Abstract
To detect individual vehicular speed, double loop detection technique has been widely used. This paper investigates four methodologies to measure individual speed using only a single loop sensor in a traveling lane. Two methods developed earlier include estimating the speed by means of (Case 1) the slop of inductance wave form generated by the sensor and (Case 2) the average vehicle lengths. Two other methods are newly developed through this study, which are estimations by measuring (Case 3) the mean of wheelbases using the sensor installed traversal to the traveling lane and (Case 4) the mean of wheel tracks by the sensor installed diagonally to the traveling lane. These four methodologies were field-tested and their accuracy of speed output was compared statistically. This study used Equality Coefficient and Mean Absolute Percentage Error for the assessment. It was found that the method (Case 1) was best accurate, followed by method (Case 4), (Case 2), and (Case 3).
노면에 차량 검지센서를 설치하여 개별차량의 속도자료를 수집하는 경우, 일반적으로 일정거리가 이격되게 설치한 두 개 이상의 차량 검지센서간의 반응시간을 활용하여 차량의 속도를 산출하게 된다. 본 논문에서는 차로당 센서 1개만을 설치하여 개별차량의 속도 산출을 함에 있어, 기존 방법인 파형의 기울기를 이용하여 속도 추정하는 방법(Case 1)과 평균차량길이를 적용한 속도산출(Case2), 새로 고안한 방법인 단일 테이프스위치(Tape Switch) 센서를 수평형으로 설치하고 평균축거를 적용하여 속도 추정하는 방법(Case 3), 그리고 테이프스위치 센서를 사선형으로 설치하고 차량의 평균윤거(Mean of tread)를 적용하여 속도 추정하는 방법(Case 4)에 대한 속도 추정정확도를 평가하였다. 4가지 방식 각각에 대해 현장에서 센서를 설치하고 기준값과 속도추정 값을 비교 분석을 했으며, 평가지표로는 등가계수(Equality Coefficient), 절대오차백분율(MAPE)을 통하여 평가하였다. 평가결과는 Case1 > Case 4 > Case 2, 3 순으로 양호한 결과를 보이는 것으로 분석되었다.