Composites Research

  • 제20권3호
  • /
  • Pages.55-62
  • /
  • 2007
  • /
  • 2288-2103(pISSN)
  • /
  • 2288-2111(eISSN)
한국복합재료학회 (The Korean Society for Composite Materials)
권호 표지
DOI QR코드

DOI QR Code

미세역학적시험법과 음향방출을 이용한 Jute 및 Hemp 섬유/폴리프로필렌 복합재료의 내구성 및 계면 평가

Interfacial and Durability Evaluation of Jute and Hemp Fiber/Polypropylene Composites Using Micromechanical Test and Acoustic Emission

  • 김평기 (경상대학교 나노.신소재공학부 고분자공학) ;
  • 장정훈 (경상대학교 나노.신소재공학부 고분자공학) ;
  • 김성주 (경상대학교 나노.신소재공학부 고분자공학) ;
  • 황병선 (한국기계연구원 복합재료그룹) ;
  • 박종만 (경상대학교 나노.신소재공학부 고분자공학)
  • Published : 2007.06.30
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

Abstract

Jute와 Hemp 섬유/폴리프로필렌 (PP)의 내구성 및 계면 평가는 끓는 물 실험 전 후로 해서 조사되었고 끓는 물 실험 전 후에 따른 Jute와 Hemp 섬유의 수분함량은 TCA를 통해 측정되었다. 끓는 물 실험 후, Jute, Hemp섬유와 폴리프로필렌 기지재 사이의 계면전단강도와 기계적 물성은 감소하였다. 반면에 물에 의해 부풀어 오른 미소섬유에 의해 미처리경우와 비교해서 접착일은 증가를 하였다. 그리고 끓는 물 실험 전·후의 Jute, Hemp섬유와 폴리프로필렌의 표면에너지는 동 접촉각을 통해 얻어졌다. 계면전단강도는 항상 열역학의 접착일과 일치하지는 않는다. 끓는 물 내에서, Jute와 Hemp 섬유는 물에 의해 부풀어지게 된다. 그래서 표면적과 수분 침투공간이 증가한다. 끓는 물 실험 전 후의 Jute와 Hemp 섬유 미세파괴 경향은 명백하게 다르다. Jute와 Hemp 섬유/폴리프로필렌 복합재의 환경적 영향에 의한 미세파괴 형태는 광학 현미경을 통한 관찰과 음향 방출 수와 에너지에 의해 상호 일치함을 보여주었다. 끓는 물 실험 이후, Jute 섬유는 Hemp 섬유와 달리 부풀어진 피브릴에 의한 낮은 인장강도에서 나타나는 미세파괴 형태를 보여주었다. 또한, 부풀어진 피브릴에 의해 미세파괴시 음향 방출 수는 증가를 하였으며, AE 진폭과 에너지는 감소하였다.

Interfacial evaluation and durability of Jute and Hemp fibers/polypropylene (PP) composites were investigated. Moisture content of various treated conditions were measured by thermogravimetic analyzer (TGA). After boiling water test, mechanical properties and IFSS between Jute, Hemp fibers and PP matrix decreased. On the other hand, work of adhesion increased due to swelled fibril by water. Surface energies of Jute and Hemp fibers before and after boiling water test were obtained using dynamic contact angle measurement. IFSS was not always consistent with thermodynamic work of adhesion. In boiling water case, since Jute and Hemp fibers could be swelled by water, surface area and moisture infiltration space increased. Environmental effect on microfailure modes of Jute or Hemp fibers and Jute or Hemp fibers/PP composites were obtained by observing via optical microscope and by monitoring acoustic emission (AE) events and their AE parameters. After boiling water test, unlike Hemp fiber, microfailure process of Jute fiber could occur due to low tensile strength by swelled fibril. In addition, AE events occurred more and AE amplitude and energy became lower than those of before boiling water test.

