DOI QR코드

DOI QR Code

Modeling cover cracking due to rebar corrosion in RC members

  • Allampallewar, Satish B. (Basic Engineering Department, Maharashtra Academy of Engineering) ;
  • Srividya, A. (Civil Engineering Department, Indian Institute of Technology Bombay)
  • 투고 : 2008.05.14
  • 심사 : 2008.11.10
  • 발행 : 2008.12.20

초록

Serviceability and durability of the concrete members can be seriously affected by the corrosion of steel rebar. Carbonation front and or chloride ingress can destroy the passive film on rebar and may set the corrosion (oxidation process). Depending on the level of oxidation (expansive corrosion products/rust) damage to the cover concrete takes place in the form of expansion, cracking and spalling or delamination. This makes the concrete unable to develop forces through bond and also become unprotected against further degradation from corrosion; and thus marks the end of service life for corrosion-affected structures. This paper presents an analytical model that predicts the weight loss of steel rebar and the corresponding time from onset of corrosion for the known corrosion rate and thus can be used for the determination of time to cover cracking in corrosion affected RC member. This model uses fully the thick-walled cylinder approach. The gradual crack propagation in radial directions (from inside) is considered when the circumferential tensile stresses at the inner surface of intact concrete have reached the tensile strength of concrete. The analysis is done separately with and without considering the stiffness of reinforcing steel and rust combine along with the assumption of zero residual strength of cracked concrete. The model accounts for the time required for corrosion products to fill a porous zone before they start inducing expansive pressure on the concrete surrounding the steel rebar. The capability of the model to produce the experimental trends is demonstrated by comparing the model's predictions with the results of experimental data published in the literature. The effect of considering the corroded reinforcing steel bar stiffness is demonstrated. A sensitivity analysis has also been carried out to show the influence of the various parameters. It has been found that material properties and their inter-relations significantly influence weight loss of rebar. Time to cover cracking from onset of corrosion for the same weight loss is influenced by corrosion rate and state of oxidation of corrosion product formed. Time to cover cracking from onset of corrosion is useful in making certain decisions pertaining to inspection, repair, rehabilitation, replacement and demolition of RC member/structure in corrosive environment.

키워드

참고문헌

  1. ACI 318 (1985), 'Standard code requirements for reinforced concrete and commentary', Am. Conc. Inst., Detroit, USA
  2. Andrade, C., Alonso, C., and Molina, F. J. (1993), 'Cover cracking as a function of bar corrosion: Part 1- experimental test', Mater. Struct., 26, 453-464 https://doi.org/10.1007/BF02472805
  3. Andres, A. Torres-Acosta and Alberto A. Sagues (2004), 'Concrete cracking by localizad steel corrosion- Geometric effects', ACI Mater. J., 101(6), 501-507
  4. Canadian Standards Association, (CSA) A23.3-94 (1994), Design of Conc. Struct., Canadian Standards Association, Rexadle, ON, Canada
  5. Carasquillo, R.L., Nilson, A.H., and Slate, F.O. (1981), 'Properties of high-strength concrete subjected to shortterm loads', ACI J. Proceedings, 78(3), 171-178
  6. CEB-FIP (1970), International Recommendations for the Design and Construction of Concrete Structures
  7. CEB-FIP (1990), Comite Euro-International du Beton-Federation International de la Precontrainte-Design Code, Londan (UK): Thomas Telford
  8. Frederic Legeron and Patrick Paultre (2000), 'Prediction of modulus of rupture of concrete', ACI Mater. J., 97(2), 193-200
  9. IS 456 (2000), 'Indian standard code of practice for plain and reinforced concrete', 4th revision, Bureau of Indian standards, New Delhi, India
  10. Kapilesh Bhargava, A.K. Ghosh, Yasuhiro, and Mori, S. Ramanujam (2006), 'Model for cover cracking due to rebar corrosion in RC structures', Eng. Struct., 28, 1093-1109 https://doi.org/10.1016/j.engstruct.2005.11.014
  11. Liu, Y. (1996), 'Modeling the time to corrosion cracking of the cover concrete in chloride contaminated reinforced concrete structures', Dissertation, at Virginia polytechnic Institute and State University, Blacksburg, VA., October
  12. Liu, Y. and Weyers, R.E. (1998), 'Modeling the time-to-corrosion cracking in chloride contaminated reinforced concrete structures', ACI Mater. J., 95(6), 675-681
  13. Mehta, P.K. and Monteiro, P.J.M. (1997), Concrete Microstructure, Properties and Materials, 1st edition, Chennai (India); Indian concrete Institute
  14. Morinaga, S. (1988), 'Prediction of service lives of reinforced concrete buildings based on rate of corrosion of reinforcing steel', Report No. 23, Shimizu Corp. Japan, 82
  15. Pantazopoulou, S.J. and Papoulia, K.D. (2001), 'Modeling cover-cracking due to reinforcement corrosion in RC structures', J. Eng. Mech., 127(4), 342-351 https://doi.org/10.1061/(ASCE)0733-9399(2001)127:4(342)
  16. Rasheeduzzafar, Al-saadoun S.S. and Al-Gahtani, A.S. (1992), 'Corrosion cracking in relation to bar diameter, cover and concrete quality', J. Mater. Civil Eng., ASCE, 4(4), 327-343 https://doi.org/10.1061/(ASCE)0899-1561(1992)4:4(327)
  17. Sadhu Singh (1981), Theory of Plasticity.1st edition, Khanna Publishers, Delhi (India)
  18. Stephen Timoshenko (2002), Strength of Materials Part II Advanced theory and Problems, 3rd edition, CBS publishers and distributors, New Delhi (India)
  19. Tamer Kl Maaddawy and Khaled Soudki (2007), 'A model for prediction of time from corrosion initiation to corrosion cracking', Cement Concrete Compo., 29(3), 168-175 https://doi.org/10.1016/j.cemconcomp.2006.11.004
  20. Timoshenko, S.P. and Goodier, J.N. (1970), Theory of Elasticity, 3rd ed. New York (USA): McGraw-Hill Book Co.
  21. Thoft-Christensen P. (2000), 'Stochastic modeling of the crack initiation time for reinforced concrete structures', ASCE Struct. Congress, Philadelphia, May 8-10, 8

피인용 문헌

  1. Beams affected by corrosion influence of reinforcement placement in the cracking vol.37, pp.2, 2008, https://doi.org/10.12989/sem.2011.37.2.163
  2. Simulation of corroded RC structures using a three-dimensional irregular lattice model vol.41, pp.5, 2008, https://doi.org/10.12989/sem.2012.41.5.645
  3. Numerical study of corrosion induced cracking in reinforced concrete structure vol.1144, pp.1, 2008, https://doi.org/10.1088/1757-899x/1144/1/012032