DOI QR코드

DOI QR Code

연구용 저속 축류압축기의 내부 유동 특성에 관한 실험적 연구

Experimental Study on the Flow Characteristics in a Low Speed Research Compressor

  • 발행 : 2008.12.01

초록

A study on the flow characteristics in a 4-stage axial compressor and the behavior of rotating stall was experimentally performed at the third-stage rotor and stator rows in order to investigate its performance and instability of the compression system. The pressure losses generated due to the leakage flow at a tip clearance and a shroud seal clearance and the wake flow near the trailing edge of a blade were taken into consideration to estimate the causes of performance drop of the low speed research compressor(LSRC) in Seoul national university. In addition, the measurement of rotating stall was conducted with hot-wire probes and the existence and propagation of stall cell could be confirmed through fast Fourier transform and cross-correlation analysis.

키워드

참고문헌

  1. Wisler, D. C., 1985, "Loss Reduction in Axial Flow Compressor Through Low Speed Model," ASME J. Enginnering for Gas Turbines and Power, Vol. 107, pp. 354-363 https://doi.org/10.1115/1.3239730
  2. Emmons, H. W., Pearson, C. E. and Grant, H. P., 1955, "Compressor Surge and Stall Propagation," ASME Transactions, Vol. 77, pp. 455-469
  3. Greitzer, E.M., 1976, "Surge and Rotating Stall in Axial Flow Compressors, Part I: Theoretical Compression System Model, Part II: Experimental Results and Comparison with Theory," ASME J. Engineering for Power, Vol. 98, pp. 190-217 https://doi.org/10.1115/1.3446138
  4. Moore, F. K. and Greitzer, E. M., 1986, "A Theory of Post-Stall Transients in Axial Compression Systems: Part 1 - Development of Equations," J. Engineering for Gas Turbines and Power, Vol. 108, pp. 68-76 https://doi.org/10.1115/1.3239887
  5. Greitzer, E. M. and Moore, F. K., 1986, "A Theory of Post-Stall Transients in Axial Compression Systems: Part 2 - Application," J. Engineering for Gas Turbines and Power, Vol. 108, pp. 231-239 https://doi.org/10.1115/1.3239893
  6. McDougall, N. M., Cumpsty, N. A. and Hynes, T. P., 1990, "Stall Inception in Axial Compressors, " J. Turbomachinery, Vol. 112, pp. 116-125 https://doi.org/10.1115/1.2927406
  7. Wisler, D. C., 1981, "Core Compressor Exit Stage Study, Volume IV : Data and Performance Report for the Best Stage Configuration," NASA CR-165357
  8. Mailach, R. and Vogeler, K., 2007, "Unsteady Aerodynamic Blade Excitation at the Stability Limit and During Rotating Stall in an Axial Compressor," ASME J. Turbomachinery, Vol. 129, No. 3, pp. 503-511 https://doi.org/10.1115/1.2720486
  9. Wellborn, S. R. and Okiishi, T. H., 1999, "The Influence of Shrouded Stator Cavity Flows on Multistage Compressor Performance," ASME J. Turbomachinery, Vol. 121, pp. 486-498 https://doi.org/10.1115/1.2841341
  10. Camp, T. R. and Day, I. J., 1998, "A Study of Spike and Modal Stall Phenomena in a Low Speed Axial Compressor," ASME J. Turbomachinery, Vol. 120, pp. 393-401 https://doi.org/10.1115/1.2841730
  11. Fringe, R. and Van Den Braembussche, R., 1984, "Distinction Between Different Types of Impeller and Diffuser Rotating Stall in a Centrifugal Compressor With Vanless Diffuser," ASME J. Turbomachinery, Vol. 106, No. 2, pp. 468-474

피인용 문헌

  1. vol.12, pp.1, 2009, https://doi.org/10.5293/KFMA.2009.12.1.065