28
  • Accepted : 2008.10.20
  • Published : 2008.12.25

Abstract

In this paper, optimum methods of wind-induced vibration control of high-rise buildings are mainly studied. Two optimum methods, genetic algorithms (GA) method and Rayleigh damping method, are firstly employed and proposed to perform optimum study on wind-induced vibration control, six target functions are presented in GA method based on spectrum analysis. Structural optimum analysis programs are developed based on Matlab software to calculate wind-induced structural responses. A high-rise steel building with 20-storey is adopted and 22 kinds of control plans are employed to perform comparison analysis to validate the feasibility and validity of the optimum methods considered. The results show that the distributions of damping coefficients along structural height for mass proportional damping (MPD) systems and stiffness proportional damping (SPD) systems are entirely opposite. Damping systems of MPD and GAMPD (genetic algorithms and mass proportional damping) have the best performance of reducing structural wind-induced vibration response and are superior to other damping systems. Standard deviations of structural responses are influenced greatly by different target functions and the influence is increasing slightly when higher modes are considered, as shown fully in section 5. Therefore, the influence of higher modes should be considered when strict requirement of wind-induced vibration comfort is needed for some special structures.

Keywords

References

  1. Constantinou, M.C. and Tadjbakhsh, I.G. (1983), "Optimum design of a first story damping system", Comput. Struct. 17, 305-310. https://doi.org/10.1016/0045-7949(83)90019-6
  2. De Silva, C.W. (1981), "An algorithm for the optimal design of passive vibration controllers for flexible systems", J. Sound Vib., 75(4), 495-502. https://doi.org/10.1016/0022-460X(81)90437-5
  3. Furuya, O., Hamazaki, H. and Fujita, S. (1998), "Proper placement of energy absorbing devices for reduction of wind-induce vibration caused in high-rise buildings", J. Wind Eng. Ind. Aerodyn., 74-76, 931-992. https://doi.org/10.1016/S0167-6105(98)00085-3
  4. Gluck, N., Reinhorn, A.M., Gluck, J. and Levy, R. (1996), "Design of supplemental dampers for control for structures", J. Struct. Eng., 122(12), 1394-1399. https://doi.org/10.1061/(ASCE)0733-9445(1996)122:12(1394)
  5. Gurgoze, M. and Muller, P.C. (1992), "Optimal positioning of dampers in multi-body systems", J. Sound Vib., 158(3), 517-530. https://doi.org/10.1016/0022-460X(92)90422-T
  6. Hahn, G.D. and Sathiavageeswaran, K.R. (1992), "Effects of added-damper distribution on the seismic response of buildings", Comput. Struct., 43(5), 941-950. https://doi.org/10.1016/0045-7949(92)90308-M
  7. Holland, J.H. (1975), Adaptation in Natural and Artificial Systems, University of Michigan Press, Ann Arbor, MI.
  8. Holland, J.H. (1992), Genetic Algorithms, Scientific American.
  9. Inaudi, J.A. and Kelly, J.M. (1993), "Optimum damping in linear isolation systems", Earthq. Eng. Struct. Dyn., 22, 583-598. https://doi.org/10.1002/eqe.4290220704
  10. Jenkins, W.M. (1997), "On the application of natural algorithms to structural design optimization", Eng. Struct. 19(4), 302-308.
  11. Koumousis, V.K. and Georgiou, P.G. (1994), "Genetic algorithms in discrete optimization of steel truss roofs", J. Comput. Civ. Eng., ASCE, 8(3), 309-325. https://doi.org/10.1061/(ASCE)0887-3801(1994)8:3(309)
  12. Lin, S.S, Zhan, g.C. and Wang, H.P. (1995), "On mixed-discrete nonlinear optimization problems: a comparative study", Eng. Optim. 23, 287-300. https://doi.org/10.1080/03052159508941359
  13. OU, J.P., Wu, B. and Long, X. (1998), "Parameter analysis of passive energy dissipation systems", Earthq. Eng. Eng. Vib., 18(1), 60-70.
  14. Qu W. L. (1991), Wind-Induced Vibration Control Design of High-Rise and Super High-Rise Buildings, Pressed by Survey Science and Technology University of Wu Han.
