Design & Manufacturing
- 제1권1호
- /
- Pages.13-16
- /
- 2007
- /
- 2800-0323(pISSN)
- /
- 2733-452X(eISSN)
사출성형시 불균형 충전에 관한 다구찌 실험계획법을 이용한 성형공정의 최적화
On the new mold structure with multi-point gate for filling-balance mold
- Hong, Youn-Suk (Graduate School of Mechanical Engineering, Pukyong National University) ;
- Han, Dong-Hyup (Graduate School of Mechanical Engineering, Pukyong National University) ;
-
Jeong, Yeong Deug
(School of Mechanical Engineering, Pukyong National University)
- 투고 : 2007.02.21
- 심사 : 2007.05.27
- 발행 : 2007.12.01
초록
Almost all injection molds have multi-cavity runner system for mass production, which are designed with geometrically balanced runner system in order to accomplish filling balance between cavity to cavity during processing. However, even though geometrically balanced runner is used, filling imbalance have been observed. Filling imbalance could be decreased by modifying processing conditions such as injections rate, mold temperature, injection pressure, melt temperature that are related to shear, viscosity. In this study, a series of experiment was conducted to investigate filling imbalance variation when modifying runner layout and polymer and to determine which processing condition influences as the primary cause of filling imbalance in geometrically balanced runner system.
키워드