Computers and Concrete

  • 제4권3호
  • /
  • Pages.187-206
  • /
  • 2007
  • /
  • 1598-8198(pISSN)
  • /
  • 1598-818X(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Nonlinear finite element analysis of high strength concrete slabs

  • Smadi, M.M. (Department of Civil Engineering, Faculty of Engineering, Jordan University of Science and Technology) ;
  • Belakhdar, K.A. (Department of Civil Engineering, Faculty of Engineering, Jordan University of Science and Technology)
  • 투고 : 2006.09.18
  • 심사 : 2007.05.02
  • 발행 : 2007.06.25
⟨ 이전 논문 다음 논문 ⟩

초록

A rational three-dimensional nonlinear finite element model is described and implemented for evaluating the behavior of high strength concrete slabs under transverse load. The concrete was idealized by using twenty-nodded isoparametric brick elements with embedded reinforcements. The concrete material modeling allows for normal (NSC) and high strength concrete (HSC), which was calibrated based on experimental data. The behavior of concrete in compression is simulated by an elastoplastic work-hardening model, and in tension a suitable post-cracking model based on tension stiffening and shear retention models are employed. The nonlinear equations have been solved using the incremental iterative technique based on the modified Newton-Raphson method. The FE formulation and material modeling is implemented into a finite element code in order to carry out the numerical study and to predict the behavior up to ultimate conditions of various slabs under transverse loads. The validity of the theoretical formulations and the program used was verified through comparison with available experimental data, and the agreement has proven to be very good. A parametric study has been also carried out to investigate the influence of different material and geometric properties on the behavior of HSC slabs. Influencing factors, such as concrete strength, steel ratio, aspect ratio, and support conditions on the load-deflection characteristics, concrete and steel stresses and strains were investigated.

