참고문헌
- J. M. Atienza, J. Ruiz-Hervias, M. L. Martinez-Perez, F. J. Mompeam, M. Garcia-Hernandez, M. Elice, 2005, Residual stresses in cold ferritic rods, Scrip. Mater. Vol. 52, pp. 305-309 https://doi.org/10.1016/j.scriptamat.2004.10.010
- Y. Shiota, Y. Tomota, A. Moriai, T. Kamiyama, 2005, Structure and mechanical behavior of heavily drawn pearlite and martensite in a high carbon steel, Metals and Materials Int., Vol. 11, No.5, pp. 371-376 https://doi.org/10.1007/BF03027507
- P. Renz, W. Steuff, R. Kopp, January 1996, Possibilities of influencing residual stress in drawn wires and bars, Wire J. Int., pp. 64-69
- S. S. Vijayakar, November 1995, Optimization of die geometry and drawing parameters in highstrength cord production, Wire J. Int., pp. 79-85
- E. Arnoudt, March 1989, Materials response to wiredrawing, Wire J. Int., pp. 79-85
- G. Baker, R. Wright, April 1992, Drawing research with high speed single die block, Wire J. Int., pp. 71-80
- Z. Zimerman, R. Henry, September 1984, Drawing fine wire on wet wiredrawing machines, Wire J. Int. pp. 134-140
- N. Kunntani, M. Asakawa, 1984, Analysis of residual stress induced by bar and wire drawing, J. of JSTP, Vol. 38, pp. 43-49
- A. Nakagiri, K. Mathukawa, S. Watanabe, Y. Sasagawa, 1998, Influence of die-wire contact length ratio on chevron crack and optimum drawing condition in wire drawing, J. of JSTP, Vol. 39. pp. 90-97
- T. Kuboki, M. Akiyama, Y. Neishi, K. Kuroda, 2001, Effect of die geometry on residual stress level present after bar drawing, lronmaking and Steelmaking, Vol. 28, pp. 65-71 https://doi.org/10.1179/030192301677876
- T. Kuboki, H. Yoshikawa, Y. Meishi, K. Kuroda, M. Akiyama, 2001, Influence of back-tension on effect of skin pass in minimizing residual stress levels after cold rod drawing, Ironmaking and Steelmaking, Vol. 28, pp. 117-121 https://doi.org/10.1179/030192301678028
- M. Akiyama, T. Kuboki, 2002, Optimization of method for residual stress after cold bar drawing, Ironmaking and Steelmaking, Vol. 9, pp. 101-106
- Skolyszewski, J. Luksza, M. Packo, 1996, Some problems of multi-stage fine wire drawing of high-alloy steels and special alloys, J. of Mat. Process. Tech. Vol. 60, pp. 155-160 https://doi.org/10.1016/0924-0136(96)02321-7
- M. Akiyama, T. Kuboki, 2002, Reduction in residual stress after cold bar drawing, Advanced Technology of Plasticity, Vol. 1, pp. 361-366
-
SFTC, 1995,
$DEFORM^{TM}$ -2D