Improvement of Chip Thickness Model in 2-flutes Slot End Milling

2날 엔드밀 슬롯 가공시 칩두께 모델의 개선

  • Published : 2005.01.01

Abstract

Generally, cutting force models use a sin function method to calculate chip thickness. In slot end milling, the error from a sin function method is much bigger than other machining because a tool rotation angle in cutting is much larger. Thus in this paper, a new method to calculate chip thickness was suggested and evaluated. In a new method, tool position data according to tool rotation are checked and stored so that it is possible correct chip thickness is calculated. Cutting force waveforms simulated from a sin function method and a new method and measured waveforms from experiments were compared and error percentages were obtained. Finally, a new method had good results for simulating cutting force in slot end milling.

Keywords

References

  1. Fuh, Kuang-Hug, 'A Predicted Milling Force Model for High-speed End Milling Operation,' International Journal of Machine Tools & Manufacturing, Vol. 37, pp.969-979, 1997 https://doi.org/10.1016/S0890-6955(96)00083-1
  2. Bayoumi, A. E., 'An Analytic Mechanistic Cutting Force Model for Milling Operations,' ASME Journal of Engineering for Industry, Vol. 116, pp. 324-330, 1994 https://doi.org/10.1115/1.2901948
  3. Lee, Sang-Kyu, Ko, Sung-Lim, 'Analysis of the Precision Machining in End Milling Operation by Simulating Surface Generation,' Journal of the KSPE, Vol. 16, No.4, pp. 229-236, 1999
  4. Lee, Ki-Yong, Kim, Jeong-Suk, 'The Prediction of Cutting Force and Surface Topography by Dynamic Force Model in End Milling,' Journal of the KSPE, Vol. 14, No.4, pp. 38-45, 1997
  5. Zhang, Lei, Zheng, Li, 'Prediction of Cutting Forces in Milling of Circular Corner Profiles,' International Journal of Machine Tools & Manufacture, Vol. 44, pp.225-235,2004 https://doi.org/10.1016/j.ijmachtools.2003.10.007
  6. Gradisek, Janez, Kalveram, Martin, 'Mechanistic Identification of Specific Force Coefficients for a general End Mill,' International Journal of Machine Tools & Manufacture, Vol. 44, pp. 401-414, 2004 https://doi.org/10.1016/j.ijmachtools.2003.10.001
  7. Tlusty, J., 'Dynamics of Cutting Forces in End Milling,' Annals of the CIRP, Vol. 44, pp. 21-25, 1975
  8. Tlusty, J., 'An Overview of Modeling and Simulation ofthe Milling Process,' ASME Journal of Engineering for Industry, Vol. 113, pp. 169-175, 1991 https://doi.org/10.1115/1.2899674
  9. Satou, Kiyohito, 切削加工 技術 テ一タ 集',' New Technology Development Center, 1983
  10. Lee, Ki-Yong, Kim, Jeong-Suk, 'Runout Modeling and Measurement Method in 4-flutes End Milling,' Journal of the KSPE, Vol. 21, No.3, pp. 22-29, 2004