A Study of the Improvement of Thermal Performance of a Junction Box of a Passenger Car

자동차 정션박스의 열성능 개선을 위한 연구

  • Lee, Young-Lim (Division of Mechanical and Automotive Engineering, Kongju National University)
  • 이영림 (공주대학교 기계자동차공학부)
  • Published : 2008.03.31

Abstract

Thermal management of a junction box of a passenger car has recently become more challenging due to its smaller size and larger current capacity. Thus, it is essential to perform the thermal optimization of a junction box in its design on an early stage of vehicle design. In this study, 3 dimensional CFD simulation with experimental measurement has been done to study for better thermal management of the junction box. First, the study of thermal characteristics of electric relays in the junction box has revealed that each surface of the relay has very different thermal resistance. In addition, an idea to install a cooling fan on the junction box has been studied and it was found that the forced cooling method was not effective on the system to keep the thermal resistance to the reasonable level of the junction box. Finally, the effect of external flows around the junction box on the temperatures of the relays, fuses, etc. has been studied and the result shows that the installation of the junction box at the proper place in an engine room can avoid any unnecessary overdesign in thermal management.

Keywords

References

  1. T. Ikeya, N. Ito, A. Chiriku, M. Okada, Y. Miyazawa and N. Mochizuki, "Thermal Simulation of the Electrical Distribution Box," SAE 2001-01-0690, 2001
  2. B. H. Soerstling, "Thermal-Electrical Modeling of Electrical Subsystems," SAE 981111, 1998
  3. Q. Yang and S. Spadoni, "Thermal Study of Electrical Devices in Electrical Distribution Box," SAE 9703030, 1997
  4. Fluent, Version 6.1, Fluent, Inc., Lebanon, NH 2005
  5. F. P. Incorpera and D. P. Dewitt, Fundamentals of Heat and Mass Transfer, Wiley, New York, 1990
  6. G. N. Ellison, Thermal Computations for Electronic Equipment, Krieger Publishing Company, Florida, 1989
  7. Cooling Fans, Sanyo Denki Co., LTD, Tokyo, Japan
  8. Y. L. Lee, "An Analysis of Engine Cooling using a Three-dimensional Radiator Model," Transactions of KSAE, Vol.9, No.4, pp.10-17, 2001