Thermal Fatigue Test of an Annular Structure

  • Hwang Jeong-Ki (School of Mechanical Engineering, Kyungpook National University) ;
  • Suh Chang-Min (School of Mechanical Engineering, Kyungpook National University) ;
  • Kim Chae-Ho (School of Mechanical Engineering, Kyungpook National University)
  • Published : 2006.01.01

Abstract

A half-scaled large test model for the main components of the real annular structure was built and the thermal behaviors were experimented and obtained by thermal cyclic loads. The model design and the test conditions for the thermal loads were determined to take into consideration the thermal and mechanical loads acting on the real annular structure by finite element analyses. Temperature profiles and strains of the main components of the model were measured at an early stage of the test and periodically throughout the test in the given test conditions. After completion of the thermal cyclic tests, no evidence of crack initiation and propagation were identified by a dye penetration test. The measured strains at the critical parts were slightly increased proportionally with the increase in the number of the thermal cycles.

Keywords

References

  1. ANSYS, 2001, 'User's Manual,' ANSYS Inc.
  2. Holman, J. P., 1986, Heat Transfer, Chapter 6, McGraw-Hill, New York
  3. Hwang, J. K., Kim, I. Y. and Choi, T. S., 2004, 'Development of Permanent Reactor Cavity Seal Assembly for Operating Nuclear Power Plants,' Proceedings of the 2004 International Congress on Advances in Nuclear Power Plants, pp. 800-804, ICAPP'04, Pittsburgh, USA
  4. Korea Electric Company, Final Safety Analysis Report - Kori Nuclear Power Plant Unit No.2, Chapter 3
  5. Korea Electric Company, Preliminary Safety Analysis Report - Korea Nuclear Units 7 & 8, Chapter 3
  6. Suh, C. M., Lee, J. J. and Kang, Y. G., 1990, 'Fatigue Microcracks in Type 304 Stainless Steel at Elevated Temperature,' Fatigue Fract. Engng. Mater. Struct., Vol. 13-5 : pp. 487-496
  7. Suh, C. M., Lee, J. J., Kang, Y. G., Ahn, H. J. and Woo, B. C., 1992, 'A Simulation of the Fatigue Crack Process in Type 304 Stainless Steel at 538 C,' Fatigue Fract. Engng. Mater. Struct., Vol. 15-7, pp.671-684