초록
풍화 및 절리가 발달한 암반에 근입된 말뚝의 허용지지력 결정에는 침하량이 매우 중요한 인자가 되며, 설계단계에서 말뚝두부의 침하량을 예측하기 위해서는 말뚝의 하중전이기구에 대한 이해가 필수적이다. 따라서 본 연구에서는 풍화된 암반에 근입된 현장타설말뚝의 하중전이기구에 대한 연구를 수행하였다. 이를 위해 직경 1m의 총 5본의 현장 타설말뚝을 풍화된 편마암 부지에 시공하구 재하시험 및 하중전이 계측을 수행하여 말뚝의 축방향 지지거동을 분석하였다. 암반상태를 정량적으로 파악하기 위하여 재하시험 부지의 암반에 대한 엄밀한 현장/실내시험을 수행하고, 이를 토대로 암반상태가 말뚝의 하중전이기구에 미치는 영향을 분석하였다. 하중전이 계측을 통해 얻은 주면하중전이 (f-w) 곡선은 풍화상태가 상대적으로 양호한(MW) 연암의 경우, 수 mm의 변위에서 항복에 도달하며, 이후 변위에 따른 지지하중의 증가율이 급격히 둔화되는 경향을 보였다. 반면 풍화암/풍화토에 근입된 말뚝의 f-w 곡선은 뚜렷한 항복점을 보이지 않으며, 상대적으로 큰(>15m) 변위까지 주면하중이 쌍곡선 형태로 증가하였다. 선단하중전이(q-w) 곡선은 암반상태에 관계없이 선단변위 (q-w)까지는 선형적인 거동을 보였다.
Since the allowable bearing capacities of piles in weathered/fractured rock are mainly governed by settlement, the load-displacement behavior of pile should be known accurately. To predict pile head settlement at the design stage, the exact understanding of the load-transfer mechanisms is essential. Therefore, in this research, the load-transfer mechanism of drilled shaft socketed into weathered rock was investigated. For the investigation, five cast-in-place concrete piles with diameters of 1,000 mm were socketed into weathered gneiss. The static axial load tests and the load-transfer measurements were performed to examine the axial resistant behavior of the piles. A comprehensive field/laboratory testing program on weathered rock at the Held test sites was also performed to describe the in situ rock mass conditions quantitatively. And then, the effect of rock mass condition on the load transfer mechanism was investigated. The f-w (side shear resistance-displacement) curve of the pile in moderately weathered rock reached to yielding point at a for millimeter displacements, and after yielding point, the rate of resistance increment dramatically decreased. However, the f-w curve in the highly/completely weathered rock did not show the obvious yielding point, and the resistance gradually increased showing the hyperbolic pattern until relatively high displacement (>15 mm). The q-w (end bearing resistance-displacement) curves showed linear response at least until the base displacement of approximately 10 mm, regardless of rock mass conditions.