  15. Singh, M.P. and Moreschi, L.M. (2001), "Optimal seismic response control with dampers", Earthq. Eng. Struct. Dyn., 30, 553-572. https://doi.org/10.1002/eqe.23
  16. Takewaki, I. (1997), "Optimal damper placement for minimum transfer functions", Earthq. Eng. Struct. Dyn., 26, 1113-1124. https://doi.org/10.1002/(SICI)1096-9845(199711)26:11<1113::AID-EQE696>3.0.CO;2-X
  17. Takewaki, I. (1998), "Optimal damper positioning in beams for minimum dynamic compliance", Comput. Methods Appl. Mech. Eng., 156, 363-373. https://doi.org/10.1016/S0045-7825(97)00221-1
  18. Trombetti T. and Silvestri S. (2007), "Novel schemes for inserting seismic dampers in shear-typesystems based upon the mass proportional component of the Rayleigh damping matrix", J. Sound Vib., 302(3), 486-526. https://doi.org/10.1016/j.jsv.2006.11.030
  19. Trombetti, T. and Silvestri, S. (2004), "Added viscous dampers in shear-type structures: the effectiveness of mass proportional damping", J. Earthq. Eng., 8(2), 275-313.
  20. Trombetti, T. and Silvestri, S. (2006), "On the model damping ratios of shear-type structures equipped with Rayleigh damping systems", J. Sound Vib., 292, 21-58. https://doi.org/10.1016/j.jsv.2005.07.023
  21. Trombetti, T., Silvestri, S. and Ceccoli, C. (2002), "Inserting viscous dampers in shear-type structures: analytical formulation and efficiency of MPD System", Proceedings of the Second International Conference on Advances in Structural Engineering and Mechanics (ASEM'0 2), Pusan, Korea, 21-23 August 2002.
  22. Trombetti, T., Silvestri, S. and Ceccoli, C. (2002), "On the first modal damping ratios of MPD and SPD systems", Technical Report: Nota Tecnica no 64, 2002, Department DISTART, University of Bologna, Italy.
  23. Tsuji, M. and Nakamura, T. (1996), "Optimum viscous dampers for stiffness design of shear buildings", The Structural Design of Tall Buildings, 5, 217-234. https://doi.org/10.1002/(SICI)1099-1794(199609)5:3<217::AID-TAL70>3.0.CO;2-R
  24. Wang, D.Y. and Zhou, Y. (2008), "Wind-induced vibration control research of high-rise buildings based on GA optimum theory", China Civil Engineering J., 41(1), 42-47.
  25. Xu, Z.D., Zhou, Y. and Zhao, H.T. (1999), "Optimum design method of the viscoelastic structure", J. Xi'an University of Architecture and Technology, 31(3), 246-252.
  26. Zhang, R.H. and Soong, T.T. (1992), "Seismic design of viscoelastic dampers for structural applications", J. Struct. Eng. ASCE, 118(5), 1375-1392. https://doi.org/10.1061/(ASCE)0733-9445(1992)118:5(1375)
  27. Zhao Jianfei, and Xie Buying. (2006), "The simulation of stochastic wind loading on long-span bridges and development of the program", Structural Engineers, 22(2), 42-49.
  28. Zhou, Y., Xu, Z.D. and Deng, X.S. (1998), "Optimum installation of the dampers in the viscoelastic structures", World Information on Earthquake Engineering, 14(3), 15-20.

Cited by

  1. Fuzzy Probability Study on Wind-Induced Annoyance of Tall Buildings vol.15, pp.8, 2012, https://doi.org/10.1260/1369-4332.15.8.1411
  2. Dynamics and Control of High-Rise Buildings under Multidirectional Wind Loads vol.2011, 2011, https://doi.org/10.1155/2011/549621
  3. Structural performance and cost analysis of wind-induced vibration control schemes for a real super-tall building vol.11, pp.8, 2015, https://doi.org/10.1080/15732479.2014.925941
  4. TMD effectiveness for steel high-rise building subjected to wind or earthquake including soil-structure interaction vol.30, pp.4, 2008, https://doi.org/10.12989/was.2020.30.4.423
  5. Wind-Induced Vibration Control of High-Rise Structures Using Compound Damping Cables vol.2021, pp.None, 2008, https://doi.org/10.1155/2021/5537622
  6. Life-cycle cost-based optimization of MTMDs for tall buildings under multiple hazards vol.17, pp.7, 2021, https://doi.org/10.1080/15732479.2020.1778741