Keywords

References

  1. J. M. Felix, P. Gatenholm, 'The Nature if Adhesion in Composites of Modified Cellulose Fibers and Polypropylene,' J. Appl. polym. Sci., Vol. 42, 1991, pp. 609 https://doi.org/10.1002/app.1991.070420307
  2. S. J. Eichhorn, C. A. Baillie, N. Zafeiropoulos, L. Y Maikambo, M. P. Ansell, A. Dufresne, et al., 'Current International Research into Cellulosic Fibres and composites,' J. Mater Sci., Vol. 36, 2001, pp. 2107 https://doi.org/10.1023/A:1017512029696
  3. S. Wong, R. Shanks and A. Hodzic, 'Interfacial Improvements in Poly(3hydroxybutyrate)-flax Fibre Composites with Hydrogen Bonding Additives,' Composites Sci. and Technol., Vol. 64, 2004, pp. 1321-1330 https://doi.org/10.1016/j.compscitech.2003.10.012
  4. J. gassan, 'A Study of Fibre and Interface Parameters Affecting the Fatifue Behaviour of Natural Fibre Composites,' Compo. Part A, Vol. 33, 2002, pp. 369-374 https://doi.org/10.1016/S1359-835X(01)00116-6
  5. M. Baiardo, E. Zini and M. Scandola, 'Flax fibre-polyester Composites,' Compos. Part A, Vol. 35, 2004, pp. 703-710 https://doi.org/10.1016/j.compositesa.2004.02.004
  6. J. Gassan and A. K. Biedzki, The Influence of Fiber Surface Treatment on the Mechanical Properties of Jutepolypropylene Composites, Compos. Part A 1997;28A:1001-1005
  7. C. Baley, 'Analysis of the Flax Fibres Tensile Behaviour and Analysis of the Tensile Stiffness Increase,' Compos. Part A, Vol. 33, 2002, pp. 939-948 https://doi.org/10.1016/S1359-835X(02)00040-4
  8. C. Yi, F. Julio, Davalos, R. Indrajut, H. Y. Kim, 'Accelerated Aging Test for Evaluations of Durability Performance of FRP Reinforcing Bars for Concrete Structures,' Compos. struct., Vol. 78, 2007, pp. 110-111
  9. N. Dilsiz and J. P. Wightman, 'Effect of Acid-base Properties of Unsized and Size Carbon Fibers on Fiber/epoxy Matrix Adhesion,' Colloid and surface A, Vol. 164, 2000, pp. 325-336 https://doi.org/10.1016/S0927-7757(99)00400-8
  10. K. V. Velde and P. Kiekens, 'Wettability of natural fibres used as reinforcement for composites,' Die Angewandle Markromolekelare Chemie, Vol. 272, 1999, pp. 87-93 https://doi.org/10.1002/(SICI)1522-9505(19991201)272:1<87::AID-APMC87>3.0.CO;2-Q
  11. J. M. Park, T. Q. Son, J. G. Jung, and B. S. Hwang, 'Interfacial Evaluation of Single Ramie and Kenaf Fiber/epoxy Resin Composites using Micromechanical Test and Nondestructive Acoustic Emission,' Compos. lnterf., Vol. 13(2-3), 2006, pp. 105-129 https://doi.org/10.1163/156855406775997051
  12. J. M. Park, D. S. Kim and S. R. Kim, 'Improvement of Interfacial Adhesion and Nondestructive Damage Evaluation for Plasma Treated PBO and Kevlar Fibers/ epoxy Composites using Micromechanical Techniques and Surface Wettability,' J. Colloid Interf Sci., Vol. 64, 2003, pp. 431-445
  13. G Romhany, J Karger-Kocsis and T. Czigany, 'Tensile Fracture and Failure Behavior of Technical Flax Fibers,' J. Applied Polymer Sci., Vol. 36, 2003, pp. 3638-3645
  14. J. M. Park, D. S. Kim and S. R. Kim, 'Interfacial Properties and Microfailure Degradation Mechanisms of Bioabsorbable Fiberspoly-Llactidecorrposites using Micromechanical and Test and Nondestructive Acoustic Emission,' Compos. Sci. Technol., Vol. 63, 2003, pp. 403-419 https://doi.org/10.1016/S0266-3538(02)00212-9
  15. T. H. Jung, R. V. Subramanian and V. S. Manoranjan, 'Prediction of Fibre Strength at the Critical Length: a Simulation Theory and Experimental Verification for Bimodally Distributed Carbon Fibre Strengths,' J. Mater Sci., Vol. 28, 1993, pp. 4489-4496
  16. Z Ahmed, M. S. Haque, F. Akhter, 'Study of the Chemical Composition of Different Pipeline Varieties of Jute Fibres,' Pakistan J. Biological Sci., Vol. 6:16, 2003, pp. 1463-1467
  17. A. B. Thomsen, A. Thygesen, V Bohn, K. V. Nielsen, B. Pallesen, and M. S. Jorgensen, 'Effects of Chemicalphysical Pre-treatement Processes on Hemp Fibres for Reinforcement of Composites and for Textiles,' Ind Crop. Prod., Vol. 24, 2006, pp. 113-118 https://doi.org/10.1016/j.indcrop.2005.10.003