주축 런아웃이 절삭흔과 표면거칠기에 미치는 영향에 관한 연구

A Study on the Spindle Run-out Effects on Cutter Mark and Surface Roughness

  • 황영국 (창원대학교 기계설계공학과 대학원) ;
  • 이춘만 (창원대학교 기계설계공학과)
  • 발행 : 2007.04.15

초록

The radial error motion of a machine tool cutter/spindle system is critical to the dimensional accuracy of the parts to be machined. This paper presents an investigation into spindle run-out effects on cutting mark and surface roughness. We experimented the effects of spindle run-out on surface roughness in flat-end milling by cutting AL 7075 workpiece in various cutting conditions. In order to analyze the effects of run-out on the surface roughness, the spindle's radial error motions was measured by mounting a sphere target onto the spindle as a reference. From the experimental results, it was found that spindle un-out makes a directive effects on surface roughness in flat-end milling.

키워드

참고문헌

  1. Geoffrey Boothroyd, Winston Knight, 2006, Fundamentals of Machining and Machine Tools, Taylor & Francis
  2. Kline, W. A. and Devor, R. E., 1983, 'The Effect of Runout on Cutting Geometry and Forces in End Milling,' International Journal of Mach. Tools Des. Res., pp. 123-140
  3. Instruction Manual of SEA Version 8, Lion Precision
  4. Wasawat, N.,, Lin, C. W. and Tu, J. F., 2006, 'A new method to quantify radial error of a motorized end-milling cutter/spindle system at very high speed rotations,' International Journal of Machine Tools & Manufacture, pp. 877-889
  5. Ning, L., Martin, L. and Andrew, W., 2005, 'Surface finish visualisation in high speed, ball nose milling applications,' International Journal of Machine Tools & Manufacture, pp. 1152-1161
  6. Kim, B. K., Kim, K. S., Lee, D. W. and Kim, J. S., 1997, 'Evaluation of Workability through Runout in End Milling,' KSPE conference proc., pp. 165-168
  7. Kim, J. D., 1996, 'Detection and Estimation of Spindle Accuracy of Machine Tools by Non-contact Type Sensor,' Journal of the Korean Society of Machine Tool Engineers, Vol. 5, No. 2, pp. 9-19
  8. Kim, B. K., Lee, G. Y., Lee, D. W. and Kim, J. S., 1997, 'Prediction of Surface Roughness through Measuring Runout in High-speed Ball-End Milling,' KSPE conference proc., pp. 889-893