INVESTIGATION OF RUNNING BEHAVIORS OF AN LPG SI ENGINE WITH OXYGEN-ENRICHED AIR DURING START/WARM-UP AND HOT IDLING

  • Xiao, G. (Institute of Internal Combustion Engine, Shanghai Jiaotong University) ;
  • Qiao, X. (Institute of Internal Combustion Engine, Shanghai Jiaotong University) ;
  • Li, G. (Institute of Internal Combustion Engine, Shanghai Jiaotong University) ;
  • Huang, Z. (Institute of Internal Combustion Engine, Shanghai Jiaotong University) ;
  • Li, L. (School of Automotive Studies, Tongji University)
  • Published : 2007.08.31

Abstract

This paper experimentally investigates the effects of oxygen-enriched air (OEA) on the running behaviors of an LPG SI engine during both start/warm-up (SW) and hot idling (HI) stages. The experiments were performed on an air-cooled, single-cylinder, 4-stroke, LPG SI engine with an electronic fuel injection system and an electrically-heated oxygen sensor. OEA containing 23% and 25% oxygen (by volume) was supplied for the experiments. The throttle position was fixed at that of idle condition. A fueling strategy was used as following: the fuel injection pulse width (FIPW) in the first cycle of injection was set 5.05 ms, and 2.6 ms in the subsequent cycles till the achieving of closed-loop control. In closed-loop mode, the FIPW was adjusted by the ECU in terms of the oxygen sensor feedback. Instantaneous engine speed, cylinder pressure, engine-out time-resolved HC, CO and NOx emissions and excess air coefficient (EAC) were measured and compared to the intake air baseline (ambient air, 21% oxygen). The results show that during SW stage, with the increase in the oxygen concentration in the intake air, the EAC of the mixture is much closer to the stoichiometric one and more oxygen is made available for oxidation, which results in evidently-improved combustion. The ignition in the first firing cycle starts earlier and peak pressure and maximum heat release rate both notably increase. The maximum engine speed is elevated and HC and CO emissions are reduced considerably. The percent reductions in HC emissions are about 48% and 68% in CO emissions about 52% and 78%; with 23% and 25% OEA, respectively, compared to ambient air. During HI stage, with OEA, the fuel amount per cycle increases due to closed-loop control, the engine speed rises, and speed stability is improved. The HC emissions notably decrease: about 60% and 80% with 23% and 25% OEA, respectively, compared to ambient air. The CO emissions remain at the same low level as with ambient air. During both SW and HI stages, intake air oxygen enrichment causes the delay of spark timing and the increased NOx emissions.

Keywords

References

  1. Bielaczyc, P. and Merkisz, J. (1997). Exhaust emission from passenger cars during engine cold start and warmup. SAE Paper No. 970740
  2. Bielaczyc, P. and Merkisz, J. (1999). Euro III/Euro IV emissions: Study of cold-start and warm-up phases with a SI (spark ignition) engine. SAE Paper No. 1999-01- 1073
  3. Callaghan, K., Nemser, S. and Johanson, W. (1999). Oxygen enriching membranes for reduced cold start emissions. SAE Paper No. 1999-10-1232
  4. Choi, H., Lim, K. and Min, K. (2005). Simulation of knock with different piston shapes in a heavy-duty LPG engine. Int. J. Automotive Technology 6, 2, 133-139
  5. Choi, M., Sun, H. and Lee, C. (2000). The study of HC emission characteristics and combustion stability with spark timing retard at cold start in gasoline engine vehicle. SAE Paper No. 2000-01-1082
  6. Deng, B. Q., Li, L. G. and Xiao, Z. C. (2003). LPG Pressure Regulator. Utility Patent of P.R.C. ZL03211793.0
  7. Isherwood, K. D., Linna, J. and Loftus, P. (1998). Using on-board fuel reforming by partial oxidation to improve SI engine cold-start performance and emissions. SAE Paper No. 980939
  8. Kajitani, S., Sawa, N. and McComiskey, T. (1992). A spark ignition engine operated by oxygen enriched air. SAE Paper No. 922174
  9. Lee, S. W. and Daisho, Y. (2004). Spray characteristics of directly injected LPG. Int. J. Automotive Technology 5, 4, 239-245
  10. Li, G., Li, L. G. and Qiao, X. Q. (2006). Oxygen-enriched combustion of the first cycle during cold start in a liquefied petroleum gas spark-ignition engine. Proc. Institution of Mechanical Engineers, Part D: J. Automobile Engineering 220, 9, 1265-1274 https://doi.org/10.1243/09544070JAUTO277
  11. Maxwell, T. T., Jones, J. C. and Setty, V. (1993). The effect of oxygen enriched air on the performance and emissions of an internal combustion engine. SAE Paper No. 932804
  12. Ng, H. K., Sekar, R. R. and Kraft, S. W. (1993). The potential benefits of intake air oxygen enrichment in spark ignition engine powered vehicle. SAE Paper No. 932803
  13. Poola, R. B., Ng, H. K. and Sekar, R. R. (1995). Utilizing intake-air oxygen-enrichment technology to reduce cold-phase emissions. SAE Paper No. 952420
  14. Poola, R. B., Sekar, R. R. and Ng, H. K. (1996). The effects of oxygen-enriched intake air on FFV exhaust emissions using M85. SAE Paper No. 961171
  15. Quader, A. A. (1978). Exhaust emissions and performance of a spark ignition engine using oxygen enriched intake air. Combustion Science and Technology, 19, 81-86 https://doi.org/10.1080/00102207808946869
  16. Russ, S., Thiel, M. and Lavoie, G. (1999). SI engine operation with retarded ignition: Part 2-HC emissions and oxidation. SAE Paper No. 1999-01-350
  17. Sekar, R. R. and Poola, R. B. (1997). Demonstration of Oxygen-enriched Combustion System on a Light-duty Vehicle to Reduce Cold-start Emissions. Argonne National Lab. Report ANL/ES/CP 92916; CONF-970639-2
  18. Shen, H., Shamim, T. and Sengupta, S. (1999). An investigation of catalytic converter performances during cold starts. SAE Paper No. 1999-01-3473
  19. Tang, X. (2000). An artificial UEGO sensor for engine cold start-Methodology, design, and performance. SAE Paper No. 2000-01-0541
  20. Wartinbee, W. J. Jr. (1971). Emissions study of oxygenenriched air. SAE Paper No. 710606