키워드

참고문헌

  1. ACI Committee 363R-92 (1997), "State-of-the-art report on high-strength concrete", (ACI 363R-92), 55.
  2. ACI Committee 435 (1991), "States of the art report on control of two way slab deflections", ACI Struct. J., 88(4), 501-514.
  3. Al-Shaarbaf, I. (1990), "Three-dimensional non-linear finite element analysis of reinforced concrete beams in torsion", PhD Thesis, University of Bradford.
  4. Attard, M. M. and Stewart, M. G. (1998), "A two parameter stress block for high-strength concrete", ACI Struct. J., 95(3), 305-317.
  5. Bahn, B. Y. and Hsu, T. T. C. (2000), "Cyclically and biaxially loaded reinforced concrete slender columns", ACI Struct. J., 97(3), 444-454.
  6. Belakhdar, K. A. M. (2006), "Three dimensional nonlinear finite element analysis of high strength reinforced concrete slabs", M.Sc Thesis, Faculty of Graduate Studies, Jordan University of Science and Technology, Irbid, Jordan, 188.
  7. Cervera, M. and Hinton, E. (1986), "Nonlinear analysis of reinforced concrete plates and shells using a three dimensional modeling of reinforced concrete structures", Pineridge Press, Swansea, UK, 327-370.
  8. Chen, W. F. and Saleeb, A. F. (1982), "Constitive equations for engineering material", John Wiley & Sons, New York, V. 1, 580.
  9. Chung, W. and Ahmed, H. (1994), "Model for shear critical high strength concrete beams", ACI Struct. J., 91(1), 31-41.
  10. Crisfield, M. A. (1994), "Nonlinear finite element analysis of solids and structures", Department of Aeronautics, Imperial College of Science, Technology and Medicine, London, UK, John Wiley & Sons, v. 1, 345.
  11. Dahl, K. K. B. (1992), "Uniaxial stress-strain curves for normal and high strength concrete", ABK Report No.R282, Department of Structural Engineering, Technical University of Denemark.
  12. Deaton, J. B. (2005), "A finite element approach to reinforced concrete slab design", M.Sc Thesis, School of Civil and Environmental Engineering, Georgia Institute of Technology, 170.
  13. Fields, K. and Bischoff, P. (2004), "Tension stiffening and cracking of high-strength reinforced concrete tension members", ACI Struct. J., 101(4), 447-456.
  14. Figueiras, J. A. and Owen, R. J. (1984), "Nonlinear analysis of reinforced concrete shell structures", Proceedings of the International Conference on Computer Aided Analysis and Design of Concrete Structures, Yogoslavia.
  15. Foster, S. J., Budiono, B. and Gilbert, R. I. (1996), "Rotating Crack Finite Element Model For Reinforced Concrete Structures", Comput. Struct., 58(1), 43-50. https://doi.org/10.1016/0045-7949(95)00109-T
  16. Hussein, A. and Marzouk, H. (2000), "Behavior of high-strength concrete under biaxial stresses", ACI Mater. J., 97(1), 27-36.
  17. Jiang, J. and Mirza, F. (1997), "Nonlinear analysis of reinforced concrete slabs by discrete finite element approach", Comput. Struct., 65(4), 1667-1687.
  18. Kwak, H. G. and Filippou, F. C. (1990), "Finite element analysis of reinforced concrete structures under monotonic loads", Structure Engineering Mechanics and Materials,. Report No.USB/SEMM-90/14, Department of Civil Engineering, University of California, Berkely, 120.
  19. Marzouk, H. and Chen Z. (1993), Finite element analysis of high strength concrete slabs: ACI Struc. J., 90(5), 505-513.
  20. Marzouk, H. and Jiang, D. (1996), "Finite element evaluation of shear enhancement of high strength concrete plates", ACI Struct. J., 93(6), 667-673.
  21. Murray, K. A., Cleland, D. J. and Gilbert, S. (2005), "The development of non-linear numerical model to simulate the behaviour of reinforced concrete flat slabs in the vicinity of edge columns", Construct. Bldg. Mater., 19, 703-712. https://doi.org/10.1016/j.conbuildmat.2005.02.019
  22. Naji, J. H. (1989), "Non-linear finite element analysis of reinforced concrete panels and infilled frames under monotonic and cyclic loading", PhD Thesis, University of Bradford.
  23. Pang, X. B. and Hsu. T. T. C. (1996), "Fixed angle softened truss model for reinforced concrete", ACI Struct. J., 93(2), 197-207.
  24. Polak, M. A. (2005), "Ductility of reinforced concrete flat slab-column connections", Comput Aided Civ. Infrastruct. Eng., 20, 184-193. https://doi.org/10.1111/j.1467-8667.2005.00386.x
  25. Polak, M.A. (1998), "Modelling punching shear of reinforced concrete slabs using layered finite elements", ACI Struct. J., 95(1), 71-80.
  26. Reitman, M. and Yankelevsky, D. (1997), "A new simplified model for nonlinear RC slabs analysis", ACI Struct. J., 94(4), 399-408.
  27. Salim, W. and Sebastian, W. (2002), "Plasticity model for predicting punching shear strengths of reinforced concrete slabs", ACI Struc. J., 99(6), 827-835.
  28. Sam, C. and Lyer, P. K. (1995), "Nonlinear finite element analysis of reinforced concrete four pile caps", Comput. and Struct., 57(4), 605-622. https://doi.org/10.1016/0045-7949(95)00068-R
  29. Shanmugam, N. E., Kumar, G. and Thevendram, V. (2002), "Finite element modeling of double skin composite slabs", Fin. Elements in Anal. and Des., 38, 579-599. https://doi.org/10.1016/S0168-874X(01)00093-2
  30. Staller, D. (2000), "Analytical studies and numerical analysis of punching shear failure in reinforced concrete slabs", TRITA-BKN Bulletin, 57, 8.
  31. Thabet, A. and Haldane, D. (2000), "Three-dimensional simulation of nonlinear response of reinforced concrete members subjected to impact loading", ACI Struct. J., 97(5), 698-702.
  32. Tomaszewicz, A. (1993), "High-strength concrete", SP2 (Plates and Shells, Report 2.3, Punching Shear Capacity of Reinforced Concrete Slabs; Report No. STF70A93082): SINTEF, Trondheim, 36.
  33. Vainiunas, P., Popovas, V. and Vilnius, A. J. (2004), "Nonlinear FEA of RC floor slab-to-column joint connection", Theoretical Foundations of Civil engineering-XII, Ed. by W. Szczesninak, OW PW, Warsaw, 12.
  34. Vecchio, F. and Collins, M. (1986), "The modified compression field theory for reinforced concrete element subjected to shear", ACI J., 83(2), 219-231.
  35. Vecchio, F., Collins, M. and Aspiotis, J. (1994), "High strength concrete elements subjected to shear", ACI Struct. J., 91(4), 423-433.
  36. Vidosa, F., Kotsovos, M. and Pavlovic, M. (1988), "Symmetrical punching of reinforced concrete slabs: an analytical investigation based on NFE modelling", ACI Struct. J., 85(2), 241-250.
  37. Wang, T. and Hsu, T. C. C. (2001), "Nonlinear finite element analysis of concrete structures using new constitutive models", Comput. Struct., 79, 2781-2791. https://doi.org/10.1016/S0045-7949(01)00157-2

피인용 문헌

  1. A 3D finite element model for reinforced concrete structures analysis vol.4, pp.4, 2011, https://doi.org/10.1590/S1983-41952011000400002
  2. Finite element analysis of initially damaged beams repaired with FRP plates vol.134, 2015, https://doi.org/10.1016/j.compstruct.2015.07.124
  3. Strength capacity of simply supported circular concrete slab vol.44, pp.5, 2013, https://doi.org/10.1002/mawe.201300145
  4. A tension stiffening model for analysis of RC flexural members under service load vol.17, pp.1, 2016, https://doi.org/10.12989/cac.2016.17.1.029
  5. Nonlinear analysis of concrete shells including effects of normal and transverse shear stresses vol.45, pp.4, 2014, https://doi.org/10.1002/mawe.201400225
  6. Static And Dynamic Characteristics Of Waste Ceramic Aggregate Fibre Reinforced Concrete vol.15, pp.2, 2015, https://doi.org/10.1515/tvsb-2015-0005
  7. Non-linear finite element analysis of reinforced concrete members and punching shear strength of HSC slabs vol.149, pp.2261-236X, 2018, https://doi.org/10.1051/matecconf/201714902056
  8. Non-linear finite element analysis of reinforced concrete members and punching shear strength of HSC slabs vol.149, pp.2261-236X, 2018, https://doi.org/10.1051/matecconf/201814902056
  9. Elucidating the mechanical behavior of ultra-high-strength concrete under repeated impact loading vol.37, pp.1, 2007, https://doi.org/10.12989/sem.2011.37.1.001
  10. Finite element investigation of the joints in precast concrete pavement vol.21, pp.5, 2007, https://doi.org/10.12989/cac.2018.21.5.547