DOI QR코드

DOI QR Code

Effect of Local Strain on Low Cycle Fatigue using ESPI System

ESPI System을 이용하여 측정한 국부 변형률이 저사이클 피로수명에 미치는 영향에 관한 연구

  • Kim, Kyung-Su (Dept. of Naval Architecture Engineering, Inha University) ;
  • Kim, Ki-Sung (Dept. of Naval Architecture Engineering, Inha University) ;
  • Kwon, Jung-Min (Dept. of Naval Architecture Engineering, Inha University) ;
  • Park, Seong-Mo (Dept. of Naval Architecture Engineering, Inha University) ;
  • Kim, Beom-Il (Dept. of Naval Architecture Engineering, Inha University)
  • 김경수 (인하대학교 선박해양공학과) ;
  • 김기성 (인하대학교 선박해양공학과) ;
  • 권정민 (인하대학교 선박해양공학과) ;
  • 박성모 (인하대학교 선박해양공학과) ;
  • 김범일 (인하대학교 선박해양공학과)
  • Published : 2006.04.01

Abstract

Low cycle fatigue cracks are mainly detected at discontinuous welded locations with high stresses under repeated cyclic static loads due to cargo leading and unloading. Theoretical and analytical methods have been used for evaluation of local stress and strain which have an effect on a prediction of fatigue life, but those have difficulties of considering stress concentration at notched location and complicated material behavior of welded joint or heat affected zone. Electronic speckle pattern interferometry(ESPI) system is nondestructive and non-contact measurement system which can get the relatively accurate full field strain at critical positions such as welded zone and structural discontinuous location. In this study, local strain was measured on welded cruciform joint by ESPI system and then low cycle fatigue test was performed. Effect of local strain on low cycle fatigue life was examined by measured values using ESPI system. Moreover, experimental fatigue life was compared with established S-N curves using theoretical local strain and stress calculated by Neuber's rule.

Keywords

References

  1. 강성원, 하우일, 신종석, 제정신, 1996, '필렛용접 이음부의 응력집중계수에 관한 연구' 대한조선학회 논문집, 제 33 권, 제 3 호, pp.1-7
  2. 김경수, 신병천, 심천식, 박진영, 조형민, 2003, '과대하중이 피로수명에 미치는 영향 에 관한 연구' 대한조선학회 논문집, 제 40 권, 제 3 호, PP. 45-53
  3. 임재용, 홍성구, 이순복, 2004, '국부 변형률 근사를 이용한 원통형 노치시편의 피로균열 발생수명의 예측' 대한기계학회 논문집 A권, 제 28 권. 제 6 호, pp. 791-798 https://doi.org/10.3795/KSME-A.2004.28.6.791
  4. 조규남, 장영식, 하우일, 장창두, 강성준, 남 동호, 1991, '해양 구조물 튜불러 조인트의 피로 해석에 대한 연구,' 대한조선학회 논문집, 제 28 권, 제 2 호, pp. 285-293
  5. 조상명, Horikawa. K, 1991, '박용재료의 반 복경화 및 피로특성에 관한 연구,' 대한조선학회 논문집, 제 28 권, 제 1 호, pp. 108-116
  6. ASTM E606-92, 1998, Standard Practice for Strain-Controlled Fatigue Testing, In: Annual book of ASTM standards, Philadelphia, ASTM, pp. 557-571
  7. British Standard Institute , 1997, 'Specification for Unfired Fusion Welded Pressure Vessels, BS5500,' Annex C
  8. Heo, J.H. , Kang, J.K., Kim, Y.I., Yoo, I.S., Kim, K.S., Urm, H.S., 2004, 'A StudY on the Design Guidance for Low Cycle Fatigue in the Ship Structure,' PRADS, pp. 782-789
  9. JSME(Japan society of mechanical Engineers), 1982, The Fatigue Strength of Low Cycle, In: Design Manual IV about Ultimate Strength of Metallic Material. Tokyo
  10. Toubal, L., Karama, M. and Lorrain, B., 2005, 'Stress Concentration in a Circular Hole in Composite Plate,' Composite Structures 68, pp. 31- 36 https://doi.org/10.1016/j.compstruct.2004.02.016
  11. Veritas, N., 2003, Fatigue Assessment of Ship Structures, Classification Notes, No. 30.7