A Study of the Driveability Improvement on the Electronic Throttle Control M/T Vehicle at Tip-in/out

스로틀 전자제어 방식 M/T차량의 가/감속 시 운전성 향상에 관한 연구

  • Park, Kyoung-Seok (School of Mechanical Engineering, Kumoh National Institute of Technology) ;
  • Lee, Jong-Hwa (Division of Mechanical Engineering, Ajou University) ;
  • Park, Jin-Il (Division of Mechanical Engineering, Ajou University)
  • Published : 2006.03.01

Abstract

The passenger car drivers want in general to feel good driveability, but they sometimes feel uncomfortable by shock and jerk phenomena when they push or release acceleration pedal with clutch on state. In this paper, the shock and jerk characteristics are studied on the vehicles controlled by the throttle-by-wire system. Experiments and simulations were carried out on two vehicles which show different control characteristics. The engine torque control characteristics was analyzed by measuring cylinder pressure. Various specification factors of the vehicles and the torque control logic of the engines were simulated through experimental data basis. The result shows the spring effect of the trans-axle in the drive-train is one of the most important factors of the shock-jerk phenomena and the engine torque control method is also responsible for the reducing the shock-jerk amplitude. In this paper a new control logic of the engine torque is suggested for the better driveablility on the tip-in/out event.

Keywords

References

  1. H. B. Song, Y. J. Choi, J. H. Lee, H. S. Cho and N. H. Cho, 'An experimental Study of the Improvement of Driveability in Vehicle Acceleration Mode,' Transactions of KSAE, Vol.9, No.6, pp.65-75, 2001
  2. Y. J. Choi, H. B. Song, J. H. Lee, H. S. Cho and N. H. Cho, 'A Study of the Control Logic Development of Driveability Improvement in Vehicle Acceleration Mode,' Transactions of KSAE, Vol.10, No.2, pp.101-109, 2002
  3. K. H. Ko, 'Analysis of Transient Response of an Engine to Throttle Tip-in/Tip-out,' Transactions of KSAE, Vol.10, No.4, pp.122-128, 2002
  4. J. B. Heywood, Internal Combustion Engine Fundamentals, McGraw Hill, New York, 1988
  5. T. J. Chung, D. P. Hong and S. S. Kim, 'A Study on Clutch-disc Characteristics for the Torsional Vibration Reduction of the Drive- Line at Creeping,' Transactions of KSAE, Vol.3, No.2, pp.102-111, 1995
  6. J. Baek, S. Park and M. Sunwoo, 'Indicated and Load Torque Estimation of SI-Engine using Cylinder Pressure Sensor,' Transactions of KSAE, Vol.11, No.5, pp.1-6, 2003